Brady BP-1244 Manual de usuario

BP-1244/BP-1344

Operator’s Manual

DO NOT PRINT

Firmware (Software) Agreement

The enclosed Firmware (Software) resident in the Printer is owned by Licensor or

its suppliers and is licensed for used only on a single printer in the user’s Trade

or Business. The User agrees not to, and not to authorize or permit any

other person or party to, duplicate or copy the Firmware or the information

contained in the non-volatile or programmable memory. The firmware

(Software) is protected by applicable copyright laws and Licensor retains all rights

not expressly granted. In no event will Licensor or its suppliers be liable for any

damages or loss, including direct, incidental, economic, special, or consequential

damages, arising out of the use or inability to use the Firmware (Software).

Information in this document is subject to change without notice and does not

represent a commitment on the part of Brady Worldwide, Inc. No part of this

manual may be reproduced or transmitted in any form or by any means, for any

purpose other than the purchaser's personal use, without the expressed written

permission of Brady Worldwide, Inc.

Part Number: 88-2256-21

Revision: B

Agency Compliance and Approvals:

C US

Listed

UL1950 Information Technology Equipment

C22.2 No. 950-M93

EN60950

For 230 Volt Operation (Europe): Use a cord set, marked "HAR," consisting

of a min H05VV-F cord which has a minimum 0.75 square mm diameter

conductors, provided with an IEC 320 receptacle and a male plug for the

country of installation rated 6A, 250V

Für 230 Volt (Europa): Benützen Sie ein Kabel, das mit "HAR" markiert ist,

bestehend mindestens aus einem H05VV-F Kabel, das mindestens 0,75

Quadratmillimeter Drahtdurchmesser hat; sowie eine IEC320 Steckdose und

einen für das Land geeigneten Stecker, 6A, 250 Volt.

As an Energy Star Partner, the manufacturer has determined that this product

meets the Energy Star guidelines for energy efficiency.

The manufacturer declares under sole responsibility that this product conforms

to the following standards or other normative documents:

EMC: EN 55022 (1993) Class A

EN 50024 (1998)

Safety: This product complies with the requirements of EN 60950 /A11:1997

Gost-R

FCC: This device complies with FCC CFR 47 Part 15 Class A.

Note: This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy, and if not installed

and used in accordance with the instructions in this manual, it may cause

harmful interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which case the user will

be required to correct the interference at his own expense.

Important Safety Instructions

This printer has been carefully designed to provide many years of safe,

reliable performance. As with all electrical equipment, there are a few

basic precautions you should take to avoid hurting yourself or damaging

the printer:

Carefully read the installation and operating instructions provided

with your printer.

Read and follow all warning instruction labels on the printer.

Place the printer on a flat, firm, solid surface.

To protect your printer from overheating, make sure all openings on

the printer are not blocked.

Do not place the printer on or near a heat source.

Do not use your printer near water, or spill liquid into it.

Be certain that your power source matches the rating listed on your

printer. If you are unsure, check with your dealer or with your local

power company.

Do not place the power cord where it will be walked on. If the power

cord becomes damaged or frayed replace it immediately.

Do not insert anything into the ventilation slots or openings on the

printer.

Only qualified, trained service technicians should attempt to repair

your printer.

Printer Overview

1.0 Introduction ................................................................ 1

1.1 About this Printer........................................................ 2

1.1.1 Standard Features....................................... 2

1.1.2 Optional Features........................................ 3

Getting Started

2.0 Before using the Printer.............................................. 5

Setting Up the Printer

3.0 Introduction ................................................................ 7

3.1 Connecting the Printer................................................ 7

3.1.1 Power Connection ....................................... 7

3.1.2 Interface Connection ................................... 8

3.1.3 Interface Cables .......................................... 8

3.2 Adjusting the Media Sensor ....................................... 9

3.3 Loading Media............................................................ 12

3.3.1 Loading Media for Peel Configuration ......... 14

3.4 Loading Ribbon.......................................................... 15

3.5 Flash Memory Expansion........................................... 17

Using the Front Panel

4.0 Introduction ................................................................ 19

4.1 Lights.......................................................................... 19

4.2 Buttons....................................................................... 20

4.3 Normal Mode - Button Functions................................ 20

4.4 Printer Setup Mode - Button Functions ...................... 21

4.4.1 Printer Setup Menu List............................... 22

4.4.2 Menu Items and Values............................... 23

4.4.3 Example of Changing Baud Rate ................ 26

4.5 Label Alignment.......................................................... 28

4.5.1 Label Alignment = YES................................ 28

4.5.2 Label Alignment = AUTO............................. 29

4.5.3 Label Alignment = NO ................................. 29

4.5.4 Label Alignment Recommended Settings.... 30

4.5.5 Label Alignment Troubleshooting................ 31

4.6 Calibration Mode........................................................ 34

4.6.1 Media Sensor Calibration Procedure........... 35

4.6.2 Auto Media Calibration Procedure............... 36

4.7 Internal Labels............................................................ 37

4.7.1 Database Configuration / Dot Check Label.. 37

4.7.2 Test Label.................................................... 39

Maintenance and Adjustments

5.0 Introduction ................................................................ 41

5.1 Cleaning the Printhead............................................... 42

5.2 Media Width Adjustment ............................................ 43

5.3 Ribbon Width Adjustment........................................... 44

5.4 Fine Printhead Adjustment......................................... 45

5.5 Printhead Replacement.............................................. 46

5.6 Darkness Adjustment................................................. 47

5.7 Resetting to the Factory Defaults............................... 47

5.8 Downloading Firmware and Fonts.............................. 48

Troubleshooting

6.0 Introduction................................................................ 49

6.1 Troubleshooting Tips.................................................. 49

Specifications.......................................................... 53

Appendix A

ASCII Control Code Chart............................................................ A-1

Appendix B

Embedded Fonts and Barcodes ..................................................... B-1

Appendix C

Warranty Information.................................................................... C-1

iii

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Impresora de Brady

Brady

Brady Bradyprinter 2461 Manual de usuario

Brady

Brady BP-PR PLUS Series Guía rápida

Brady

Brady Bradyprinter 200MVP Manual de usuario

Brady

Brady PAM 3600 Manual de usuario

Brady

Brady THT-BP Precision Manual de usuario

Brady

Brady BradyPrinter M611 Manual de usuario

Brady

Brady Bradyprinter THT 300X-PLUS Manual de usuario

Brady

Brady IP Printer series Manual de usuario

Brady

Brady touch print Manual de usuario

Brady

Brady SLV-DAT-PRO Manual de usuario

Brady

Brady BradyPrinter M611 Manual de usuario

Brady

Brady Bradyprinter 200MVP Manual de usuario

Brady

Brady BBP72 Series Manual de usuario

Brady

Brady Tagus Manual de usuario

Brady

Brady LS2000 Manual de usuario

Brady

Brady BMP21 Manual de usuario

Brady

Brady BradyPrinter S3000 Manual de usuario

Brady

Brady PAM 3000 Manual de usuario

Brady

Brady BP-IP300 Manual de usuario

Brady

Brady BBP 33 Manual de usuario

Brady

Brady BBP11-34L Manual de usuario

Brady

Brady TLS2200 Manual de usuario

Brady

Brady BradyPrinter S3700 Manual de usuario

Brady

Brady BMP 41 Manual de usuario

Manuales populares de Impresora de otras marcas

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series Manual de usuario

Evolis

Evolis Elypso Manual de usuario

Kyocera

Kyocera FS-9530DN Manual de usuario

Canon

Canon LASER SHOT LBP-1210 Manual de usuario

Samsung

Samsung BIXOLON SRP-350plusF Manual de usuario

Canon

Canon PIXMA PRO-1 Series Manual de usuario

Canon

Canon PIXMA G3560 Guía de configuración

Dell

Dell Color Laser Printer 2130cn Manual de usuario

Tektronix

Tektronix Phaser 840 Manual de usuario

Epson

Epson ET-7750 Instrucciones de funcionamiento

Canon

Canon CLBR 460ps Manual de usuario

Eltron

Eltron P210 Guide Manual de usuario

Ricoh

Ricoh MD-P1 Manual de usuario

Epson

Epson SC-F7100 series Manual de usuario

Epson

Epson Stylus C40UX Manual de usuario

Canon

Canon imagePASS-A2 Manual de usuario

Canon

Canon S820D Manual de usuario