12 13
SAFETY PRECAUTIONS
• Turn the blade set counterclockwise against the
stop to fix it tightly in the jar.
For easy cleaning pour some water into the
blender’s jar, add a drop of the cleaning agent and
switch on for several seconds. Then rinse with clear
water.
CLEANING OF THE BLENDER’S CASING
The outside part of the blender’s casing can be first
wiped with a wet napkin soaked with soapy solution
and then with a soft dry napkin or use a special
agent for cleaning of metal surfaces.
When cleaning the blender do not use wire
wools, chemical agents, abrasive cleaning agents
containing sulfanilic or citric acid.
STORAGE OF THE BLENDER
Store the appliance assembled in the vertical
position.
• The blender is meant for blending of liquids and
food. Use the blender for the purpose specified.
• This appliance shall be used only in home
conditions.
• The blender shall not be used by unattended
children.
• Before usage make sure that the appliance is
properly and entirely assembled.
• Place the appliance only on a dry even horizontal
surface. Do not place the blender on a gas or
electric oven, and in a close proximity to sources
of heat.
• Never immerse the base with the motor, the
power cord or the plug of the power cord in water
or any other liquid. Avoid formation of water
condensate thereon, do not use the blender in
places with increased humidity.
• Do not leave the operating blender unattended.
• Do not overload the blender’s jar – do not fill
it above the maximum level mark. Excessive
amount of products can stop the motor.
• Do not mix hot products and liquids in the
blender. Let them cool down before placing them
in the jar.
• Always unplug the appliance after use, as well as
before assembly, dismantling and storage.
• The blender’s blades are very sharp and require
extremely careful handling. Do not place your
hands in the blender’s jar when it is plugged.
• Avoid hanging of the cable down the edge of the
table, do not lay in on heating surfaces, avoid
cable jam.
• Do not move the operating blender. Do not
remove the blender’s lid and jar from the base
during operation.
• Do not place any parts of the blender into
a microwave oven.
• Do not use the jar for storage of products.
• Do not switch on the blender without food or
liquids.
• In order to ensure the blender’s safety and
correct operation use only BORK’s original parts.
• Regularly inspect the power cord, the plug of
the power cord and the blender for damages.
Upon detection of any damages immediately
suspend operation of the blender and bring it to
the nearest service center for testing, repair or
replacement.
• For safety reasons all operations on repair
and maintenance of the blender, except for
cleaning, shall be performed only by authorized
representatives of BORK certified service
centers.
