BOXLIGHT 9000-INT Manual de usuario

FCC Warning

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment

is operated in a commercial environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio communi-

cations. Operation of this equipment in a residential area is likely to cause harm-

ful interference in which case the user will be required to correct the interference

at his own expense.

DOC (Canada)

This Class A digital apparatus meets all requirements of the Canadian Interfer-

ence-Causing Equipment Regulations.

Cet appareil numerique de la classe A respecte toutes les exigences du Reglement

sur le materiel brouilleur du Canada.

Safety Certifications

UL, CUL, TÜV, NOM

EN 55022 Warning

This product is intended for use in a commercial, industrial, or educational envi-

ronment. It is not intended for residential use.

This is a Class A product. In a domestic environment it may cause radio interfer-

ence, in which case the user may be required to take adequate measures. The typ-

ical use is in a conference room, meeting room or auditorium.

Wenn das Produkt Boxlight 9000 in Deutschland verkauft wird, muss es Umwelt

geschuetzt sein. (Klasse B) Dieses Product muss mit dem Bundesamt fuer Post

und Telekommunikation registriert sein. (BAPT)

Trademarks

Apple, Macintosh, and PowerBook are trademarks or registered trademarks of

Apple Computer, Inc. IBM and PS/2 are trademarks or registered trademarks of

International Business Machines, Inc. MicroSaver and Kensington are trademarks

or registered trademarks of Kensington Microware Limited. Microsoft, Power-

Point, and Windows are trademarks or registered trademarks of Microsoft Corpo-

ration. CablePro is a trademark or registered trademark of Boxlight Corporation.

Declaration of Conformity

Manufacturer: Boxlight Corporation

19332 Powder Hill Place, Poulsbo, Washington USA

We declare under our sole responsibility that the Boxlight 9000 Projector conforms

to the following directives and norms:

Directive 89/336/EEC, Amended by 93/68/EEC

EMI: EN 55022 (1992) Class A

EMC: EN 50082-1 (1992)

IEC 801-2, IEC 801-3, IEC 801-4

Directive 73/23/EEC, Amended by 93/68/EEC

Safety: EN 60950: 1992 + A1 + A2 + A3: 1995

March, 1998

TABLE OF CONTENTS

Safety Summary iii

Introduction 1

Image Resolution 1

Compatibility 1

Unpacking the Projector 1

Usage Guidelines 4

If You Need Assistance 4

Warranty 4

Setting up the Projector 5

Connecting an IBM-Compatible Computer Using the CablePro

Lite Cable 11

Connecting a Macintosh Computer Using the CablePro Lite

Cable 12

Connecting a Computer Using a VESA cable 13

Connecting a Computer using BNC cables 13

Connecting a Video Player 14

Connecting an External Speaker 15

Connecting the Remote Control Cable 16

Connecting a Computer with an RS-232 Cable 16

Powering up the Projector and Adjusting the Image 16

Turning Off the Projector 17

Using the Projector 19

Basic Image Adjustment 19

Adjusting the Projector 20

Using the Remote Control 21

Using the Remote and Keypad Buttons 22

Using the On-Screen Menus 25

Display Menu Functions 27

Audio Menu Functions 29

Image Menu Functions 31

Controls Menu Functions 33

Ta b l e o f C o n t e n t s

Maintenance and Troubleshooting 35

Cleaning the Lens 35

Cleaning the Fan Intake Filter 35

Replacing the Projection Lamp 37

Replacing the Batteries in the Remote Control 39

Using the Kensington Lock 39

Troubleshooting 40

Solutions to Common Problems 40

Appendix 45

Specifications 45

Accessories 47

Portable and Laptop Activation Chart 49

Using Video Mirroring with a PowerBook Computer 53

Projected Image Size for Optional Lenses 54

Connection Pin Assignments 55

RS232 Terminal Specifications 57

Index 61

iii

SAFETY SUMMARY

Please read these instructions carefully before using your projec-

tor. Failure to comply with them could result in fire, electrical

shock, personal injury or damage to equipment.

These graphics are used throughout this manual to draw your

attention to important information about the projectors.

NOTE: Additional useful details or tips.

CAUTION: Steps to take to avoid damage to your equipment.

WARNING: Steps to take to avoid personal injury.

These graphics are used on the projector’s labels.

Attention - Refer to this User’s Guide for important

safety information.

CAUTION: Hot Surfaces - Avoid touching hot surfaces.

Do not touch until the projector has cooled.

Do Not Look Into The Lens!

Be extremely careful not to look into the projection lens when the

projector is turned on. The bright light may harm your eyes. Be

especially careful to keep children from looking into the lens.

Powe r Source

Use only a three-wire grounding type power source. The power

source should not exceed 270 Volts RMS between the supply con-

ductors or between either conductor and earth ground.

Power Cord

Use only the power cord that was shipped with the projector.

Although other power cords might be similar in appearance, they

have not been safety-tested with the projector. Do not use a

power cord if it has become damaged or frayed. Contact Boxlight

at 1-800-762-5757 if you need to replace your power cord.

Safety Summary

Grounding

The projector is grounded through the grounding conductor on

the power cord. To avoid electric shock, plug the power cord into

a properly wired receptacle. Do not defeat the purpose of the

grounding-type plug.

Lamp

To avoid overheating and unacceptable image quality, replace the

projection lamp with a lamp of the specified type. Refer to

page 45 for lamp specifications and to page 37 for instructions on

replacing the lamp.

Lamp Compartment

To avoid burns, do not open the lamp module door until the pro-

jector is turned off and the lamp has cooled for at least 30 min-

utes. Follow the instructions in this manual for lamp replacement

carefully.

Hot Surfaces

Allow the projector to cool at least 30 minutes before replacing a

lamp. When you open the lamp housing, be very careful not to

touch the hot surfaces inside.

Ventilation and Overheating

Openings in the projector case provide ventilation to protect it

from overheating. Keep loose papers and other objects well away

from the grills. Do not place the projector on top of or close to a

computer or other heat-producing equipment.

Liquid Spills

Do not set drinks on top of the projector. Spilled liquids can flow

inside and cause damage.

NOTE: If you open the projector

case, you will void the warranty.

Do Not Disassemble

All service must be performed by Boxlight. The only user-service-

able parts in the projector are the projection lamp, which you can

replace by opening the lamp cover on the side of the projector

(see page 37) and the fan intake filter (see page 35). Do not open

any other part of the projector.

INTRODUCTION

The Boxlight 9000 is an XGA multimedia projector designed for

fixed installations. It allows 3 computer and 2 video inputs, along

with RS-232 control.

Image Resolution

NOTE: The projector automati-

cally expands 640x480 and

800x600 images to fill the screen.

You can display these images at

their original resolutions by turn-

ing off the Auto Resize feature.

See “Auto Resize” on page 31 for

more information.

The Boxlight 9000 can display VGA, SVGA, XGA, and SXGA

images. The native resolution of the projected image is XGA

1024x768. Screen resolutions between 1024x768 and 1280x1024

are compressed to 1024x768. The projector cannot compress

screen resolutions above 1280x1024. If your computer’s screen

resolution is higher than 1280x1024, reset it to a lower resolution

before you connect the projector.

Compatibility

The projector is compatible with a wide variety of computers and

video devices, including:

•IBM-compatible computers, including laptops, up to 1280x1024

resolution at 75 Hz.

NOTE: The projector is compati-

ble with many third-party control-

lers and amplifiers, including

AMX, Crestron, and Extron. Call

Boxlight for details.

•Apple Macintosh and PowerBook computers up to 1280x1024

resolution.

•Selected workstations (contact Boxlight for details).

•Most standard VCRs, camcorders, DVD and laser disc players.

Unpacking the Projector

The projector comes with the items shown in Figure 1. Check to

make sure all are included. Contact Boxlight immediately if any-

thing is missing.

NOTE: For model 9000-INT: To

use video input, an optional video

board must be installed in the pro-

jector. Contact Boxlight for more

information.

If you are experienced in setting up presentation systems, use the

Boxlight 9000 Quick Start card that was included in the shipping

box. For complete details on connecting and operating the projec-

tor, refer to this User’s Guide.

Introduction

NOTE: For model 9000-INT: To

use video input, an optional video

board must be installed in the

projector. Contact Boxlight for

more information.

FIGURE 1

Shipping box contents

NOTE: Long throw and short

throw lenses are also available.

See “Optional Accessories” on

page 47.

1. Boxlight 9000 projector 6. computer audio cable

2. Boxlight 9000 User’s Guide 7. CablePro Lite computer cable

3. power cord 8. VESA computer cable

4. remote and batteries 9. lens cap

5. VCR cable (RCA A/V cable)

Not shown: Quick Start card

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Proyector de BOXLIGHT

BOXLIGHT

BOXLIGHT Seattle X26N Manual de usuario

BOXLIGHT

BOXLIGHT Seattle X22N Manual de usuario

BOXLIGHT

BOXLIGHT ProjectoWrite DX25N-U Manual de usuario

BOXLIGHT

BOXLIGHT CP-731i Manual de usuario

BOXLIGHT

BOXLIGHT SP-50m Manual de usuario

BOXLIGHT

BOXLIGHT XD-5m Manual de usuario

BOXLIGHT

BOXLIGHT MP-40t Manual de usuario

BOXLIGHT

BOXLIGHT CP-15t Manual de usuario

BOXLIGHT

BOXLIGHT CP-300t Manual de usuario

BOXLIGHT

BOXLIGHT Route66 Manual de usuario

BOXLIGHT

BOXLIGHT CINEMA 20HD Manual de usuario

BOXLIGHT

BOXLIGHT Seattle X30N/W Manual de usuario

BOXLIGHT

BOXLIGHT CP-322i Manual de usuario

BOXLIGHT

BOXLIGHT CP-19t Manual de usuario

BOXLIGHT

BOXLIGHT MP-38t Manual de usuario

BOXLIGHT

BOXLIGHT CP-320t Manual de usuario

BOXLIGHT

BOXLIGHT ProjectoWrite2-W Manual de usuario

BOXLIGHT

BOXLIGHT KVU600 Manual de usuario

BOXLIGHT

BOXLIGHT Cambridge X33N Manual de usuario

BOXLIGHT

BOXLIGHT SP-48Z Manual de usuario

BOXLIGHT

BOXLIGHT N12 BNW Manual de usuario

BOXLIGHT

BOXLIGHT PRO7501DP Manual de usuario

BOXLIGHT

BOXLIGHT CD-450m Manual de usuario

BOXLIGHT

BOXLIGHT XP-56d Manual de usuario

Manuales populares de Proyector de otras marcas

iEmmet

iEmmet MP-312 Manual de usuario

Epson

Epson VS400 Manual de usuario

Sony

Sony VPL-HS10 Marketing Specifications & Features Manual de usuario

Sony

Sony VPL-HW65ES Manual de servicio

Toshiba

Toshiba TLP-791U Manual de usuario

Philips

Philips LC1341 Guía de referencia

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manual de usuario

NEC

NEC NP600S EDU Manual de usuario

BenQ

BenQ SH753P Manual de usuario

Eiki

Eiki EK-623U series Manual de usuario

Epson

Epson PowerLite Pro Cinema 6020UB Manual de usuario

Epson

Epson PowerLite Home Cinema 705HD Manual de usuario

Christie

Christie LHD700 Manual de usuario

Navitar

Navitar FX Manual de usuario

InFocus

InFocus LitePro 560 Manual de usuario

Sony

Sony SRX-R815P Manual de usuario

Vivitar

Vivitar DP1500 X Manual de usuario

Acer

Acer C20 Series Manual de usuario