PAMASCO SERVICE CENTeR
14315 S. HALSTED STREET
RIVERDAlE,ll 60827
9. CONSISTENTLY HIGH OR LOW BEVERAGE LEVEL:
A. Inspect, clean or replace flow control washer and flow
control screen.
B. Test for correct water pressure. Water pressure should be
between 30 and 80 p.s.i.
c. Flow washer should be .06 GPM.
10•. INCONSISTENT BEVERAGE LEVEL:
A. Inspect and clean spray head and silicone tubing.
B. Test water supply for inconsistent. water pressure.
C. Test timer. Replace if necessary.
D. Inspect, clean or replace flow control washer and flow
control screen.
E. Test solenoid valve for leakage. Replace if necessary.
F. Inspect tank for leakage. Replace if necessary.
G. Test optional in-line water filter, check valve or shut off
valve for blockage. Replace if necessary.
11. HI-LIMIT THERMOSTAT KEEPS ACTIVATING:
A. Test hi-limit thermostat. Replace if necessary.
B. Check brewing temperature. Adjust if necessary. (see item
#7A)
C. Test thermostat. Replace if necessary.
D~ Is hi-limit thermostat too tight against tank? Hi-limit
should be snug only.
E. Inspect hi-limit thermostat for correct, loose or damaged
wires or terminals.WARNING
UNDER NO CIRCUMSTANCE SHOULD THE HI-LIMIT THERMOSTAT BE BY-PASSED. IN
THE EVENT OF FAILURE THE HI-LIMIT THERMOSTAT SHOULD BE REPLACED. USE
ONLY ORIGINAL REPLACEMENT PARTS.
12. DRIPPING FROM SPRAY HEAD WHEN KNOB IS OFF:
A. Inspect and clean spray head, silicone tubing and fittings.
B. Test solenoid valve for leakage.
C. Test water supply for correct water pressure. Water pressure
should be between 30 &85 PSI.'
13. BREWER WILL NOT SHUT OFF OR BREWER STARTS BY ITSELF:
A. Test power-fill switch. Replace if necessary.
B. Test timer. Replace if necessary.
C. Test solenoid valve for leakage.
D. Inspect for correct, loose or damaged wires or terminals.
E. Test water supply for correct water pressure. Water pressure
should be between 30 &85 PSI.
14. WATER LEAKING FROM BOTTOM OF UNIT:
A. Inspect and clean spray head and silicone tubing.
B. Inspect tank, silicone tubing and fittings for leakage.
