Blanco FE9085X Guía de instalación

Instructions for the Use and Care and Installation of
FE9085X
Electrical Freestanding Multifunction Cookers


Dear Customer
Thank you for choosing our product.
Please read this hand book carefully before installing and using it, as you will find the
correct indications for the best installation, use and care of the product.
You will find that the clean lines and modern look of your Blanco oven blends in
perfectly with your kitchen décor. It is easy to use and performs to a high standard.
Blanco also makes a range of products that will enhance your kitchen – such as
cooktops, rangehoods, dishwashers, microwaves, sinks and taps. There are models
to complement your new Blanco oven.
Of course, we make every effort to ensure that our products meet all your requirements,
and our Customer Service Centre is at your disposal to answer all your questions and to
listen to all your suggestions.
Please complete the warranty section of this manual and keep your receipt as proof of
purchase. Retain all documents relating to the purchase of your Blanco product.
Blanco is committed to providing increasingly efficient products that are easy to use,
respect the environment and are attractive and reliable.
BLANCO

Index
GENERAL WARNINGS p. 5- 7
Instructions for installation:
• Dimensions and installation features p. 8
• Electrical connection p. 9 - 10
Instructions for use
• cooktop p. 11
• oven p. 12- 15
Instructions for cooking p. 16- 17
Instructions for the assembly
of bottom kick plate onto the cookers p. 18
Maintenance and cleaning p. 19- 21
Blanco Customer Service p. 22
Blanco product warranty p. 23
4

• Very important: keep this instruction booklet with the appliance in case you pass
it on to someone else.
•In order to prevent accidental tipping of the appliance, for example by a
child climbing onto the oven door, the stabilizing means must be installed.
Please refer to instructions for installation.
• This appliance is not intended for use by young children or infirm persons without
supervision.
• Young children should be supervised to ensure that they do not play with the
appliance.
• Don’t touch the heating elements inside the oven.
• When the grill is on all the accessible elements are hot, hence, keep children
away from these elements.
• The product installation must be performed by competent and qualified installers
who are aware of the installation regulations in force.
• Do not use the steams jets for cleaning.
• Before maintenance or cleaning disconnect the appliance from the mains and
wait for it to cool down.
• Ensure the appliance is switched off before replacing the lamp to avoid the pos-
sibility of electric shock.
• Switch off all heating element before removing cookware.
• Be careful not to place saucepans with unstable or deformed bottoms on the bur-
ners to avoid accidents by overturning or spilling over of liquid.
• The user must not change the appliance supply cable. For replacement contact
only a licenced electrican.
• Should the ceran top be even lightly cracked, immediately turn off the main
General Warnings
power and contact customer service.
• Never put aluminium sheets, plastic containers, or other perishable material, on
heated tops. Never use the cerantop as a support base for other objects.
5

• Accessible parts will become hot when in use, to avoid burns and scalds children
should be kept away
• Do not leave the packaging unsupervised for, the safety of Children.
• Replaced appliancesmust be taken to a special garbage
collection centre
•Always use oven gloves to remove and replace food in
the oven. Ensure that you support the grill pan when
removing from the oven.
•Do not allow persons especially children sit down or play
with the oven door. Do not use the drop down door as
a stool to reach above cabinets.
Warning:
Never use the food-warmer drawer set at the bottom of the range to store
flammable substances or matters that cannot withstand heat such as:
wood, paper, spray cans, rags, etc.
General Warnings
This electric appliance complies with the following directives:
- 2004/108/EEC (electromagnetic compatibility)
- 89/109/EEC (foodstuffs)
- 2006/95/EEC (low voltage)
Before using the oven for the first time, we suggest to:
• remove the special film covering the oven door glass
(when provided)
• heat the empty oven at max. temperature for 45 minutes
(to remove unpleasant smell and smoke caused by
working residues and by the thermal insulation)
• carefully clean inside the oven with soapy water and rinse it .
• For any repairs always contact an authorised Service Centre and ask for
original spare parts. Repairs by untrained people will void your warranty on this
product.
6
•THIS PRODUCT IS NOT FOR USE IN MARINE CRAFT, CARAVANS OR
MOBILE HOMES.

NO YES
The base element is concealed beneath the bottom of the oven to make the oven easier
to clean and contribute to better access into the oven.
Because the element is concealed beneath the oven the following rules will need to be
observed during cooking to ensure optimum performance from the oven.
DO NOT PLACE ALUMINIUM FOIL OR METAL OBJECTS ON THE BASE OF THE OVEN
DURING COOKING.
Foil or dishes must never be placed on the base of the oven during cooking as the con-
centration of the direct and reflected heat will damage the enamel surface. Provisions of
the warranty do not cover damage resulting from such use.
General Warnings
IMPORTANT NOTICE TO THE USER
7

Instructions for Installation
DIMENSIONS AND INSTALLATION FEATURES
900
600
970 ÷ 980
150 min
600 min
TO FIT THE STABILISING CHAINS
In order to prevent tipping of the appliance it is equipped
with 2 chains for stabilising means and must be installed
and is required for safety reasons.
After the connection to gas and electrical supply is
completed and oven is located in its final position. The
following MUST be done:
The 2 chains are fitted in the upper part of the rear right
and the rear left side. These two chains enable the cooker
to be fixed to the wall
1. The anchor used to attach the chains to the rear wall
must be of a type suitable for the purpose
2. If the appliance is installed between two cupboards, drill
a hole big enough on each side of the cupboards, to allow
the chains to pass through the holes and anchor the chains
within each cupboards
3. If the appliance is installed next to drawers, remove the
drawers, then carry out the procedure described in point 2.
Ensure the anchor does not interfere with the operation of the
drawers. If the cooker is to be installed next to an appliance,
such as a dishwasher, temporarily remove the appliance for
access to fit the stabilising chains.
4. Make sure the fixing to the wall is as close as possible to the
chain anchor point on the cooker and that the chains are
taught to effectively prevent the appliance from tilting.
Important: For a unique situation where the stabilising chains cannot be fitted, please contact
Blanco Technical Department for advice.
When the oven is moved for servicing – THE CHAINS MUST BE RE-ATTACHED by the Technician.
THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITIES FOR DAMAGES TO
PROPERTY OR INJURIES TO PERSONS OR ANIMALS DERIVING FROM INCORRECT
INSTALLATION OR USE OF THE EQUIPMENT SET OUT IN THE MANUAL.
Nominal volume of the oven
101 lt
8

ELECTRICAL CONNECTION
The appliances are provided with a three-pole feeding cable and work with alterna-
te voltage indicated on the “rating plate of the product“ reported at the end of the
instruction manual and on the product. The grounding conductor of the cable is
marked with the colours yellow/green.
CONNECTION OF THE FEEDING CABLE TO THE MAINS
Connect the feeding cable to a plug suitable for the load indicated on the rating plate
of the product. In case of a direct connection to the mains (cable without plug), it is
necessary to insert a suitable omnipolar switch before the appliance, with minimum
opening between contacts of 3 mm (the grounding wire should not be interrupted by
the switch).
Before connecting to the mains, make sure that:
• the electrical counter, the safety valve, the feeding line and the socket are ade-
quate to withstand the maximum load required (see rating plate).
• the supply system is regularly grounded, according to the
regulations in force.
• the socket or the omnipolar switch can easily be reached
after the installation of the oven
• after carrying out the connection to the mains, check that the
supplying cable does not come into contact with parts
subject to heating.
• never use reductions, shunts, adaptors which can cause
overheating or burning.
The manufacturer is not liable for any direct or indirect damage caused by
faulty installation or connection. It is therefore necessary that all installation
and connection operations are carried out by qualified personnel complying
with all applicable laws and regulations.
Instructions for Installation
3x4 mm2
N
L
2
4
5
3
1N
L2
4
5
3
1
5x2,5 mm2
230V or 220-240V 400V 3N or 380-415V 3N
H05RR-F
H05V2V2-F
9

Electrical features
Oven light 2x25 W
Upper heating element 1100 W
Bottom heating element 1500 W
Grill heating element 2600 W
Circular heating element 2600 W
Instructions for Installation
2
3
4
2
750-2200
Plate Rated input
(hot area (W)
dimension mm)
1
2
3
4
Front left
(Ø = 220)
1200
1500-2400
1800
Front right
back left
(Ø = 150)
Central
(180x280)
Back right
(Ø = 180)
n°
1
Cooking top Electrical features
10
Tabla de contenidos
Otros manuales de Estufa de Blanco

Blanco
Blanco BC 75 X Instrucciones de funcionamiento y seguridad

Blanco
Blanco BFD915WX Manual de usuario

Blanco
Blanco BFS120 Guía de instalación

Blanco
Blanco FD9085WX Guía de instalación

Blanco
Blanco BFS95W Guía de instalación

Blanco
Blanco BFD914WX Manual de usuario

Blanco
Blanco BFD9054WX Manual de usuario

















