Brodit 727002 Manual de usuario

Product 727002

727002 Active holder for fixed installation Fits for devices with original skin. With tilt swivel.

This holder is equipped with a cable for fixed installation for charging of your device. It provides a discreet and

neat installation without any visible cables. 12/24 Volt. The product is E-approved. Connect the power cable with

a 2 A fuse. 2 A charger. Professional installation recommended. The holder is mounted onto a tilt swivel so you

can adjust the angle and switch between portrait and landscape mode.

Tablets should not be installed onto a car’s dashboard if they block the view or block key controls. The ProClip is

designed for installation of smaller devices (phones), not for large devices (tablets). If you want to place a tablet

onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine

if such an installation is possible in the specific case. Consideration should be given to the position and how firmly

the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations

for such installations.

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit

recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

This product supports Qualcomm QC 2.0 quick charge (provided the device supports Qualcomm QC 2.0 quick

charge).

EAN: 7320287270020

Item no 727002 fits:

Samsung Galaxy Tab Active 2. SM-T390/SM-T395 (For all countries)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Read all of the instructions and look at the pictures before attaching the holder. The charger unit is fused

internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A

fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the

vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit

is securely mounted behind the dashboard in a well ventilated area that does not get hot! If connecting a

GPS/Data device to the holder, ensure the charger unit is located in a position within easy reach of any GPS or

charging adapters. Route the power cable from the charger unit to the power supply source in the vehicle and

connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle

chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition

switch of the vehicle. How to mount the holder: 1. Loosen the screw in the center of the holder. 2. Place the

attaching plate onto desired position and screw it into place with the enclosed screws. Place the holder over the

attaching plate. Tighten the screw until the holder is firmly in place, but still can be adjusted. 3. To place device in

holder: Place the lower part into the holder where the opening between the sidewalls is widest. Flip the upper part

forward so the device goes flat into the holder. Slide the device straight downward into the holder. To remove

device from holder: Press the device straight upward so the lower part reaches the widest part of the opening

between the sidewalls. Flip the upper part of the device away from the holder and lift the device out from the

holder. 4. The holder is in place.

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Brodit

Brodit

Brodit Monitor Mount Manual de usuario

Brodit

Brodit 727196 Manual de usuario

Brodit

Brodit 541861 Manual de usuario

Brodit

Brodit ProClip 855038 Manual de usuario

Brodit

Brodit ProClip 853044 Manual de usuario

Brodit

Brodit ProClip 835009 Manual de usuario

Brodit

Brodit 810698 Manual de usuario

Brodit

Brodit ProClip 654877 Manual de usuario

Brodit

Brodit 852598 ProClip Manual de usuario

Brodit

Brodit 711027 Manual de usuario

Brodit

Brodit Passive Holder Manual de usuario

Brodit

Brodit 810850 Manual de usuario

Brodit

Brodit Heavy Duty ProClip Manual de usuario

Brodit

Brodit ProClip 854686 Manual de usuario

Brodit

Brodit 272011 Manual de usuario

Brodit

Brodit 711029 Manual de usuario

Brodit

Brodit ProClip Manual de usuario

Brodit

Brodit 711148 Manual de usuario

Brodit

Brodit ProClip 855004 Manual de usuario

Brodit

Brodit ProClip 804438 Manual de usuario

Brodit

Brodit Getac T800 Manual de usuario

Brodit

Brodit PDA Holder Manual de usuario

Brodit

Brodit ProClip 855170 Manual de usuario

Brodit

Brodit 713184 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario