Biostar BIH61-IHP Manual de usuario
FCC Warning
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instrucon
manual, may cause harmful interference to radio communicaons. Operaon of this equipment in a
residenal area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
2 | Table Of Contents
BIH61-IHP User’s Manual
Table Of Contents
FCC Warning ����������������������������������������������������������������������������������������������������������� 1
Chapter 1: Introducon������������������������������������������������������������������������������������������� 3
1.1 Before You Start .....................................................................................................................................3
1.2 Specicaons .........................................................................................................................................4
1.3 Rear Panel Connectors...........................................................................................................................6
1.4 Motherboard Layout..............................................................................................................................7
Chapter 2: Hardware installaon����������������������������������������������������������������������������� 9
2.1 Install Central Processing Unit (CPU) .....................................................................................................9
2.2 Install a Heatsink ..................................................................................................................................11
2.3 Fan Headers .........................................................................................................................................12
2.4 Installing Memory Module...................................................................................................................13
2.5 Expansion Slots ....................................................................................................................................14
2.6 Jumper & Switch Seng ......................................................................................................................16
2.7 Headers & Connectors .........................................................................................................................18
Chapter 1: Introducon | 3
BIH61-IHP User’s Manual
Chapter 1: Introducon
1�1 Before You Start
Thank you for choosing our product. Before you start installing the motherboard, please make sure you
follow the instrucons below:
• Prepare a dry and stable working environment with sucient lighng.
• Always disconnect the computer from power outlet before operaon.
• Before you take the motherboard out from an-stac bag, ground yourself properly by touching
any safely grounded appliance, or use grounded wrist strap to remove the stac charge.
• Avoid touching the components on motherboard or the rear side of the board unless necessary.
Hold the board on the edge, do not try to bend or ex the board.
• Do not leave any unfastened small parts inside the case aer installaon. Loose parts will cause
short circuits which may damage the equipment.
• Keep the computer from dangerous area, such as heat source, humid air and water.
• The operang temperatures of the computer should be 0 to 45 degrees Celsius.
• To avoid injury, be careful of:
Sharp pins on headers and connectors
Rough edges and sharp corners on the chassis
Damage to wires that could cause a short circuit
Note
»
»The package contents may be dierent due to the sales region or models in which it was sold. For more
informaon about the standard package in your region, please contact your dealer or sales representave.
4 | Chapter 1: Introducon
BIH61-IHP User’s Manual
1�2 Specifications
Dimensions 170 x 170 x 1.6 mm
Processor Intel® Alder lake s for LGA1700 Socket CPU (Max TDP at 65W)
Core Logic (PCH) Intel® H610
Chipsets
EDP to LVDS : RTD2136
DDI to VGA : RTD2166
LAN controller: Intel I225V, I219V
Audio Codec: ALC897
Audio Amplier: ALC105
Super IO : F81966D-I
System Memory 2 x 260-pin socket support DDR4 3200Mhz SO-DIMM, up to 64 GB
Graphic
Intel® Integrated Graphics
2xHDMI
Support 2x Horizontal HDMI
1. Support HDMI 1.4b
VGA
2. VGA: RTD2166
3. Support 2x8 pin wafer
eDP/LVDS
1. Chipset: RTD2136
2. Support LVDS dual channels, co-lay eDP (by BOM opon)
3. 2x3 Pin header for LCD voltage select
4. 1x1*20 pin LVDS connector, 1x2*20pin eDP connector (by BOM opon)
Ethernet
Support 2 x GbE LAN
(1) 1xI225V, 1x I219V GbE LAN
(2) Support PXE boot form LAN, wake on LAN
SATA
Support 3x SATAIII
(1) 1x SATAIII 7pin connector with 1x4 Power Wafer
(2) 1 x full type PCI Express mini card with PCIex1, USB2.0 , SATA (support PCIE+USB or USB+SATA)
(3) 1x SATA3 for M.2 B Key
Universal Serial Bus
3 x USB3.1
(1) 2x USB3.1 for 1x stack connector on IO.
(2) 1 x M.2 key B type 2242/3042/3052 with PCIEx2, SATA3.0 (SATA3), USB3.1 (support SATA+USB or
USB3+PCIE)
7 x USB2.0
(1) 2x USB2.0 for 1x stack connector on IO.
(2) 1x USB 2.0 + 1 x PCIex1 + SATA3 signal for Mini-PCIe
(3) 1x M.2 key E type 2230 with PCIEx1 and USB2.0
(4) 1 x USB2.0 for 1x 1*4 pin wafer
(5) 2 x USB2.0 for 1x2*5 pin wafer
Super IO Controller : F81966D-1
Support 4x COM Port, DIO
Serial Port
Support 4xCOM port, dene as below,
1 x RS232/422/485 (COM1)
(1) DB9 connector on main I/O
(2) Mode selecon by BIOS control.
(3) Support RI/5/12V, jumper selecon, default RI.
1x 2*3 PIN header
3x RS232 (COM2~COM4)
(1) 3 x 2*5 Header
Expansion Slot
(1) 1x PCIE Gen3 X16 slot
(2) 1x USB 2.0 + 1 x PCIex1 + SATA3 signal for Mini-PCIe
(3) 1 x M.2 key B type 2242/3042/3052 with PCIEx2, SATA3.0 (SATA3), USB3.1 (support SATA+USB or
USB3+PCIE)
(4) 1 x M.2 key E type 2230 with PCIEx1 and USB2.0, support CNVI funcon.
(5) 1x SIM slot, colay MINIPCIE and M.2 Key B slot (by BOM opon)
Audio
Audio Codec: ALC897
(1) 1 x Audio jack, support Line-out on Rear I/O.)
(2) 1x 2*5-pin wafer box for Mic-in, Line-In, Audio-Out
Note: “Audio-Out” can select Line out or speaker out by 0ohm.
If ALC105 SMT, then Audio-out is support speaker out, else if ALC105 is non-SMT, then support Line-out
funcon.
Chapter 1: Introducon | 5
BIH61-IHP User’s Manual
Digital I/O 1 x 8-Bit DIO header
1 x 2*5 Pin header
Front Panel 1 x 2*6 Pin header
TPM
TPM 2.0 chip onboard
TPM IC: SLB9670
Non-SMT by default (BOM oponal)
Indicator 1x Green LED for 5V standby power indicator
Buzzer 1 x Buzzer
Hardware monitor CPU/System temperature, Voltage monitoring for VCC, 3.3, 5, 12V...
Watchdog Timer Reset; 1 sec.~255 min. and 1 sec. or 1 min. /step
RTC Internal RTC, supports Wake On RTC
EuP Support
Power Input DC-IN 12~24V
ATX 4P connector
Edge IO
1x DC 12~24V Jack
2x HDMI connector
1x Dual-Stack USB3.1 connectors
2x RJ45 connectors, support GbE.
1x DB9 COM connector
1 x Line-out Audio Jack
1x Dual-Stack USB2.0 connectors
Onboard pin-header
Expansion slots
2x 260-pin DDR4 sockets
1 x M.2 key B type
1 x PCIex16 Slot
1x M.2 key E slot
1x Mini-PCIe Slot
SATA
1x SATAIII 7pin connector with 1x4 pin power.
Display
1x 2*20 Pin connector for eDP
1x 2*20 Pin connector for LVDS
1x 2*3 Pin header for LCD voltage select
1x1*8 pin header for Inverter.
1x 2*8 pin header, support VGA
Audio
1x 2*5-pin wafer box for Mic-in, Line-In, Audio-Out
1 x Buzzer
USB
1 x USB2.0 for 1x 1*4 pin wafer
Power
1x ATX 4PIN Connector
Serial Port
3x 2*5 pin header for RS232
FAN
1x 1*4 pin-header for CPU fan
1x 1*3 pin-header for SYSTEM fan
Others
1x Green LED for 5V standby power indicator
1x1*3 pin header clear CMOS
1x 1*3 pin header for AT/ATX power select jumper
1x SIM slot
1 x 2*5 pin 2mm pitch 8-bit DIO pin header
1 x 2*6 front panel pin header
O.S. support Windows 10 Pro
Linux Ubuntu 20.04
ESD/ EMI Contact with 4Kv, Air with 8Kv
EMI class A
Operaon Temp.. 0ºC ~ 60ºC Humidity : 5% ~ 90%
Storage Temp. -10ºC ~ 70ºC Humidity : 5% ~ 90%
6 | Chapter 1: Introducon
BIH61-IHP User’s Manual
1�3 Rear Panel Connectors
CN1: COM Port (DB9) Mode 001 000 010
Pin Dene RS-232
(3T/5R)
RS-422
(1T/1R Full
Duplex)
RS-485
(1T/1R TX Enable
Low Acve)
1COM1C_DCD TX(B) (R(B) / T(B))
2COM1C_RXD TX(A) (R(A) / T(A))
3COM1C_TXD RX(A) NC
4COM1C_DTR RX(B) NC
5GND GND GND
6COM1C_DSR NC NC
7COM1C_RTS NC NC
8COM1C_CTS NC NC
9COM1C_RI NC NC
Chapter 1: Introducon | 7
BIH61-IHP User’s Manual
1�4 Motherboard Layout
»
» represents the 1st pin.
8 | Chapter 1: Introducon
BIH61-IHP User’s Manual
Back View
Chapter 2: Hardware installaon | 9
BIH61-IHP User’s Manual
Chapter 2: Hardware installaon
2�1 Install Central Processing Unit (CPU)
Step 1: Locate the CPU socket on the motherboard
Note
»
»Remove pin cap before installaon, and make good preservaon for future use. When the CPU is removed, cover
the pin cap on the empty socket to ensure pin legs won’t be damaged.
»
»The motherboard might equip with two dierent types of pin cap. Please refer below instrucon to remove the
pin cap.
Step 2: Pull the socket locking lever out from the socket and then raise the lever up.
Step 3: Remove the Pin Cap.
10 | Chapter 2: Hardware installaon
BIH61-IHP User’s Manual
Step 4: Hold processor with your thumb and index ngers, oriented as shown. Align the notches with the
socket. Lower the processor straight down without lng or sliding the processor in the socket.
Step 5: Hold the CPU down rmly, and then lower the lever to locked posion to complete the installaon.
Note
»
»Ensure that you install the correct CPU designed for LGA1200 socket.
»
»The CPU ts only in one correct orientaon. Do not force the CPU into the socket to prevent damaging the CPU.
Tabla de contenidos
Otros manuales de Hardware de computadora de Biostar
Manuales populares de Hardware de computadora de otras marcas
EMC2
EMC2 VNX Series Manual del propietario
Panasonic
Panasonic DV0PM20105 Manual de usuario
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manual de usuario
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manual de usuario
Raidon
Raidon iT2300 Manual de usuario
National Instruments
National Instruments PXI-8186 Manual de usuario
