BIRD SignalHawk SH-36S-PC Guía de configuración

920-SHPC-REF Rev A www.birdrf.com (866) 695-4569

General Start-Up Instructions

1. To turn SignalHawk on, press Power switch.

2. Launch the SignalHawk program on the PC.

3. Select the unit from the device list if more than one unit is in operation.

4. Select the desired measurement and press Enter or double click it.

5. Press Setup then Recall Default Setup.

Connecting a PC SignalHawk

Note: PC SignalHawk can be used in any orientation.

1. Connect PC SignalHawk to a PC using the supplied USB cable.

Note: The 'USB Host Power' LED will illuminate when host port is active

and has power. It is not an indication of proper USB connectivity to the

host. Refer to software installation instructions for how to address the PC

SignalHawk from the host.

2. Turn Power on.

3. Select the unit from the DSP Device List, if necessary.

4. Connect RF signal.

5. Connect a TTL trigger source to the BNC connector, if necessary.

Connecting to a Rack Mount SignalHawk Locally via USB

Connection

1. Connect the Rack Mount SignalHawk unit to the computer USB port using the sup-

plied USB cable.

2. Turn Power on.

3. Launch the SignalHawk program.

4. Select the unit from the DSP Device List, if necessary.

Connecting a Rack Mount SignalHawk Remotely via LAN/WAN

1. Connect the SignalHawk to a local area network.

Note: The Rack-Mount SignalHawk provides the following

connections to a network:

• 10/100 auto sensing RJ45 Ethernet connector

• Half and full duplex support

• IP address: 192.168.1.10

• Subnet Mask: 255.255.255.0

2. Launch Remote Desktop on a client PC running TCP/IP protocol.

SignalHawk

PC Based Spectrum Analyzer

Rack Mount Spectrum Analyzer

Models SH-36S-PC & SH-36S-RM

100 kHz to 3.6 GHz

CAUTION

Avoid installing the SignalHawk near equipment that exhausts or radiates excessive

heat (such as power amplifiers or DC power supplies). Proper ventilation should always

be considered as part of the installation location.

920-SHPC-REF Rev A www.birdrf.com (866) 695-4569

Rack Mount SignalHawk Connection Diagram

Spectrum Analyzer Start-Up Instructions

1. Connect the input signal or antenna to the RF in test port.

Note: Maximum input is +20 dBm (100 mW).

2. Press in order: Freq & Span, Center Freq, enter the value.

3. Repeat for Freq Span.

4. Press Amp &Trace then press Autoscale OR adjust Reference and Scale man-

ually for preferred viewing.

5. Lower the noise floor, if necessary, by pressing Preamp On OR BW & Sweep then

Resolution BW, then press the down arrow key to narrow the RBW.

6. Repeat Steps 3 and 4 as required.

General Instructions

To mark the signal peak, click Mark & Limit, Marker On,

and Marker to Max Peak.

To save the trace, click File & Help, Quick Save Trace

OR Label & Save Trace.

To save setup, click Setup then Quick Save Setup

OR Label & Save Setup.

To recall a setup click Setup, click Recall Setup or Enter.

For additional information,

Refer to the Operations Manual and On-board Help

RF MODULE

Mini ITX PC

USB

ETHERNET

Local Broadcast

Site

WAN/LAN

Rack-Mount

Signal Hawk

Local PC

Laptop

Remote PC

ETHERNET

HUB

ROUTER

Pass-thru connection:

allows convenient

access to hub through

front panel

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Instrumento de medición de BIRD

BIRD

BIRD Thruline 43 Manual de usuario

BIRD

BIRD Thruline 43 Manual de usuario

BIRD

BIRD TERMLINE 8141 Manual de usuario

BIRD

BIRD O2 Manual de usuario

BIRD

BIRD SignalHawk SH-36S-RM Manual de usuario

BIRD

BIRD 5000-XT Manual de usuario

BIRD

BIRD THRULINE 4450 Hoja de datos

BIRD

BIRD Termaline 8930 Series Manual de usuario

BIRD

BIRD Wattcher 3127A Manual de usuario

BIRD

BIRD Thruline 4410A500 Manual de usuario

BIRD

BIRD Digital Power Meter Display Manual de usuario

BIRD

BIRD THRULINE 43 Series Manual de usuario

BIRD

BIRD Termaline 8890SC Series Manual de usuario

BIRD

BIRD 4042 Manual de usuario

BIRD

BIRD 4391A Manual de usuario

BIRD

BIRD TERMALINE 8135 Manual de usuario

BIRD

BIRD Thruline 4410 series Manual de usuario

BIRD

BIRD SignalHawk SH-60S-TC Manual de usuario

BIRD

BIRD 4422 Manual de usuario

BIRD

BIRD THRULINE 4027F series Manual de usuario

BIRD

BIRD 4421-250 Manual de usuario

BIRD

BIRD SiteHawk SK-6000 Manual de usuario

BIRD

BIRD 4421A Manual de usuario

BIRD

BIRD 5000-XT Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario