3. Preparation for use
3.1 First time
Before using the Birth Alarm Mobile Multiple for the first time you have to
complete the following steps; this needs to be done once only:
• Unscrew both the Master and the Slave and remove the red label,
which is located against the pole of one of the batteries. The batteries
will now make contact.
• The SIM card may or may not have been supplied; this depends on
the country where you live.
- If it has been supplied, it is located in the SIM holder under the
battery compartment of the MASTER. (see 5.3)
- If this is not the case, you have to purchase your own SIM card
and configure it; once this is done it has to be activated and
inserted into the SIM holder. (see 5.3)
• The Chapter "Installing a new SIM card" (see 6) explains how you can
configure and install a newly bought SIM card.
Once you have carried out these steps for the Master and the Slave , you can
tighten the screws again and continue the configuration process.
3.2 Switching on/off
You can switch on/off your Birth Alarm Mobile Multiple and operate it by
using the back of the supplied special screwdriver.
Complete the following steps to switch the Birth Alarm Mobile Multiple ON:
If you have a good signal with your mobile phone in the stable
or field where your mare is, we recommend that you buy a SIM
card from the same provider.
