Page 3
2. Set the desired down position.
STOP+▼ 2x
OK
Go with the OPERATING- Press and hold the STOP and DOWN button until The desired downposition is set.
buttons to the desired the motor moves up and down 2x.
downposition.
_______________________________________________________________________________
Step 4 Setting the desired third limit position (I desired)
1x P2 1x
1x STOP 1x
1x STOP 2x
OK
Set the desired Press 1x P2. Press 1x STOP button. Press 1x STOP button.
Third limit The product moves 1x The product moves 1x The product moves 2x up
position. up and down. up and down. and down for confirmation.
Press and hold STOP for 3 seconds to move to the set limit position.
The motor is now ready or use!
______________________________________________________________________________
Additional settings
____________________________________________________________________________
Option A Adjusting the top position I adjustment is not possible, go to Option B, then to Step 3.
STOP +▲ until
STOP +▲ until 2x
Go to the already Press at the same time Go to the new Press at the same time
set top position. STOP and UP until top position. STOP and UP button, until
the motor moves. the motor 2x moves.
___________________________________________________________________________
Adjusting the down position I adjustment is not possible, go to Option B, then to Step 3.
STOP +▼ until
STOP +▼ until 2x
Go to the already Press at the same time Go to the new Press at the same time
set bottom position, STOP and DOWN until bottom position. STOP and DOWN button, until
the motor moves. the motor 2x moves.
______________________________________________________________________________
Option B Deleting the end limits
1x P2 1x
1x ▼ 1x
1x P2 2x
OK
Press 1x P2. The product Press the DOWN button. Press P2. The product The end positions
moves up down. The product moves 1x moves 2x up and down. are now deleted
up and down. from the memory.
