ØDO keep body parts, clothing & power cords clear of turning/cutting pieces.Stay alert and
use common since when using this tool.
ØDO allow machine to reach operating speed before starting a hole.
ØDO unplug machine while changing or adjusting cutting bits so as not to accidentally turn
machine on.
ØDO remove adjusting wrenches prior to turning the machine on.
ØDO guard against electric shock by only operating this tool on a properly functioning GFCI
(Ground Fault Circuit Interrupt) circuit.
ØDO be mindful that power tools can expose an operator to vibrations transmitted trough
contact with the machine. Prolonged exposure can lead to medical issues which should be
discussed with a medical professional.
ØDO tie in a drip loop in the power cord to prevent water from running into the power
receptacle.
ØDO use a dust extraction system for cutting materials that create dust. The operator should
also wear a protective respiratory device.
ØDO NOT make adjustments to machine while the machine is running.
ØDO NOT switch off the machine when it is under load, except in an emergency.
ØDO NOT remove or modify grounding plug. Only to be used on a properly grounded GFCI
circuit.
ØDO NOT leave the machine running when not in use.
ØDO NOT hold the work piece by hand or using body. Always mechanically clamp or secure
work piece.
ØDO NOT allow operator to make contact with grounded surfaces such as metal objects.
ØDO NOT allow liquids to enter the machine’s ventilation system.
ØDO NOT operate machine outside of machine specifications.
ØDO NOT touch moving parts while the machine is running as death or dismemberment could
occur.
ØDO NOT operate machine overhead (Inverted) when drilling “wet” type cores.
ØDO NOT remove machines electrical components while connected to a power source. Only to
be removed for service by qualified personal and put back on the machine after service is
complete.
ØDO NOT allow children or untrained personal to operate machine.
ØDO NOT use this machine in the rain or a wet environment.
ØDO NOT operate in the presence of explosive materials as power tools create sparks which
may ignite dust or fumes.
ØDO NOT drill into an area that may contain a live electrical wire/circuit.
