PART# BMX-2121
Blend
lllount-
®
ESCORT.
PASSPORT
MAX
Innovative
Mounting
Solutions
APPROXIMATELY 1/2"
GAP
BETWEEN
MIRROR
-
AND
RO
5 • Install the RD onto the mount. Make the necessary adjustments as shown above.
Using the vertical adjustment, we recommend you adjust the RD so there
is
approxi-
mately 1/2" gap between the bottom
of
the mirror and the top
of
the
RD
. After all ad-
justments are made,
be
sure to check that all adjustment screws are tight. Grab the
long arm
of
the alien wrench to assure that these screws are securely tightened.
You
will not strip out the tapped holes in the aircraft grade aluminum.
6 •
To
access the buttons
of
the RD you will need to gently push
downward on the front
of
the RD with one finger and push the de-
sired button with another finger. Then allow the RD to return to it's
original position by gently letting it spring upward. When accessing
the buttons, be sure to push the RD downward
just
enough for your
finger to fit between the RD and mirror. Do not push down more
than what
is
needed.
~VING
RD
'
•;
· 2 ' INSTALLING R ,
-~~
.•
SLIDE
RO
ONTO
_,
.•
~RING Cl.IP AS
r
AS
IT
till
GO
'
7 • When removing
or
installing the RD, squeeze the trigger and the back side
of
the mounttogether with one hand, and lift the front
of
the RD upward with
the other hand before sliding the RD off or onto the spring clip. You
must
lift
the
front
of
the
RD
upward
before
sliding
it
off
or
onto
the
mount.
NOTE : This mount can get extremely hot when sitting in direct sunlight. If you intend to remove your RD frequently, you may want
to
install the two gray
"TOUCH STRIPS" included in the tool kit. Place them where your fingers make contact with the mount. They may be trimmed with a blade or knife.
FOR MORE INFO VISIT www.blendmount.com/videos
CAUTION
DO
NOT use this mount
if
it interferes with the adjustability or the operation
of
your rear view mirror in any way.
DO
NOT use this mount if the radar detector creates
an
unsafe viewing obstruction.
DO
NOT ATTEMPT
TO
MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMount products are accompanied with detailed installation instructions and adjustment tips.
You
are encouraged to contact customerser1ice@blend-
mount.com or call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs.
www.blendmount.com
Innovative Design
And
Precision Manufacturing PAGE 2 OF 2
Your feedback is very important to us. Please email any questions or
BlendMount-
US PATENT# D625,580 S, D656,
811
S,
0653
,980 S
D690,245
S,
D690,246
S,
D690,247
Sand
other patents pending
