Changing Batteries
P2 P2
M
P2 P2
M
P2 P2
M
BREL
poweredby
Model:DD2702H
Fifteen-ChannelEmitter
433MHz
CR24503.0V
0.7276243084
Press P2. The product
moves 1x up and down Press 1x down. Press 1x down. The motor speed
has been reduced.
1x P2
Speed Control
P2
1x
1x 1x
The motor speed
has been increased
Press 1x up. Press 1x up.
If the motor does NOT react after this action, it is already at the highest or lowest speed.
Additional settings P1 button
The product moves up, stops or goes down when pressed P1
Press 1x P1 on the motor.
1x P1
Can be used without a transmitter as an operating button.
Switching off the receiver
Press and hold P1 until the product moves up and down for
the 2nd time.
The Receiver
switched off.
To reactivate the receiver, briefly press P1 once.
Changing the direction of rotation
Press and hold P1 until the product moves up and down for
the 3rd time.
The direction of
rotation has changed.
Resetting to factory settings
Press and hold P1 until the product moves up and down
for the 4th time.
Resets to factory settings.
Option D
There are 3 different speeds; Namely : 21rpm - 24rpm - 28rpm.
To apply new settings: go to step 1
CR2450
LITHIUM BATTERY
CR2450
LITHIUM BATTERY
3V
3V
Page 8
1x
If the speed has been changed the slow stop is activated. To deactive the slow stop you have to reset the motor.
Brel Netherlands B.V. is registered according to the
transposition of Directive 2012/19EU (the WEEE Directive)
and to the transposition of Directive 2006/66EC (the Battery
Directive) at the Irish registry The Producer Register with the
registration number 3408WB.
Brel Netherlands B.V. is registered according to the
transposition of Directive 2012/19EU (the WEEE Directive)
into the Act on Waste n.185/2001 in Czech republic with the
participation number 09281/20ECZ.
