Bosch AMC2 4W Manual de usuario

AMC2 4W

APC-AMC2-4W | APC-AMC2-4WCF | APC-AMC2-4WUS

en Installation manual

AMC2 4W | Installation manual | en 3

Bosch Sicherheitssysteme GmbH F.01U.024.965 | V 0.1 | 2006.03

Remarks

This hardware is part of a security system. Access shall be lim-

ited to authorized persons only.

Some states do not allow the exclusion or limitation of implied

warranties, or limitation of liability for incidental or consequen-

tial damages, so the above limitation or exclusion might not

apply to you.

Bosch Security Systems retains all rights not expressly granted.

Nothing in this license constitutes a waiver of Bosch’s rights

under the U.S. Copyright laws or any other federal or state law.

If you have any questions concerning this license, please, write

to:

Bosch Access Systems GmbH

Adenauerstr. 20 / A3

D-52146 Würselen

Germany.

4en | Table of Contents AMC2 4W | Installation manual

F.01U.024.965 | V 0.1 | 2006.03 Bosch Sicherheitssysteme GmbH

Table of Contents

1 Please read carefully7

1.1 Explanation of Used Symbols7

1.2 Internet7

1.3 We Are Interested in Your Opinion8

2 Safety Instructions9

2.1 Important Safety Notes9

2.2 FCC & ICES Information12

2.3 Safety Precautions13

2.4 Unpacking14

3 Introduction15

3.1 Description of the AMC2 4W 15

3.2 Equipment Configuration17

3.3 Performance Characteristics20

3.4 System Overview21

4 Technical Data22

5 Installing26

5.1 Mounting26

5.2 Demounting27

5.3 Opening the AMC2 4W Case28

5.4 Cabling28

5.5 Connecting Power Supply31

5.6 RS-485 Host Interface33

5.6.1 RS-485 Two Wire Connection35

5.6.2 RS-485 Four Wire Connection36

5.6.3 DIL Switch Address Selector37

5.7 RS-232 Host Interface39

5.8 Ethernet Interface41

5.9 RS-485 Extension Module Bus42

5.10 Wiegand Interface for Card Readers43

5.11 Connecting Relay Outputs44

5.12 Connecting Analog Input Devices47

5.13 Tamper Protection49

6 Operating50

6.1 Status Display of the AMC2 4W50

6.2 Configuring the Ethernet Interface52

6.3 Resetting the AMC2 4W52

7 Appendix54

7.1 Connecting Diagrams54

AMC2 4W | Installation manual Table of Contents | en 5

Bosch Sicherheitssysteme GmbH F.01U.024.965 | V 0.1 | 2006.03

7.2 Legend58

8 Index59

6en | Table of Contents AMC2 4W | Installation manual

F.01U.024.965 | V 0.1 | 2006.03 Bosch Sicherheitssysteme GmbH

AMC2 4W | Installation manual Please read carefully | en 7

Bosch Sicherheitssysteme GmbH F.01U.024.965 | V 0.1 | 2006.03

1 Please read carefully

1.1 Explanation of Used Symbols

Throughout this document, helpful tips, important notes, cau-

tions and warnings will be presented for the reader to keep in

mind. These appear different from the rest of the text as fol-

lows:

1.2 Internet

If you are interested in further information on this product or

information on other products, please, refer to our website at

http://www.bosch-security-systems.com.

CAUTION! or WARNING!

These warn the operator that damage to the program or equip-

ment might occur.

NOTE!

Important Notes – must be followed for successful operation

and programming. Tips and shortcuts might also be included

here.

8en | Please read carefully AMC2 4W | Installation manual

F.01U.024.965 | V 0.1 | 2006.03 Bosch Sicherheitssysteme GmbH

1.3 We Are Interested in Your Opinion

We constantly try to improve the quality of our products and

our manuals. Should you have any suggestions for improve-

ment, please, send us your comments.

Bosch Security Systems

Adenauerstr. 20 / A3

D-52146 Würselen

Germany

Tel.:+49 24 05 / 60 05-0

Fax:+49 24 05 / 60 05-29

Email:[email protected]

AMC2 4W | Installation manual Safety Instructions | en 9

Bosch Sicherheitssysteme GmbH F.01U.024.965 | V 0.1 | 2006.03

2 Safety Instructions

2.1 Important Safety Notes

1. Read, Follow, and Retain Instructions - All safety and

operating instructions must be read and followed properly

before putting the unit into operation. Retain instructions

for future reference.

2. Consider all Warnings - Adhere to all warnings on the unit

and in the operating instructions.

3. Accessories - Use only accessories recommended by the

manufacturer or those sold with the product. Accessories

not recommended by the manufacturer shall not be used,

as they may cause hazards.

4. Installation Precautions - Do not place this unit on an

unstable stand, tripod, bracket, or mount. The unit may

fall, causing serious injury to persons and damage to the

unit. Mount the unit according to the manufacturer’s

instructions.

5. Cleaning - Disconnect the unit from power before cleaning.

Follow any instructions provided with the unit. Generally,

using a damp cloth for cleaning is sufficient. Do not use liq-

uid cleaners or aerosol cleaners.

6. Service - Do not attempt to service this unit by yourself.

Opening or removing covers may expose you to dangerous

voltages or other hazards. Refer all servicing to qualified

service personnel.

7. Damage Requiring Service - Disconnect the unit from the

main AC or DC power source and refer servicing to quali-

fied service personnel under the following conditions:

•When the power supply cord or plug is damaged.

•If liquid has been spilled or an object has fallen into

the unit.

•If the unit has been exposed to water and/or inclem-

ent weather (rain, snow, etc.).

•If the unit does not operate normally, when following

the operating instructions. Adjust only those controls

10 en | Safety Instructions AMC2 4W | Installation manual

F.01U.024.965 | V 0.1 | 2006.03 Bosch Sicherheitssysteme GmbH

specified in the operating instructions. Improper

adjustment of other controls may result in damage,

and require extensive work by a qualified technician

to restore the unit to normal operation.

•If the unit has been dropped or the cabinet damaged.

•If the unit exhibits a distinct change in performance,

this indicates that service is needed.

8. Replacement Parts - When replacement parts are

required, the service technician shall use replacement

parts that are specified by the manufacturer. Unauthorized

substitutions may result in fire, electrical shock or other

hazards.

9. Safety Check - Upon completion of service or repair work

on the unit, ask the service technician to perform safety

checks to ensure that the unit operates properly

10. Power Sources - Operate the unit only from the type of

power source indicated on the label. If unsure of the type

of power supply to use, contact your dealer

•For units intended to operate from battery power,

refer to the operating instructions.

•For units intended to operate with External Power

Supplies, use only the recommended approved power

supplies.

•For units intended to operate with a limited power

source, this power source must comply with EN/UL

60950. Substitutions may damage the unit or cause

fire or shock.

•For units intended to operate at 12 VDC normal input

voltage is 12 VDC. Voltages applied to the unit’s

power input shall not exceed 15 VDC. User-supplied

wiring, from the 12 VDC power supply to the unit,

must be in compliance with electrical codes (Class 2

power levels). Do not ground the 12 VDC supply at the

terminals or at the unit’s power supply terminals.

11. Grounding - If an outside cable system is connected to the

unit, ensure that the cable system is grounded. U.S.A.

models only Section 810 of the National Electrical Code,

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Controladores de Bosch

Bosch

Bosch rexroth ctrlX CORE Manual de usuario

Bosch

Bosch Rexroth CKL Series Guía

Bosch

Bosch Rexroth IndraControl L25 Manual de usuario

Bosch

Bosch ADS-AMC2-4R4CF Manual de usuario

Bosch

Bosch Smart Home controller II Manual del operador

Bosch

Bosch D2212B Guía de inicio rápido

Bosch

Bosch KJR-120C1/BTF-E Instrucciones de funcionamiento

Bosch

Bosch BAT 251 Manual de usuario

Bosch

Bosch CC 100 M Manual de usuario

Bosch

Bosch AVENAR panel 8000 Manual de usuario

Bosch

Bosch AEC-AMC2-VDS1 Manual de usuario

Bosch

Bosch CS 550 Manual de usuario

Bosch

Bosch 560 DDC Manual de usuario

Bosch

Bosch WORCESTER Sense II Manual de usuario

Bosch

Bosch READYKEY PRO LNL-500 Manual de usuario

Bosch

Bosch Buderus Logamatic 5000 Series Manual de instrucciones

Bosch

Bosch EasyControl CT200 Manual de usuario

Bosch

Bosch Rexroth CS 106 Guía del usuario

Bosch

Bosch Rexroth ctrlX SAFETY SAFEX-C.12 Manual de usuario

Bosch

Bosch Intuvia BUI255 Manual de usuario

Bosch

Bosch CL200 Manual de usuario

Bosch

Bosch rexroth SB24 Manual de usuario

Bosch

Bosch D1255TD Manual de usuario

Bosch

Bosch Rexroth IndraDrive CsDrive System with HCS01 Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario