01
Thank you for purchasing a BlueSpot product, you can find further information on our range at
www.BlueSpot.uk.com. Please ensure that you are using the product correctly and that all
guidance and cautions are followed in accordance with the instructions. Please retain these
instructions for future reference.
General Information
Please make sure that you read these instructions carefully in order to avoid injury when using
the tool. Follow all health and safety rules and regulations. If in doubt and available please
contact a more knowledgeable source.
The product is marked with a sticker to show the laser aperture. Please make sure you are
aware of where this is before beginning.
• Maintain tool in good and clean condition for best and safest performance.
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear
non-slip shoes.
• Keep children and unauthorised persons away from the work area.
• If the thermometer is damaged do not use.
• Do not point the laser directly at eyes or indirectly off reflective surfaces.
• Do not use the thermometer in the environment of explosive gas, steam or dust.
To avoid damaging the thermometer or the target please protect from the
following situations.
• Do not leave the thermometer on or near objects of high temperature.
• EMF (electro-magnetic fields) from arc welders, induction heaters.
• Thermal shock (caused by large abrupt ambient temperature changes. Allow
30 minutes for the thermometer to stabilise before use).
Safe use
The BlueSpot Infrared Thermometer is used for measuring the temperature of the objects surface,
which is applicable for various hot, hazardous or hard to reach objects. The thermometer consists
of optics, temperature sensor signal amplifier, processing circuit and an LCD display.The optics
collect the infrared energy emitted by an object and focus onto the sensor.The sensor then
translates the energy into an electricity signal.The signal will be shown digitally on the LCD.
The infrared thermometer boasts single dot laser targeting as well as a back light to illuminate
the screen in dark conditions.The readings are available in both Celsius and Fahrenheit. For more
accurate readings the thermometer features a hold function. Ideal for industrial and home use.
Accuracy +/- 0.5%
Product Introduction
