Biostar BICHT-PBA Manual de usuario

FCC Informaon and Copyright

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful

interference in a residenal installaon. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to

radio communicaons. There is no guarantee that interference will not occur in a parcular installaon.

The vendor makes no representaons or warranes with respect to the contents here and specially disclaims

any implied warranes of merchantability or tness for any purpose. Further the vendor reserves the right

to revise this publicaon and to make changes to the contents here without obligaon to nofy any party

beforehand.

Duplicaon of this publicaon, in part or in whole, is not allowed without rst obtaining the vendor’s approval

in wring.

The content of this user’s manual is subject to be changed without noce and we will not be responsible for

any mistakes found in this user’s manual. All the brand and product names are trademarks of their respecve

companies.

Dichiarazione di conformità sinteca

Ai sensi dell’art. 2 comma 3 del D.M. 275 del

30/10/2002

Si dichiara che questo prodoo è conforme

alle normave vigen e soddisfa i requisi

essenziali richies dalle direve

2004/108/CE, 2006/95/CE e 1999/05/CE

quando ad esso applicabili

Short Declaraon of conformity

We declare this product is complying with the

laws in force and meeng all the essenal

requirements as specied by the direcves

2004/108/CE, 2006/95/CE and 1999/05/CE

whenever these laws may be applied

2 | Table Of Contents

BIBD-PBA User’s Manual

Table Of Contents

FCC Informaon and Copyright �� 1

Chapter 1: Introducon�� 3

1.1 Before You Start .....................................................................................................................................3

1.2 Specicaons .........................................................................................................................................4

1.3 Rear / Front Panel Connectors ...............................................................................................................5

1.4 Motherboard Layout..............................................................................................................................6

Chapter 2: Hardware installaon�� 7

2.1 Central Processing Unit (CPU)................................................................................................................7

2.2 Jumpers / Slot / Headers / Connectors ..................................................................................................7

Chapter 3: BIOS Setup�� 11

3.1 Main Menu ..........................................................................................................................................12

3.2 Advanced Menu...................................................................................................................................13

3.3 Chipset Menu.......................................................................................................................................19

3.4 Security Menu......................................................................................................................................29

3.5 Boot Menu ...........................................................................................................................................31

3.6 Exit Menu.............................................................................................................................................33

Chapter 1: Introducon | 3

BICHT-PBA User’s Manual

Chapter 1: Introducon

1.1 Before You Start

Thank you for choosing our product. Before you start installing the motherboard, please make sure you

follow the instrucons below:

• Prepare a dry and stable working environment with sucient lighng.

• Always disconnect the computer from power outlet before operaon.

• Before you take the motherboard out from an-stac bag, ground yourself properly by touching

any safely grounded appliance, or use grounded wrist strap to remove the stac charge.

• Avoid touching the components on motherboard or the rear side of the board unless necessary.

Hold the board on the edge, do not try to bend or ex the board.

• Do not leave any unfastened small parts inside the case aer installaon. Loose parts will cause

short circuits which may damage the equipment.

• Keep the computer from dangerous area, such as heat source, humid air and water.

• The operang temperatures of the computer should be 0 to 45 degrees Celsius.

• To avoid injury, be careful of:

Sharp pins on headers and connectors

Rough edges and sharp corners on the chassis

Damage to wires that could cause a short circuit

Note

»The package contents may be dierent due to the sales region or models in which it was sold. For more

informaon about the standard package in your region, please contact your dealer or sales representave.

4 | Chapter 1: Introducon

BIBD-PBA User’s Manual

1.2 Specifications

CPU Intel® Atom™ Quad core x5-Z8350 Processor (2M Cache, up to 1.92 GHz)

Graphic

Integrated Intel® HD Graphics engine

Dual independent displays (Extended mode) as below two:

-- Integrated DVI-D

-- Integrated HDMI

Main Memory DDR3L 1600MHz SO-DIMM / 2GB/4GB, single channel ,1.35V

*Registered DIMM or ECC DIMM is not supported

Storage 1x Built-in 32/64GB eMMC Flash Onboard

1x Built-in Micro SD connector

Networking

LAN:

Realtek RTL8152B

10 / 100 Mb/s auto negoaon, Half / Full duplex capability

Wireless:

AMPAK AP6212 SIP Module (BCM43438) support 802.11 b/g/n, BT V4.0(colay AP6255, BCM43455)

Sound Codec Realtek Codec ALC5645, supports Line-out/Mic-in

USB

Intel® Atom™ x5-Z8350 Processor supports 3xUSB 2.0 Port and USB 3.0 OTG:

3x Super Speed (SS) ports (Backward Compable of USB 2.0 HS/FS/LS)

Built-in 1x GL854 (1 to 7 port USB 2.0 Hub IC):

1x USB 3.0 OTG on the front/rear IO Type A connector(with 5V standby and The current is 900mA)

3x USB 2.0 Bus on the front/Rear IO Type A connector(with 5V and The current is 500mA)

1x USB 2.0 Bus internal header 2x5 pins 2.54mm(with 5V and The current is 500mA)

1x USB 2.0 bus for M.2 socket (3G Module) from SOC

1x USB 2.0 bus for S/IC CHIP 10/100M LAN/RTL8152B for LAN Port

1x USB 2.0 bus for USB2.0 to 4 x UART IC(Fintek F81534)

Rear Panel I/O

1x DC12V Jack connector

1x DVI-I connector (Digital signal only)

1x HDMI Type A connector

2x USB 2.0 connector (with 5V and The current is 500mA)

1x RJ45 LAN connector (10/100 Mb/s)

1x micro SD connector

Front Panel I/O

1x USB 3.0 connector (with 5V standby and The current is 900mA)

1x USB 2.0 connector(with 5V standby and The current is 500mA)

2x Audio Jack(Line-out & Mic-in)

1x Power Buon(co-lay header)

1x 25pin FPC connector Integrated MIPI CSI 8M CAMERA connector

Internal I/O

1x M.2 B KEY socket for 3G Module

1x M.2 E KEY socket for 802.11b/g/n WIFI /BT Module

1x SIM connector

1x USB 2.0 Bus internal header 2x5 pins 2.54mm(with 5V and The current is 500mA)

1x 1*3 pins header, Clear CMOS Jumper seng

1x 1*2 pins header, Power buon header

2x 1*2 pins wafer for Codec AL5645 class D 2.5Wa/Channel Amp Speaker

1x Antenna connector

4 x 2*5 pins wafer,COM Port

3x 1*3 pins COM port mode selecon

Board Size 105 mm (W) x 146 mm (L), 3.5” SBC

Operaon Temperature 0°C ~ 40°C

Storage Temperature -40°C ~ 60°C

Relave Humidity 10% ~ 90% (non-condensing)

Cercaon CE / FCC Pre-scan

OS Driver Support Windows 10 (64 bits) OS , Ubuntu 16.04

RoHS Compliant Yes

Chapter 1: Introducon | 5

BICHT-PBA User’s Manual

1.3 Rear / Front Panel Connectors

Rear

Front

J1: DC-12V IN Power Jack

6 | Chapter 1: Introducon

BIBD-PBA User’s Manual

1.4 Motherboard Layout

» represents the 1st pin.

Chapter 2: Hardware installaon | 7

BICHT-PBA User’s Manual

Chapter 2: Hardware installaon

2.1 Central Processing Unit (CPU)

The mainboard includes an Intel® Celeron processor, and a cooler has been installed to provide sucient

cooling.

2.2 Jumpers / Slot / Headers / Connectors

M2_2: Half-size mPCIe Slot

SIM1: SIM card socket

8 | Chapter 2: Hardware installaon

BIBD-PBA User’s Manual

Jumper Seng

The illustraon shows how to set up jumpers. When the jumper cap is placed on pins, the jumper is “close”,

if not, that means the jumper is “open”.

Pin opened Pin closed Pin 1-2 closed

JCMOS1: Clear CMOS Jumper

Placing the jumper on pin2-3 allows user to restore the BIOS safe seng and the CMOS data. Please

carefully follow the procedures to avoid damaging the motherboard.

Pin 1-2 Close: Normal Operaon (Default)

Pin 2-3 Close: Clear CMOS data

Clear CMOS Procedures:

1. Remove AC power line.

2. Set the jumper to “Pin 2-3 close”.

3. Wait for ve seconds.

4. Set the jumper to “Pin 1-2 close”.

5. Power on the AC.

6. Reset your desired password or clear the CMOS data.

JM0 / JM1 / JM2: COM port mode selecon

JM0: Pin 1-2 Close / JM1: Pin 1-2 Close / JM2: Pin 2-3 Close:

RS232(Default)

JM0: Pin 1-2 Close / JM1: Pin 1-2 Close / JM2: Pin 1-2 Close:

RS422

JM0: Pin 1-2 Close / JM1: Pin 2-3 Close / JM2: Pin 1-2 Close:

RS485

Chapter 2: Hardware installaon | 9

BICHT-PBA User’s Manual

F_USB2: USB 2.0 Connectors

This header allows you to connect addional USB 2.0 port.

Pin Assignment

1USB_VCC

2 USB_VCC

3 DM2

4 DM1

5DP2

6DP1

7 GND

8 GND

JSPK1/2: Audio Connector

Le Speaker (JSPK1)

Pin Assignment

1 SPKRP

2SPKPN

Right Speaker (JSPK2)

Pin Assignment

1SPKLP

2 SPKLN

JCOM1/2/3/4: COM Port Connector

Pin Assignment Pin Assignment

1-PDCD 2 PSIN

3 PSOUT 3 -PDTR

5GND 6 -PDSR

7 -PRTS 8 -PCTS

9RI 10 NA

10 | Chapter 2: Hardware installaon

BIBD-PBA User’s Manual

PWRBTN: Power Buon

Pin Assignment

1GND

2PWRBTN

ANT4: WIFI+BT Antenna

Tabla de contenidos

Otros manuales de Placa madre de Biostar

Biostar

Biostar M7SXF Manual de usuario

Biostar

Biostar H170GTN Manual de usuario

Biostar

Biostar H61MLB Manual de usuario

Biostar

Biostar A55MLV2 Manual de usuario

Biostar

Biostar U8068 Manual de usuario

Biostar

Biostar A740G M2L PLUS - BIOS 2 Manual de usuario

Biostar

Biostar G31-M7 Manual

Biostar

Biostar M6TZA Manual de usuario

Biostar

Biostar TP67XE - BIOS Manual de usuario

Biostar

Biostar MCP6P3 Manual de usuario

Biostar

Biostar A75MG Manual de usuario

Biostar

Biostar M6VLB Manual de usuario

Biostar

Biostar K8M890-M7 PCI-E Manual de usuario

Biostar

Biostar A55MLV Guía del usuario

Biostar

Biostar B550GTQ Manual de usuario

Biostar

Biostar M7 VKG Manual de usuario

Biostar

Biostar 945GC-M7 TE Guía del usuario

Biostar

Biostar H77MU3 Manual de usuario

Biostar

Biostar M7 VKG Manual de usuario

Biostar

Biostar EIH11-SWA Manual de usuario

Biostar

Biostar TFORCE 550 SE Manual de usuario

Biostar

Biostar TA890FXE - BIOS Guía del usuario

Biostar

Biostar K8VGA-M Manual de usuario

Biostar

Biostar A880GB - BIOS Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Manual de usuario