Bogen Easy Design HS15EZ Manual de usuario
Easy Design Speaker
Models HS15EZ
HS15EZW
TM
Speaker Layout
The layout of the speakers should be planned prior
to installation. Desired mounting height, barring
obstructions, is 15 to 20 feet, with the speakers
angled downward toward the listening area and
facing in the same direction.
Layout starts in one corner of the area (see Figure
1).The first speaker in Row 1should be positioned
a distance equivalent to (A) (see Figure 2) from the
corner based on the noise level of the area. The
next speaker in Row 1should be a distance equiv-
alent to (B) (see Figure 2) from the first speaker.
Each additional speaker in the row should use this
same spacing.
Row 2 starts a distance equivalent to (C) (see
Figure 2) from Row 1, and, like Row 1, each speak-
er should be a distance apart equivalent to (B).
Row 3 starts a distance equivalent to (C) from
Row 2. Continue this pattern of alternating rows
until the area is appropriately covered.
For areas that include high shelving or corridors,
speakers should be installed so that they project
down the aisles between the shelves or down
through the corridors.
The spacing of the speakers can be adjusted so
that the speakers are evenly spaced in a row.
NOTE: Each environment is unique.This layout
plan is general in nature and may not be
applicable for every installation.
Figure 1
START HORN SPEAKER
A
B
C
Row 1
Row 2
Row 3
Row 4
Figure 2
Specifications subject to change without notice.
© 2000 Bogen Communications Inc. All rights reserved.
Part No. 54-5072-01r2 Printed in Korea 0100
50 ft. 100 ft. 60 ft. 1/2 Rotation
High Noise
(75dB-85dB)
30 ft. 65 ft. 40 ft. Full Clockwise
A B C Volume Setting
PLACEMENT
Very High Noise
(85dB-95dB)
50 Spring Street, Ramsey NJ 07446
Tel. 201-934-8500, Fax: 201-934-9832
www.bogen.com
Speaker Installation
STEP 1-For easier installation, remove the flange (base)
from the speaker by unscrewing the wing nut while at the
same time pressing inwardly on the wing nut. Place the
flange flush with the mounting surface and mark the loca-
tion of the three holes with either a marker or chisel. It is
important that the three holes be exactly aligned with the
flange, otherwise you might stress the base or make the
connection unsteady. Drill the necessary holes and screw
the flange to the surface (see Figure 3). (Use appropriate
hardware for your specific mounting surface.)
NOTE: The speaker may also be strap-mounted using
standard 1/2-inch industrial strapping.
STEP 2 - After mounting the flange, reattach the speaker
to the flange and aim the speaker for the desired coverage.
A 45 downward angle is recommended, but this may vary
depending upon speaker layout.
STEP 3 - Remove the plastic cover to make the electrical
connection and set the volume control (see Figure 4).The
suggested amplifier connections are:
Amplifier Outputs Speaker Connections
70V Terminal 1
COM Terminal 2
NOTE: The speaker will also work perfectly well with these
connections reversed. However, it is important to be
consistent in the wiring of the speakers in the system.
STEP 4 - Adjust the volume control to the desired setting.
See Figure 2 for the suggested initial settings based on the
ambient noise level of the environment. Place the plastic
protective cover back over the exposed area.
NOTE: The two furthermost clockwise settings
(positions 7 and 8) on the volume control will produce
the same volume.
Figure 3
Figure 4
ELECTRICAL
CONNECTION
VOLUME
CONTROL
o
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Oradores de Bogen
Bogen
Bogen FG15 Manual de usuario
Bogen
Bogen NEAR OPS1 Guía
Bogen
Bogen Quantum S810QIPPG8U Manual de usuario
Bogen
Bogen Bogen NEAR ORBIT OPS1 Guía
Bogen
Bogen ASWB1 Guía
Bogen
Bogen HFCS1 Guía
Bogen
Bogen Near Signature S5 Manual de usuario
Bogen
Bogen Easy Design CS1EZ Manual de usuario
Bogen
Bogen ASWB1 Guía
Bogen
Bogen Bogen WBS8T725 WBS8T725 WBS8T725 Manual de usuario
Bogen
Bogen NEAR A2 Manual de usuario
Bogen
Bogen Speaker Line Attenuator UTI1 AUX Manual de usuario
Bogen
Bogen AMT-12 Guía de dimensiones
Bogen
Bogen HFCS1 Manual de usuario
Bogen
Bogen ENHANCER ESYS1 Manual de usuario
Bogen
Bogen NEAR A12 Manual de usuario
Bogen
Bogen ACD2X2 Manual de usuario
Bogen
Bogen FG15 Manual de usuario
Bogen
Bogen AMBSL1 Manual de usuario
Bogen
Bogen FMH15T Manual de usuario
