6
STEP-BY-STEP GUIDE
0800 003 006 /boundaryline.co.nz
- Ensure locking plugs and grommets are fully seated
other post insert. Make sure the locking plugs are all
-
each hole. If you are facing the fence, the locking plug
post. You are now ready to insert the slats.
-
-
discard.
-
non-carbon pencil.
-
-
with pre-painted self-drilling hex. head screws #10-16.
-
SLOTTED POST INSERTS
-
end of the slat approximately 100mm. Each slat will
- The slat’s roll-formed seam should be at the top rear of
the slat when it is inserted.
-
it contacts the rear of the ColourSlatTM post. The other
end of the slat will now be able to be pushed into the
down to get it past the edge of the ColourSlatTM post.
INSERTING THE SLATS
Always start at the top as you may injure
your ngers starng from the base if a slat
slips and falls next to an inserted slat.
!
IMPORTANT
ITEM PART NUMBER DESCRIPTION
1 SPI-xx
2
3
Post-xx
5
6 Cap-xx Post Cap
3
6
5
12
SLAT TOPS
