9
Fan heater oscillation mode
• Press the button (9) « » on the control panel (3) or the
button (16) « » on the remote control (18) to switch
the body oscillation mode on, the symbol « » will
appear in the operation mode icons row (11). To switch
the oscillation mode o, press the button (9) « » or
(16) « » again, the symbol
« » on the control panel (3) will go out.
TIMER SETTING
• Press the timer on/o button (10) « » on the control
panel (3) or the button (17) « » on the remote control
(18) and set the requited timer operation time, the
symbol « » will appear in the operation mode icons
row (11).
• Time setting range is up to 8 hours.
• The timer operation time is indicated with the digital
symbols (12) on the control panel (3).
• To switch the timer o, consequently press the button
(10) « » or the button (17) « » until the digital
symbols (12) show the room temperature.
Room heating temperature setting
• Press the buttons (8) «–/+» on the control panel (3) or
the buttons (15) «–/+» on the remote control (18) to set
the required room heating temperature.
• The temperature setting range is from 10 to 49
degrees, the temperature is displayed on the control
panel (3) with digital symbols (12).
• Switching the fan heater o
• Switch the fan heater o by pressing the on/o button
(6) « » on the control panel (3) or the button
(13) « » on the remote control (18).
• Note: — after pressing the buttons (6,13), the
heating element will switch o, but the fan will
continue to operate for 30 seconds to cool the
heating element.
• After the fan stops, switch the power o by setting
the switch (5) to the position «0».
AUTOMATIC EMERGENCY SWITCH-OFF
FUNCTION IF THE OUTGOING AIR IS TOO
HOT
• If the outgoing air temperature exceeds the
acceptable value, the automatic thermal switch will
switch on, and the fan heater will be switched o.
• Set the power switch (5) to the position «0» and
unplug the unit, let the fan heater cool down for
approximately 15-25 minutes (depending on the air
temperature in the room) and only after that you can
switch the unit on again.
• Make sure that the front (2) and rear grids are not
blocked with foreign objects.
• Insert the power plug into the mains socket and
switch the fan heater on.
• If the fan heater does not switch on, it may be caused
by another malfunction. In this case apply to a
service center for repairing of the fan heater.
