Brodit 279018 Manual de usuario

Product 279018

279018 Holder with Pass-Through Connector Active holder for fixed installation. With tilt swivel. 12/24 Volt.

Active holder with pass-through connector and for fixed installation. All cables that can be used with the GPS

device can also be used with the holder, for example a TMC cable. This means that you can have both charging

and TMC connected to the GPS in the same time! When you have attached the cable to the holder it is firmly in

place and you do not have connect it manually to the device each time you put the GPS in the holder.

The holder has a straight cable with open end for fixed installation. The cable is to be connected inside the

dashboard, this gives a discreet, neat installation without cables hanging over the interior.

You can easily take the device with you when leaving the vehicle. 12/24 Volt. The product is E-

approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The

holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Attach onto a ProClip

Mounting Platform.

Charging specifications:

Input voltage: DC/10-30V

Charging voltage: DC/4.75-5.3V

Output current(Typ): 2.0A

Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection

LED charging indicator: Power input indicator(Green) , Ovp/Ocp/Output Short(Red)

Operating temperature: 0°C ~ +40°C

Storage temperature: -20°C ~ +80°C

RoHS compliant: ROHS

EAN: 7320282790189

Item no 279018 fits:

TomTom XL 30-series (For all countries)

TomTom XL IQ Routes (For all countries)

TomTom XL Live IQ Route 2nd edition (For all countries)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The

charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be

installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the

cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape

provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does

not get hot!

Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1.

Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the

Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel

attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place

with the enclosed screws. 3. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto

the attaching plate. All cables that fit the device can be attached to the holder. 4. The holder is in place.

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Brodit

Brodit

Brodit 713049 Manual de usuario

Brodit

Brodit ProClip 804735 Manual de usuario

Brodit

Brodit 511627 Manual de usuario

Brodit

Brodit ProClip 853804 Manual de usuario

Brodit

Brodit ProClip 855113 Manual de usuario

Brodit

Brodit ProClip 852057 Manual de usuario

Brodit

Brodit ProClip 804080 Manual de usuario

Brodit

Brodit ProClip 852947 Manual de usuario

Brodit

Brodit 747286 Manual de usuario

Brodit

Brodit 854805 ProClip Manual de usuario

Brodit

Brodit ProClip 804934 Manual de usuario

Brodit

Brodit ProClip 852426 Manual de usuario

Brodit

Brodit 712079 Manual de usuario

Brodit

Brodit ProClip 853353 Manual de usuario

Brodit

Brodit 736102 Manual de usuario

Brodit

Brodit ProClip 854740 Manual de usuario

Brodit

Brodit 546682 Manual de usuario

Brodit

Brodit ProClip 835009 Manual de usuario

Brodit

Brodit ProClip 855176 Manual de usuario

Brodit

Brodit ProClip 654877 Manual de usuario

Brodit

Brodit ProClip 853196 Manual de usuario

Brodit

Brodit 727203 Manual de usuario

Brodit

Brodit ProClip 853435 Manual de usuario

Brodit

Brodit ProClip 853360 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario