Do not care, set up in the following conditions. Otherwise it will cause fire, electric
shock or do damage to the machine.
The place of direct sunlight
when we use it, the environment temperature must higher than the place of custody
and set the temperature condition.
Relative humidity higher than the place of the custody and set humidity condition.
The place of large temperature difference and condensation.
Corrosive gas and combustible gas.
The place where has more dust, dirt, salt and metal powder
The place where is easy to splash water, oil and medicine, etc
The place where the vibration or shock may spread to the main sites.
vibration or shock may spread to the main sites.
Do not hold the cable, the motor shaft or see the early handling. Otherwise it will
cause injury or malfunction.
Please do not put too much products together,(please according to the instructions.
)Otherwise it will cause injury or malfunction.
Need to deal with the packing of wooden materials (including wood, plywood,
shelves), insecticidal processing, please make sure the method of fumigation outside.
Example: heat treatment (material core temperature in 56 ℃ above, the processing
time in more than 30 minutes) in addition, the processing, please before packaging
for packing materials for processing, rather than after packing to deal with the whole.
Use after fumigation treatment of wood packaging electrical products (monomer or
installed on the mechanical product), the packaging materials produced by the gas
and steam may cause fatal damage of electronic products. Especially halogen
disinfectant (fluorine, chlorine, bromine, iodine, etc.) will cause corrosion to the
capacitor inside.
Installation Note
Do not be splashed with water or place in an environment prone to corrosion and
flammable gases and combustible materials in the vicinity of using this product.
Doing so may cause an electric shock or fire.
Do not sit on the product or put heavy objects on it. Otherwise it will cause injury or
malfunction.
Do not block the air inlet and exhaust ports. Do not make the foreign body into the
inside of the product. Otherwise, it will due to aging of the internal components and
cause a malfunction or fire.
Must follow the requirements of the installation directions. Otherwise it will lead to
failure.
When installing ,without the servo unit and control cabinet surface or the other with
a predetermined gap between machinery. It will cause fire or malfunction.
Please do not apply too. Otherwise it will cause failure.
wiring precautions
Please correct and reliable wiring. Otherwise it will cause the motor control,
personal injury, or malfunction.
Please don't connect the servo unit in the servo motor and terminals U, V, W with the
commercial power supply source.
Otherwise it will cause injury or fire.
Please firmly connected the power supply terminal with the motor terminals.
Otherwise it will cause a fire.
