BitFenix 6+6 CONTROLLER Manual de referencia
6+6 Controller Introduction
6+6 Controller
Rated voltage DC12V/DC5V
With 6 ARGB 3Pin 5V sockets, 6 12-volt
fan sockets and a ARGB header connected
to Motherboard
A single ARGB socket can bear 80 LEDs
A single fan socket can withstand 6 12-volt
fans
A total of 60 lighting illumination modes
If you connect the controller to the
Motherboard, long press the switch for
the first time to enter the Motherboard
follow mode and long press the switch
again, the fan will flash white light then
turn off.
If you only use the controller, long press
the switch and the LED will flash white
light then turn off.
This controller compatible with Asus
AURA SYNC, MSI Mystic Light, Gigabyte
RGB Fusion 2.0 and Asrock Poloychrome
SYNC
6+6 Controller
Connect to Gigabyte Motherboard
Addressable RGB 3pin socket
Connect to Fan
Addressable RGB 3pin socket
Connect to Motherboard Addressable RGB 3pin socket
Front RGB switch
SATA power cable (Connect to Power supply )
6+6 Controller
Please remove the 6+6 controller from the case ,
before you connect the ARGB cable or fan.
Remove
ARGB LED connector
Connect to ARGB LED
connector on motherboardor
controller with 3 pin.
Fan power header
Connect to fan header
on motherboard or
controller for power.
6+6 Controller
How to connect ARGB header on 6+6 controller
Each socket support up to 80 LEDs
6+6 Controller
6+6 Controller
Please turn it over and plug in
How to connect fan header on 6+6 controller
Each socket support up to 6 fans
6+6 Controller
How to connect by Motherboard Addressable RGB 3pin socket
If you connect the controller to the Motherboard, long press the switch for the
first time to enter the Motherboard follow mode and long press the switch again,
the fan will flash white light then turn off.
This controller compatible with Asus AURA SYNC, MSI Mystic Light, Gigabyte RGB
Fusion 2.0 and Asrock Poloychrome SYNC
A total of 60 lighting illumination modes
If you connect the controller to the Motherboard, long press
the switch for the first time to enter the Motherboard
follow mode and long press the switch again, the fan will
flash white light then turn off.
If you only use the controller, long press the switch and the
LED will flash white light then turn off.
This controller compatible with Asus AURA SYNC, MSI
Mystic Light, Gigabyte RGB Fusion 2.0 and Asrock
Poloychrome SYNC
Please press LED button to switch the light mode
6+6 Controller
How to daisy chain with 6+6 controller and other Bitfenix ARGB accessaries
Otros manuales de Controladores de BitFenix
