Bticino D45 Manual de usuario

322011

A (mm) B (mm) C (mm)

125 325 44,5

A C

D45 System

Description

Digital colour entrance panel

with addresses list

D45 System entrance panel with colour camera and backlighted alphanumeric keyboard

equipped with pushbutton to direct calls to the porter switchboard. Possibility to send

an alarm message to the switchboard when opening over two minutes of the associated

lock or when trying to remove the device. Setup parameters via device keyboard.

Configuration by device menu and keyboard or through the dedicated software

(supplied with the product). Residents can be called in 3 different ways :

- searching the name of the resident in the addresses list by using up & down arrow keys

- entering the resident surname by using the alphanumerical keyboard (same way as

for the mobile phone)

- direct call by typing the resident corresponding numerical code (you must know the

resident code).

Flush mounting installation with dedicated box - supplied with the product.

Related items

322012 Targa module

346250 Door lock relay

Technical data

Power supply: 30 Vdc

Stand by absorption: ≤ 25 mA @ 30 V

Max operating absorption: ≤ 245 mA@30 V

Camera sensor: 1/3”

Lens: F3.6 mm

Camera diagonal view angle: 85°

Camera distance up to clear picture: 16.4 cm

Camera resolution: 540 TV Lines (horizontal)

Camera minimum lux level visibility: 0.01 lux (compensation lamp OFF)

0 lux (compensation lamp ON)

Operating temperature: (-25) – (+55) °C

Protection index: IP54

Protection against mechanical impact: IK07

Dimensional data Legend

1. Compensation Lamp

2. Send call to the selected resident key

3. Door lock release key

4. External light sensor

5. Microphone

6. Direct call to the management center pushbutton

7. Delete & Return key

8. Alphanumerical pushbuttons

9. Navigation / search for the resident keys

10.Backlighted LCD display

11.Loudspeaker

12.Adjustable colour camera

Front view

BT00853-a-EN 03/09/2014

322011

A (mm) B (mm) C (mm)

120 314 55

A C

Digital colour entrance panel

with addresses list

Rear view

Legend

1. NN RRRR: configurators housing

2. ISP: entrance panel software upgrade connector

3. SPK: loudspeaker volume adjust

4. MIC: microphone volume adjust

5. VIDEO-IN/GND/NC/+12V/LED : entrance panel camera and compensation Lamp

connector

6. RJ45 Targa module connection

7. RJ45 System BUS connection

8. 6 poles connector :

– +12V/GND power supply for access control module (Optional)

– UNLOCK signal output from access control module (Optional)

– DAS electronic lock status signal connector

– LOCK-/LOCK+ electrical door lock connection

9. SPK-OUT/GND/GND/SPK-OUT: entrance panel loudspeaker connections

10.(V-GAIN) video gain setting

11.Password RESET pushbutton

Flush mounting box - dimensional data

BT00853-a-EN 03/09/2014

N N R R R R

322011Digital colour entrance panel

with addresses list

Configuration & Settings

BT00853-a-EN 03/09/2014

Entrance panel must be configured for the following parameters:

NN : Entrance panel number

RRRR : NOT USED

Two different device configuration ways available:

WAY 1) Configuration settings by device keyboard

WAY 2) Configuration by using SF2 Software and PC connection

Configuration settings by device keyboard - WAY 1:

PASSWORD

Access to the configuration menù by press and hold the door lock key

for more than 10 seconds.

Enter the access code (DEFAULT 1 2 3 4)

PASSWORD

1 2 3 4

If the correct code has been entered, direct access to the configuration menù will be granted.

To exit from the configuration menù, or to return to the previous menù, select EXIT than press OK.

Welcome

CONFIGURATION

Language

Panel settings

Address book

CONFIGURATION

Phonic module settings

FW versions

EXIT

322011Digital colour entrance panel

with addresses list

BT00853-a-EN 03/09/2014

Configuration & Settings

Changing the PASSWORD - if the password has been forgotten , it is possible to change it in this way : press the RESET pushbutton on the rear side of the device for about 6 seconds.

Password will be recovered to default (1 2 3 4).

Password setup

To change the access password, press OK than enter new password“6789”

Confirm by pressing

Entrance panel settings :

Select the menu function and confirm by pressing

Device settings submenu, allows you to set up the following parameters :

- display brightness adjustment

- display contrast adjustment

Press EXIT to return to the previous menu.

PASSWORD SETUP

Password 1234

EXIT

PASSWORD SETUP

Password 6789

EXIT

CONFIGURATION

Language

Panel settings

Address book

PANEL SETTINGS

Device settings

Password

Home page

DEVICE SETTINGS

Brightness

Contrast

EXIT

Digital colour entrance panel

with addresses list

HOME PAGE

Template 1 line

Timeout 5 Sec

Text –––>

HOME PAGE TEXT

Line 1 –––>

Line 2 –––>

EXIT

Configuration & Settings

HOME PAGE - this menu function allows you to enter a customized welcome message or any other general message.

The message can fill a maximum of three text rows (15 characters max.) -Template.

Is possible to set the display time of the message on the screen (5, 10 or 15 seconds) -Timeout.

Select the line where to enter the text by using and confirm with

Press to select the text field. Enter the message text by using the alphanumerical keyboard (in the same way as you write an SMS on your mobile phone).

Than confirm with .

The message will continuously appear on the home page screen as for the time set in theTimeout menu.

Restore DEFAULT SETTINGS

Select the line where to enter the text by using and confirm with

The settings of the entrance panel will be restored to the factory default settings.

NOTE : this operation does not delete the data contained in the resident address book.

HOME PAGE TEXT

Line 1

Welcome

EXIT

PANEL SETTINGS

Home page

Restore default

HOME PAGE TEXT

Line 1

MY TEXT

EXIT

HOME PAGE TEXT

Confirm

EXIT

322011

BT00853-a-EN 03/09/2014

Configuration & Settings

ADDRESS BOOK - This menu is used to to enter various residents data (including call codes and door lock release codes) as well as performing any other function described below :

List of names - this setting estabilish how the name of the residents will be displayed on the screen. ON = list enabled

To search the desired resident name, use the indicated keys or enter the surname by using the alphanumerical keypad.

Calling mode by type of code - Enter the type of code to be used to call the resident

Apart address = SCS address of the handset

Call mode = Numerical code assigned to the resident

Calling mode - recall - when this function is enabled, the entrance panel will automatically repeat the call every 25 seconds up to 2 times.

CONFIGURATION

Panel settings

Address book

Phonic module settings

CALLING MODE

List of names ON

Type of code –––>

Phonic module settings

CALLING MODE

List of names

Type of code –––>

Recall OFF

CONFIGURATION

List of names ON

Type of code –––>

Recall OFF

CODE TYPE

Apart address *

Call code

EXIT

Select the name with

and press OK

322011Digital colour entrance panel

with addresses list

BT00853-a-EN 03/09/2014

Configuration & Settings

Contact setting - call codes can be set with a lenght from 1 to 8 digits. Door lock codes can be set with a lenght from 4 to 9 digits.

ADDRESS BOOK

Contact setting

New contact

Modify contact

ADDRESS BOOK

Contact setting

New contact

Modify contact

ADDRESS BOOK

Contact setting

New contact

Modify contact

ADDRESS BOOK

Call code digits 4

Lock code digits 5

EXIT

Aaaaaa

Call code digits : default 4 digits

Door lock release code digits : default 9 digits

Modify contact - this function gives you the possibility to change the selected contact.

Entering a new contact- this function gives you the possibility to enter new residents in the address book.

For each resident is possible to set the following parameters :

ID Number : identification progressive number automatically assigned by the device to each resident. This function gives you the possibility

to change this ID with a 4 digits number asigned by the installer.

Surname : surname of the resident.

Name : name of the resident.

Public : set on (YES), the name and the surname of the resident will appear on the display during the call selection.

set on (NO), the name and the surname are hidden. Resident call is possible by entering the call code.

Apart address : SCS address of the corresponding handset.

Call code : numerical call code assigned to the resident.

Lock code : door lock release numerical code.

Select the contact to change and confirm with

Digital colour entrance panel

with addresses list

322011

BT00853-a-EN 03/09/2014

Configuration & Settings

Delete contact - this function gives you the possibility to delete the selected contact.

Delete the adresses book - this function gives you the possibility to delete all the contacts present in the addresses book.

ADDRESS BOOK

New contact

Modify contact

Delete contact

DEL THIS CONTACT

Confirm

Will be deleted

EXIT

DEL ADDRESS BOOK

Confirm

Will be deleted

EXIT

Aaaaa

Bbbbb

Ccccc

Ddddd

Select the contact to delete with than press

Confirm the elimination by pressing

322011Digital colour entrance panel

with addresses list

BT00853-a-EN 03/09/2014

Configuration & Settings

Speaker module settings - this configuration can be performed only with the module NOT phisically configured (NO configurators inserted).

SCS SETTINGS

P – Panel number 00

T – Lock time 1

Switchboard 00

FW versions

Phonic mod. : 00.00.00

EXIT

P-Panel number: SCS address of the entrance panel

T-Lock time: door lock time delay (NOT USED)

Switchboard: SCS address of the switchboard (if present)

Signal type of lock: NO = Normally open

NC = Normally closed

Dismantle alarm: ON = alarm enabled

OFF = alarm disabled

Digital colour entrance panel

with addresses list

322011

Firmware version - this menu indicate you the firmware version installed on the device.

Direct call to the switchboard - by pressing the dedicated pushbutton.

Door lock release by code- you can directly activate the door lock releasing by typing the associated numerical code. Press the key than enter the numerical code.

To call the switchboard

press the button

Input unlock password

Switchboard

DOOR OPEN

BT00853-a-EN 03/09/2014

S- S+ CNC NO

L+ L

323020

configuration

tool

1 2

OFF

322011Digital colour entrance panel

with addresses list

322011

346250

Distance 1 2

0 –300 m OFF OFF

300 – 700 m ON OFF

700 – 1000 m ON ON

This is the enhanced way to download the device configuration to entrance panel previ-

ously created by using SF2 configuration software and a personal computer. To transfer

use the configuration hardware tool 323020 serial interface

Configuration by using SF2 Software and PC connection - WAY 2 :

WARNING : in order for the communication to take place, the EP must be powered and

not physically configured

The entrance panel has a double DIP SWITCH for the video compensation setting.

By setting different DIP V-GAIN, it is possible to adapt the video signal to different

transmission distances - refer as follows :

DIP SWITCH SETTINGS FOR B/W. AND COLOUR SYSTEM

Configuration

Wiring diagrams - Door lock relay connection

N.B.: Cable size 1 mm2and max distance 2 meters 8A cosϕ= 1 24 Vac/24 Vdc

4A cosϕ= 0.7 24 Vac

3A cosϕ= 0.4 24 Vac

Video gain settings

BT00853-a-EN 03/09/2014

Otros manuales para D45

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Sistema de intercomunicación de Bticino

Bticino

Bticino 363511 Manual de usuario

Bticino

Bticino 323004 Manual de usuario

Bticino

Bticino 361511 Manual de usuario

Bticino

Bticino Terraneo 342702 Manual de usuario

Bticino

Bticino D45 Manual de usuario

Bticino

Bticino CLASSE 100X Manual de usuario

Bticino

Bticino Classe100 X16E Manual de funcionamiento

Bticino

Bticino Video Kit Manual de usuario

Bticino

Bticino Terraneo 342620 Manual de usuario

Bticino

Bticino 315211 Manual de funcionamiento

Bticino

Bticino 391 875 Manual de usuario

Bticino

Bticino 344272 Manual de usuario

Bticino

Bticino 321020 Manual de usuario

Bticino

Bticino Classe 300 EOS KIT Manual de usuario

Bticino

Bticino Small Entrance Panel Compact Manual de funcionamiento

Bticino

Bticino 374005 Manual de usuario

Bticino

Bticino 366611 Manual de usuario

Bticino

Bticino 346830 Manual de usuario

Bticino

Bticino Classe 300 Manual de usuario

Bticino

Bticino 391627 Manual de usuario

Bticino

Bticino Terraneo 344702 Manual de usuario

Bticino

Bticino 332851 Manual de funcionamiento

Bticino

Bticino IP DES 375000 Manual de funcionamiento

Bticino

Bticino Classe 300X Manual de usuario

Manuales populares de Sistema de intercomunicación de otras marcas

MSI

MSI MSI-140 Manual de usuario

golmar

golmar Stadio Plus Manual de usuario

CyberData

CyberData 011211 series Manual

Vidos

Vidos duo M1021 Manual de usuario

Vimar

Vimar ELVOX 7539/E Manual de usuario

SSS Siedle

SSS Siedle BTSV 850-03 Manual de usuario

Dahua

Dahua VTO Series Manual de usuario

Elvox

Elvox 5651 Manual de usuario

Videx

Videx VIDEOKIT Series Manual de usuario

Rocom

Rocom Doortello Business FW T2.05W2.04 Manual de usuario

Viking

Viking E-35-EWP Manual de usuario

Safeguard Supply

Safeguard Supply LRA-EX1000 Manual de usuario

SSS Siedle

SSS Siedle BFCV 850 Series Manual de usuario

GRD

GRD MAX V2 Manual de usuario

Alecto

Alecto ADI-250 Manual de usuario

Aiphone

Aiphone IE-8MD Manual de usuario

Perel

Perel EDB4 Manual de usuario

LG L5142 Manual de usuario