WEIGHT UNIT SELECTION
Press the UNITS key to select the weight u its, the display will view the optio s.
There are 8 weight u its available.
RESET TO ZERO
If the zero value varies duri g the weighi g, press the key, the display will
show zero agai .
TARE
This fu ctio allows calculati g the et weight of a product.
With display showi g “zero”, place a co tai er o the pa , the press the key,
the bala ce will subtract the co tai er´s weight, put the product i to the co tai er
a d the read the product´s weight o the display ( et weight)
To retur to ormal weighi g model, remove the co tai er a d press the
key.
OVERLOAD MESSAGE
If a object is placed o the pa a d its weight exceeds the maximal capacity of
the bala ce, the display will show the message "-----OL-----", at the same time, the
bala ce will beep. Remove the object; otherwise it may damage the mecha ism of
the bala ce.
PIECES COUNTING FUNCTION
The pieces cou ti g fu ctio is used to cou t the umber of pieces deposited o
the pa .
Place a co tai er o the pa a d press the key.
I sert a certai umber of pieces (10, 20, 50 or 100) i to the co tai er. This
umber of pieces is the i itial sample, the higher umber gra ts more accuracy i
fi al cou ti g.
Press the MODE key, select the desired sample umber usi g the or UNITS
keys. To co firm the selected value, press the PCS key.
The bala ce will accept the sample a d after a few mi utes will i dicate the pieces
cou ti g mode.
The display will show the umber of pieces placed o the pa , add the rest of
