BreezeCOM SU-A-2.4 Series Manual de usuario
BreezeACCESS 2.4
Subscriber Units
SU-A-2.4 Series
SU-E-2.4 Series
Installation
Manual
Preliminary
Revision 3
November, 2000
Cat. No. 213123
Front Matter
SU-A/E Subscriber Units Installation Manual ii BreezeACCESS 2.4 Series
© 2000 by BreezeCOM Ltd. All rights reserved.
No part of this publication may be reproduced in any material form without the written permission of
the copyright owner.
Trade Names
BreezeACCESS, BreezeNET, BreezeLINK, BreezeVIEW, BreezeMANAGE and WIX are trade
names of BreezeCOM Ltd. Other brand and product names are registered trademarks or trademarks of
their respective companies.
Statement of Conditions
The information contained in this manual is subject to change without notice. BreezeCOM shall not be
liable for errors contained herein or for incidental or consequential damages in connection with the
furnishing, performance, or use of this manual or equipment supplied with it.
Warranty
In the following warranty text, “the Company” shall mean:
• BreezeCOM Ltd., for products located outside the USA.
• BreezeCOM Inc., for products located in the USA.
This BreezeACCESS product is warranted against defects in material and workmanship for a period of
one year from date of purchase. During this warranty period the Company will, at its option, either
repair or replace products that prove to be defective.
For warranty service or repair, the product must be returned to a service facility designated by the
Company. Authorization to return products must be obtained prior to shipment. The buyer shall pay all
shipping charges to the Company and the Company shall pay shipping charges to return the product to
the buyer.
The Company warrants that the firmware designed by it for use with the unit will execute its
programming instructions when properly installed on the unit. The Company does not warrant that the
operation of the unit or firmware will be uninterrupted or error-free.
Limitations of Warranty
The foregoing warranty shall not apply to defects resulting from improper or inadequate maintenance
by the buyer, buyer supplied interfacing, unauthorized modification or misuse, operation outside of the
environmental specifications for the product, or improper site preparation or maintenance. No other
warranty is expressed or implied. The Company specifically disclaims the implied warranties of
merchantability and fitness for any particular purpose.
BreezeCOM shall not be liable to any person for any special or indirect damages, including, but not
Front Matter
BreezeACCESS 2.4 Series iii SU-A/E Subscriber Units Installation Manual
limited to, loss of profits or revenues, loss of use or damage to any associated equipment, cost of
capital, cost of substitute products, facilities or services, downtime costs or claims resulting from any
cause whatsoever arising from or in any way connected with the manufacture, sale, handling, service,
repair, maintenance or use of the products. In no event shall the company’s liability exceed the
purchase price denoted on the invoice.
Electronic Emission Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for digital equipment,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a residential environment
notwithstanding use in commercial, business and industrial environments. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Information to User
Any changes or modifications of equipment not expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
Safety Considerations
For the following safety considerations, “Instrument” means the BreezeACCESS Subscriber Unit
components and its cables. To avoid shock, do not perform any servicing unless you are qualified.
RF Warning
To comply with FCC RF exposure requirements in section 1.1307, a minimum separation distance of
2m (79 inches) is required between the antenna and all persons.
Line Voltage
Before connecting this instrument to the power line, make sure that the voltage of the power source
matches the requirements of the instrument.
Front Matter
SU-A/E Subscriber Units Installation Manual iv BreezeACCESS 2.4 Series
Radio
The instrument transmits radio energy during normal operation. To avoid possible harmful exposure to
this energy, do not stand or work for extended periods of time in front of its antenna. The long-term
characteristics or the possible physiological effects of Radio Frequency Electromagnetic fields have
not been yet fully investigated.
Antenna Installation and Grounding
Be sure that the Outdoor unit, the antenna and the supporting structure are properly installed to
eliminate any physical hazard to either people or property. Verify that the antenna mast is grounded so
as to provide protection against voltage surges and static charges. Make sure that the installation of the
Outdoor unit, antenna and cables is performed in accordance with all relevant national and local
building and safety codes.
BreezeACCESS 2.4 Series v SU-A/E Subscriber Units Installation Manual
Table of Contents
1. INTRODUCTION .....................................................................................................................1
2. BASIC INSTALLATION..........................................................................................................4
2.1 Packing List...........................................................................................................................4
2.2 Other Items Required for Installation....................................................................................4
2.3 General Installation Scheme..................................................................................................5
2.4 Guidelines for Selection of Equipment Locations................................................................7
2.5 Installing the Outdoor Unit ...................................................................................................9
2.5.1 Pole Mounting the Outdoor Unit ...................................................................................9
2.5.2 Connecting the Antenna Cable (SU-RE) .....................................................................12
2.5.3 Connecting the Ground and IF Cables.........................................................................12
2.6 Installing the SU-NI Indoor Unit.........................................................................................13
3. CONFIGURING SYSTEM PARAMETERS........................................................................15
3.1 Getting Started with the Local Terminal.............................................................................15
3.2 Configuring Basic Parameters.............................................................................................17
3.3 Reset Unit............................................................................................................................18
4. ALIGNING THE ANTENNA.................................................................................................19
5. VERIFYING CORRECT OPERATION OF THE OUTDOOR UNIT..............................20
6. RSSI MEASUREMENT AND MAXIMUM DATA RATE CONFIGURATION .............21
6.1 Performing the RSSI Measurement.....................................................................................21
6.2 Configuring The Maximum Data Rate................................................................................22
Table of Contents
SU-A/E Subscriber Units Installation Manual vi BreezeACCESS 2.4 Series
7. VERIFYING CORRECT OPERATION ..............................................................................23
7.1 General ................................................................................................................................23
7.2 Verifying Data Connectivity...............................................................................................23
7.3 Verifying Telephone Connectivity (SU-A/E-DV series only)............................................24
8. SPECIFICATIONS .................................................................................................................25
8.1 Radio ...................................................................................................................................25
8.2 Data Communication...........................................................................................................26
8.3 Voice Communication (SU-A/E-DV series).......................................................................26
8.4 Outdoor Unit to Indoor Unit Communication.....................................................................26
8.5 Configuration and Management..........................................................................................26
8.6 Interfaces.............................................................................................................................27
8.7 Electrical, Mechanical and Environmental .........................................................................27
8.8 Standards Compliance, General..........................................................................................27
APPENDIX A. USING TELNET...............................................................................................28
APPENDIX B. BASIC PARAMETERS....................................................................................29
Table of Contents
BreezeACCESS 2.4 Series vii SU-A/E Subscriber Units Installation Manual
Table of Figures
Figure 2-1: SU-A General Installation Scheme.........................................................................5
Figure 2-2. SU-E General Installation Scheme .........................................................................6
Figure 2-3. Holes/Grooves/Screw holes....................................................................................9
Figure 2-4. SU-RA 2” Pole Mounting Installation Using the Special Brackets......................10
Figure 2-5. SU-RE 3” Pole Mounting Installation Using the Special Brackets......................11
Figure 2-6. SU-RA/RE Outdoor Unit Bottom Panel...............................................................12
Figure 2-7. SU-NI Rear Panel (unit with voice support).........................................................13
Figure 2-8. SU-NI Front Panel ................................................................................................14
Table of Tables
Table 1-1. BreezeACCESS SU-A-xD-2.4 Data Subscriber Units ............................................2
Table 1-2. BreezeACCESS SU-E-xD-2.4 Data Subscriber Units.............................................2
Table 1-3. BreezeACCESS SU-A-xD1V-2.4 Data Subscriber Units........................................3
Table 1-4. BreezeACCESS SU-E-xD1V-2.4 Data Subscriber Units........................................3
Table 3-1. Main Menu.............................................................................................................16
Table 5-1: SU-RA/RE Outdoor Unit LEDs.............................................................................20
Table 6-1: RSSI vs. Maximum Data Rate................................................................................22
Table 7-1: SU-NI LEDs............................................................................................................23
Introduction
BreezeACCESS 2.4 Series 1 SU-A/E Subscriber Units Installation Manual
1. INTRODUCTION
This manual describes installation guidelines for BreezeACCESS 2.4 SU-A and
SU-E series of Subscriber Units.
The BreezeACCESS IP Broadband Wireless Local Loop (WLL) system allows
access service providers to provide high-speed IP connectivity services to their
subscribers. To effectively support IP-based services BreezeACCESS systems
employ wireless packet data switching technology.
The BreezeACCESS 2.4 line of products uses Frequency Hopping Spread
Spectrum radios that operate in Time Division Duplex (TDD) mode in the
2.400GHz – 2.500GHz frequency range.
SU-A and SU-E series Subscriber Units are comprised of an indoor unit (SU-NI)
and an outdoor unit. In the SU-A product line, the outdoor unit (SU-RA)
contains the radio module and an integral flat antenna. In the SU-E series, the
outdoor unit (SU-RE) contains the radio module and an interface to an external
antenna (not included). The indoor unit provides the interface to the user’s
equipment and is powered from the mains via its SU-PS power supply unit. The
SU-NI also contains an IF (Intermediate Frequency) module and is connected to
the outdoor unit via a 50-ohm coaxial IF cable. The IF cable serves for
transmission of the 440MHz IF signal between the indoor and the outdoor units.
It also serves for transferring power (12VDC), management and control signals
from the indoor unit to the outdoor unit.
Introduction
SU-A/E Subscriber Units Installation Manual 2 BreezeACCESS 2.4 Series
Table 1-1 lists the products included in the BreezeACCESS SU-A-xD-2.4 Data
Subscriber Units.
Table 1-2 lists the products included in the BreezeACCESS SU-E-xD-2.4 Data
Subscriber Units.
Table 1-3 lists the products included in the BreezeACCESS SU-A-xD1V-2.4
Data and Voice Subscriber Units.
Table 1-4 lists the products included in the BreezeACCESS SU-E-xD1V-2.4
Data and Voice Subscriber Units.
Table 1-1. BreezeACCESS SU-A-xD-2.4 Data Subscriber Units
Product CPE support General Description
SU-A-1D-HP-2.4
SU-A-1D-LP-2.4 Supports a single
Ethernet device. Indoor unit, power supply and an
outdoor radio unit with an
integral flat antenna.
SU-A-8D-HP-2.4
SU-A-8D-LP-2.4 Supports up to eight
Ethernet
workstations/PCs
Output power at antenna port:
26 dBm (SU-A-xD-HP-2.4) or
2 dBm (SU-A-xD-LP-2.4)
SU-A-BD-HP-2.4
SU-A-BD-LP-2.4 Supports a LAN
(bridge functionality)
Table 1-2. BreezeACCESS SU-E-xD-2.4 Data Subscriber Units
Product CPE support General Description
SU-E-1D-HP-2.4
SU-E-1D-LP-2.4 Supports a single
Ethernet device Indoor unit, power supply and an
outdoor radio unit with an RF
connector to an external antenna.
SU-E-8D-HP-2.4
SU-E-8D-LP-2.4 Supports up to eight
Ethernet
workstations/PCs
Output power at antenna port:
26 dBm (SU-E-xD-HP-2.4) or
2 dBm (SU-E-xD-LP-2.4)
SU-E-BD-HP-2.4
SU-E-BD-LP-2.4 Supports a LAN
(bridge functionality)
Este manual sirve para los siguientes modelos
26
Tabla de contenidos
Otros manuales de Punto de acceso inalámbrico de BreezeCOM
