Blue Torrent AC 50032 Manual de usuario

Thank you for choosing Blue Torrent.

PLEASE READ BEFORE RETURNING THIS

PRODUCT FOR ANY REASON.

SAVE THIS MANUAL FOR FUTURE

REFERENCE.

INSTRUCTION MANUAL

MODE D'EMPLOI

MANUAL DE INSTRUCCIONES

POOL WATCH SWIMMING POOL ALARM

MODEL NUMBER

AC 50032

NSF - 50

ASTM F2208

SAFETY GUIDELINES — DEFINITIONS

It is important for you to read and understand this manual. The

information it contains relates to protecting YOUR SAFETY and

PREVENTING PROBLEMS. The symbols below are used to help you

recognize this information.

Indicates an imminently hazardous situation which, if not

avoided, will result in death or serious injury.

Indicates a potentially hazardous situation which, if not

avoided, could result in death or serious injury.

Indicates a potentially hazardous situation which, if not

avoided, may result in minor or moderate injury.

(Used without word) indicates a safety-related message.

Used without the safety alert symbol indicates potentially

hazardous situation which, if not avoided, may result in

property damage.

IMPORTANT SAFETY

INSTRUCTIONS

When using an electrical appli-

ance, basic precautions should

always be followed, including the

following:

READ ALL

INSTRUCTIONS

BEFORE USING

THIS POOL ALARM.

DANGER:

WARNING:

CAUTION:

NOTICE:

• Do not allow to be used

as a toy. Close attention is

necessary when used by or near

children.

• Use only as described in this

manual.

• Battery fluid is corrosive and may

be toxic. It may be harmful or fatal if

swallowed. Avoid all contact with

this substance.

•Keep batteries out of reach of

children.

•Immediately remove old, weak, or

worn out batteries from your device.

Recycle or dispose of old, weak, or

worn batteries in accordance with

local, regional, or national law or

regulations.

•Never dispose of batteries in fire, as

they may leak and explode.

•Secure battery cover. Do not allow

batteries to become wet.

•When inserting batteries, follow the

polarity markings.

•Replace all batteries at the same

time. Do not mix new and old

batteries.

•Never mix alkaline, standard

(carbon-zinc), and rechargeable

(nickel-cadmium) batteries.

•Remove batteries when alarm is not

in use for an extended time.

•Do not put any object into openings.

•If appliance is not working as it

should, has been dropped,

damaged, or dropped into water,

return it to a service center.

•Do not allow children to operate the

alarm system.

•This appliance is intended for

household use only and not for

commercial or industrial use.

WARNING:

Read all safety warnings

and all instructions. Failure

to follow the warnings and

instructions listed below may

result in electric shock, fire and/

or serious injury.

WARNING:

To reduce the risk of fire,

electrical shock, or injury:

IMPORTANT SAFETY

INSTRUCTIONS,

CONTINUED.

Once reading these safety

instructions, follow the manual

step by step to ensure a quick,

easy, and safe installation.

• Protect the pool with a

barrier fence, a gate, a gate

or door alarm, a pool cover,

and any additional

protections.

•Never leave children

unattended near the pool.

•Keep the alarm in an area

where it can be easily heard.

•Maintain a proper water

level in your pool to ensure

proper detection.

•Once installed, test the

system on a weekly basis.

•Keep pool water clean and

clear. Green or cloudy water

caused by improper

maintenance can conceal

individuals who have fallen

into the pool.

•Monitor children in proximity

of the pool closely.

•Increase supervision if more

people or children are in the

pool.

•Under supervision, teach

children to swim as soon as

possible.

•Children who are unable to

swim should always wear a life

vest in the pool area.

•Learn life saving techniques,

especially for small children.

•Do not leave toys or objects

floating in an unattended pool.

Toys or objects could be seen

as an invitation for a child to

enter an unattended pool.

•Prohibit running near the pool.

•Store pool chemicals in a secure

location out of reach from

children.

•Remove the unit if water

temperature drops below 32°

F/0° C.

WARNING:

The AC 50032 is not

intended for negative edge

or infinity-style pools.

DANGER:

At the sound of alarm, an

immediate response is

imperative. Drowning can

occur in as little as three

minutes.

DANGER:

Have an action in plan

should the alarm sound.

Keep a working phone

within the pool area. Be

prepared for an

emergency.

The AC 50032 is a pool alarm

designed to detect intrusions

into an unsupervised pool. It

is not a lifesaving device. It

should never replace the

supervision of children by

responsible adults.

WARNING:

To reduce risk of injury:

POOL WATCH

AC 50032 POOL

ALARM FACTS

•This is a alarm designed to

detect an intrusion into the

swimming pool, especially by

young children. Alarm should

only be used for this application.

•This alarm has been engineered

to circumvent false alarms

caused by wind, rain, floating

objects, or automatic cleaners.

•Loaded with patented features

and the result of years of

research and development, this

alarm when used properly is

designed to provide an efficient

and trouble-free solution to

pool security.

A. Main Alarm Body

B. Remote Siren

C. AC Adapter for Remote

Siren

D. Mounting Screws for

Main Alarm

CONTENTS:

USES HIGH TECH SENORS

FOR ELEVATED SAFETY.

Alarm must have working

batteries. Test unit weekly.

NSF - 50

ASTM F2208

Begin installation by carefully

unpacking box. If any parts

are missing, contact

[email protected]

for replacements.

NOT INCLUDED: 6 Long

Life Alkaline D Cell 1.5V

Batteries and 1 Long Life

Alkaline 9V Battery

WHERE TO INSTALL ALARM

To ensure alarm performs at its optimal capability, choose

closest pool type from diagram below and use the

corresponding mounting points for alarm installation.

REQUIRED TOOLS:

For a Rectangular Pool: the AC 50032 should be installed at

location 1 for pools up to 32' x 16' or 9.6 meters x 4.8 meters. A

second AC 50032 should be installed at location 2 for larger pools.

For a Freeform Pool: the AC 50032 should be installed at location

1 for pool size is up to 26' or 8 meters. For larger pools, a second

alarm is required, and AC 50032 alarms should be installed at

location 2 and location 3.

For an Oval Pool: the AC 50032 should be installed at location 1

for pools up to 24' or 8 meters. For larger pools, a second alarm is

required, and AC 50032 alarms should be installed at location 1

and location 2.

For an L-Shaped Pool: the AC 50032 should be installed at

location 1 for pools up to 17'. For larger pools, a second alarm will

be needed at location 2.

For a Round Pool: the AC 50032 should be installed in any of the

4 locations for pools up to 24'. For larger pools, a second alarm

will be needed.

1. Pencil

2. Phillips head screwdriver

3. 1/4" drill bit

4. Electric drill

5. Adjustable wrench

6. Masking tape

INSTALLING THE ALARM

STEP 1: Test fit alarm in location determined above. As shown in

Figure 1, the alarm sensor pipe throat should be in the water and

the mounting area level and flat. The alarm base should easily

snap into the bottom of the main alarm body and allow the sensor

throat to extend directly into the pool at a 90° angle.

STEP 2: Use pencil to mark two holes to be drilled into deck to

secure alarm, aligning marks with holes in left and right of the

alarm body head. Refer to Figure 2 for appropriate spacing.

STEP 3: Drill holes into hole markings with a 1/4" masonry drill.

Refer to Figure 2 to drill holes 1.75" deep. To achieve the right

depth, measure 1.75" inches from the end of the drill bit, and mark

point with masking tape. Stop drilling when deck is level with

tape. Remove dust and debris from hole. Remove nuts and

washers from mounting anchors, and insert mounting anchors

into previously drilled holes. To mount into wood deck or metal

rail, use screws provided.

WARNING:

Use power tools only as recommended by

manufacturer. Do not install alarm or use

power tools when swimmers are in the

pool. Remove all power tools from pool

area as soon as possible.

STEP 4: To install/replace batteries, remove all four screws

from the battery cover. Refer to Figure 3. Do not lose screws.

When the 6 long life alkaline D cell 1.5V batteries are installed,

the alarm will loudly beep twice. Next, turn front switch to SWIM

mode. The alarm will sound in one long burst to signify it is in

swim mode. WHITE LED will flash on top of alarm head every 20

seconds to indicate that the alarm is on and can be handled for

3 minutes without siren sounding.

STEP 5: Screw the main alarm body into mounting anchors on

pool edge.

STEP 6: Adjust and maintain pool water level. This step is

imperative in order for the pool alarm sensor to perform properly.

The alarm sensor throat should be no more shallow or deep than

0.19" to 0.39" in the water at all times. Never block or fill air hole

located on the back of alarm sensor throat. See Figures 4.1-4.4 for

improper water level and Figure 5 for proper water level.

STEP 7: Mount the Remote Siren no more than 100 linear feet

from the alarm base unit in an area inside your home where it will

be heard throughout the house in the event of alarm sounding.

FIG. 5

0.19" - 0.39"/

MOUNTING THE REMOTE SIREN: Remove the Phillips head

screw from the back of the remote siren. Install 1 long life alkaline

9V battery and replace cover. Plug the AC adapter into the

remote siren. Then place remote siren on flat surface or use a

screw to mount it to wall near electrical socket. Plug AC adapter

into electrical socket, using Figure 6 for reference. To show

function, the remote will give two short sirens and display a RED

LED light. When siren receives a trigger signal from the main alarm

unit, it will sound. Battery in remote siren unit is intended as

backup in the case that main AC power should fail. Make sure main

AC adapter is plugged in at all times. If battery in main alarm is low,

remote siren will beep once each 8 seconds. It's imperative at that

time to change battery for main alarm.

• Do not use with damaged cord or plug. If appliance is not

working as it should, has been dropped, damaged, left outdoors

or dropped into water, return it to a service center.

• Do not pull or carry by cord, use cord as a handle, close a door

on cord, or pull cord around sharp edges or corners. Do not run

appliance over cord. Keep cord away from heated surfaces.

• Do not unplug by pulling on cord. To unplug, grasp the

plug, not the cord.

• Use only in a standard electrical outlet (120V/60Hz).

WARNING:

STEP 8: Turn the return jets built into inside pool walls down

toward the bottom of the pool, using Figure 7 as a guide. This

will both help conserve the chemical consumption of your pool

and allow the pool alarm to work efficiently. If water features

such as waterfalls, automatic cleaners, or pump cycling cause

false alarms, turn the water feature off when the pool is not in

use. Contact the manufacturer with any additional questions.

UNDERSTANDING "FAR" MODE

To help reduce false alarms, the Pool Watch AC 50032 Alarm is

equipped with "False Alarm Resistant" technology. When in FAR

mode, the alarm monitors the water and detects outside

interference from conditions such as wind and automatic

cleaners. It then compensates for these factors without

compromising alarm safety.

FAR mode is alternate to the alarm's default armed mode

setting. After the GREEN LED light has been on for a constant 6

seconds, the alarm will beep for 1 second, and the LED will then

flash every 2 seconds. After any 5 minute period without

detecting movement, the alarm will automatically revert to

normal armed mode.

The alarm can also be taken out of FAR mode by adjusting the

switch from RESET to SWIM to RESET.

Tabla de contenidos

Manuales populares de Sistema de seguridad de otras marcas

Inner Range

Inner Range Concept 2000 Manual de usuario

Climax

Climax Mobile Lite R32 Instrucciones de montaje

CADDX

CADDX NX-6 Manual de usuario

FBII

FBII XL-31 Series Manual de usuario

Johnson Controls

Johnson Controls PENN Connected PC10 Manual de usuario

Aeotec

Aeotec Siren Gen5 Manual de usuario

Blaupunkt

Blaupunkt SA 2700 Manual de usuario

IDEAL

IDEAL Accenta Manual del propietario

AJAX

AJAX DoubleButton Manual de usuario

Swann

Swann SW-P-MC2 Manual de usuario

Ecolink

Ecolink Siren+Chime Manual de usuario

Digital Monitoring Products

Digital Monitoring Products XR150 Manual de usuario

EDM

EDM Solution 6+6 Wireless-AE Manual de usuario

Highway Safety Group

Highway Safety Group EA401 Manual de usuario

Siren

Siren LED GSM Manual de usuario

Detection Systems

Detection Systems 7090i Instrucciones de montaje

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manual de usuario

Siemens

Siemens FDM273 Manual de usuario