Black Box MLG-6025DK Manual de usuario
Model: MLG-6025DK
HDMI DOCKING STATION
Output high definition video to TV for iDevices.
- 1 -
Contents
I.
Appearance of Equipment………………………………………………………………..2
II.
Wiring of Equipment………………………………………………………………......2-3
III.
Illustration of Rem
ote Control………………………………………………………....3
IV. Product Introduction………………………….……………………………….…..4
4.1 Features
4.2
Spec cation
4.3
Performance parameters
4.4
Accessories
V.
Functions and Basic Operations……………………………………………………......5
5.1 Compatibility of product
5.2Introductions iPad / iPhone / iPod touch
VI.
Music / network music playback instructions………………………………….......6-7
VII.
Video / network Video playback instructions……………………………..............8-9
VIII.
Photo browse instructions……………………………………………………….........9
IX.
Safety Notices………………………………………………………………………….10
X.
Troubleshooting…………………………………………………………………….10-11
Notice: please take o the protection case of your idevice (iPod touch/iPhone/iPad) before
connecting to the Docking Station.
- 2 -
I.
Appearance of Equipment
1. iPhone / iPad / iPod touch 30 pin connector
2. Adjustable slide (applicable erent models)
3. Receiver
4. Standby Buttons with LED (LED status: blue is power on, red is standby)
5. HDMI Port (Output video up to 720P)
6. YPbPr Port (Output video up to 576P)
7. Audio L/R Output
8. Power Input Interface (5V / 3A)
9. Power Switch
II. Wiring of Equipment
1. Connect Docking and TV with HDMI or YPbPr & Audio L/R cable properly.
2. Connect power adapter.
3. Install the compatible Apple devices on Docking
4. Audio L/R cable can be used to connect the Docking with Stereo Receiver
Connected via HDMI cable
Front View Rear View
- 3 -
Connected via YPbPr Cable & Audio L/R cable
Note: If your equipment is properly connected with the DOCK, the Apple device screen will show this
icon (
(
(
(
(
(
(
(
(
(
(
, see page 5), but there is no output on the TV until the Apple device entering into
Photo/Audio/Video play status.
III. Remote Control Illustration
1. STANDBY: Press to enter standby mode
2. VOL-: Volume down
3. VOL+: Volume up
4. : Up direction key
5. OK: OK key
6. : Fast forward key
7. : Down direction key
8. : Fast backward key
9. : Play & Pause key
10. : Next key
11. : Previous key
12. HD/YUV: Press to switch between HD
and YUV mode
13. MENU: Return MENU key
14. MUTE: Press to mute
Note:
erent operating modes, it’s normal that some keys of dock remote control may not be
available.
b. If operation cannot be done by using remote control, please do it by clicking the compatible
models of machine.
c. MENU button is applicable for iPhone and iPod touch
- 4 -
IV.
Product Introduction
4.1 Features
1. Compatible with iPod Touch, iPhone and iPad.
2. Allow local videos of compatible models and the online video to play on TV, and
support up to 720p video output.
3. Allow local music of compatible models and the Internet music to be output to TV or
stereo system.
4. Allow playing picture slide and pictures with background music.
5. Allow charging the compatible models while playing pictures, music or video, or charging
independently.
6. Equipped with HDMI, YPbPr, and Audio L/R interfaces; supports component output and
HD output; customers can choose the favorite interfaces as they like.
7. Support boot screen in HDMI mode and can play local music in boot screen mode.
4.2 Produ
Product Dimension: 134 * 80 * 30MM
Products Weight: 240G
Input Voltage: AC100-240V
Output Voltage: DC 5V, 3A
Power Consumption: Less than 10W
Output Resolution: Up to 720P
Interface: HDMI, YPbPr, Audio L/R
4.3 Performance Parameters of Product
Adapter: Input: 100-240V 50/60Hz, 0.3A
Output: 5V/3A
Standby Power Consumption: 0.15 W
Load Power Consumption: Max 7.5 W
4.4 Accessories
1. Remote control 2. Adapter 3. User manual 4. YPbPr cable 5. Audio L/R cable
6. HDMI cable (optional)
- 5 -
V. Functions and Basic Operations
5.1 Compatibility of Product
Compatible iPod touch models
Compatible iPhone models
5.2 Basic Operations of iPad / iPhone / iPod touch
If your equipment is properly connected with the DOCK, the screen will show the icon as below.
- 6 -
VI. Music / network music playback instructions
6.1 Online music playback method:
1. For use on iPhone / iPod Touch
a. Connect the HDMI dock to the TV with an
HDMI cable.
Make sure the TV’s input is set to HDMI.
Switch on the main power switch at the back
of the unit beside the HDMI port.
Power on the power button located at the front of the dock.
The Opening Screen will be shown on the TV screen(Figure 1).
Now plug in your idevice to the dock.
b. Click the on your idevice, open the music playlists and choose the song to play back. The
user can operate volume and pause functions remotely after the music has started playing.
NOTICE: Menu button only applies to the iPhone and iPod touch. While the screen of iPhone is on
the song list (Figure 2) , Menu Button can be used to pick Playlists / Artists / Songs / Videos /
More (Figure 4). and arrow on the remote control can be used to browse through the
music. To select a song, press OK on the remote control.
(Figure 1)
(Figure 4)
(Figure 2) (Figure 3)
- 7 -
2. For use on iPad
NOTICE: iPad has limited controls via remote due to software restrictions.
6.2 Network music playback method:
1. Click to turn launch Safari browser. Input the music web address and open the playlist to
select the music (its smoothness depends on network transmission speed, if not uent, you can
replay it after suspended buer.)
NOTICE: After the network music starts playing, Standby/VOL-/VOL+/Mute button is active.
(Figure 5) (Figure 6)
)8erugiF()7erugiF(
- 8 -
VII. Video/ network Video playback instructions:
7.1 Video playback can be selected by the following method:
1. For use on iPhone / iPod Touch
Click and select the video program to play back.
NOTICE:
a. MENU button on the remote only applies to iPhone & iPod Touch. When
the iPhone’s screen is on the video selection menu (Figure 9), the MENU Button can be used to
select the Video list. Select the favorite program though the arrow keys / on the remote
and then press OK.
b. Remote control can be operated from a distance after the network video starts playing,
Standby/VOL+/VOL-/Play/Pause/Mute/Menu/Arrow button is supported.
2. For use on iPad
NOTICE:
a. iPad has limited controls with remote due to software restrictions.
(Figure 9) (Figure 10)
(Figure 11) (Figure 12) (Figure 13)
- 9 -
b. Remote control can be used after the network video starts playing.
Standby/VOL+/VOL-/Play/Pause/Mute button is supported.
7.2 Network video playback method:
Click the , turn to launch the video playlists. Choose your desired video.
NOTICE: Smoothness of the video depends on the network transmission speed, if not uent, you
can replay it after suspended buer.
REMARK: Standby/VOL-/VOL+/Mute button is supported after the video has started playing.
VIII. Photo browse instructions:
The operation method as following:
1. Click on your idevices to select the photos.
2. Choosing slideshow, music will play at the same time, click “start the slides”
3. The background music will stop if you press the Previous / Next button to browse the
pictures. Press PLAY to restart.
NOTICE: Remote control can be operated from a distance after the network video is playing,
Standby/VOL-/VOL+/Previous/Next/Mute/Play/Pause button is supported during playback.
(Figure 14) (Figure 15) (Figure 16)
(Figure 17) (Figure 18)
Tabla de contenidos
Otros manuales de Estación de acoplamiento de Black Box
Black Box
Black Box USB 2.0 Docking Station Manual de usuario
Black Box
Black Box USBC2000-4KDUAL Manual de usuario
Black Box
Black Box IC665A Manual de usuario
Black Box
Black Box USBC2000-4KDUAL Manual de usuario
Black Box
Black Box IC652A Manual de usuario
Black Box
Black Box USBC2000-R2 Manual de usuario
Black Box
Black Box USBC2000 Manual de usuario
