ASSEMBLY INSTRUCTIONS
STEP 1
For easiest assembly, do not connect TOP POLES (C), MIDDLE
POLES (B), and BOTTOM POLES (A) until instructed. Once
connected, these will be posts for the rack.
Note that each POLE (A+B+C) has slight horizontal line
indentations at 1” intervals. Each SLIP SLEEVE (E) has raised
horizontal lines inside designed to lock them in place on
POLE (A+B+C).
On BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (E) at
desired height no higher than 3rd indentation from bottom.
Please make sure arrow faces up and word “TOP” is right
side up.
Slide pair of SLIP SLEEVES (E) until you hear a click to confirm
the pair is locked onto BOTTOM POLE (A). Do this for each
BOTTOM POLE (A) and make sure height is identical for each
BOTTOM POLE (A). Do NOT place more than one pair on
each pole at a time.
Note: There will be a very small gap in-between two locked SLIP SLEEVES (E)—this is normal.
STEP 2
Place SHELF (D) on its side and slide each BOTTOM POLES
(A) through each corner cylinder on SHELF (D). Make sure
SHELF (D) corner cylinders are positioned over SLIP
SLEEVES (E).
Stand the unit upright.
Note:
•Level side of SHELF (D) is TOP side (TRINITY logo on
corner cylinders should be right-side up.)
•Use a rubber mallet, if needed, to secure SHELF (D).
© 2021 TRINITY - 800.985.5506 2
