Beyerdynamic Unite CC-24P Manual de usuario
UNITE CC 24P
CHARGING CASE
LADEKOFFER
QUICK START GUIDE
KURZANLEITUNG
Unite CC-24P – Charging Case
4
The Unite CC-24P charging case belongs to the wireless Unite system from beyerdynamic. For detailed descriptions of the
use, please refer to the operating instructions for the entire system, which you can download from the internet at:
www.beyerdynamic.com/unite
1. Sa ety instructions
General
• READ the operating instructions.
• KEEP the operating instructions.
• HEED all warnings.
• FOLLOW all instructions.
Disclaimer
• beyerdynamic mbH & Co. K will not be liable if any damage, injury or accident occurs due to negligent, incorrect or
inappropriate operation of the product.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this device near water.
6. Clean only with dry cloth.
The lightning flash within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous
voltage within the device that may be sufficient enough to constitute a risk of electric shock to users.
The exclamation mark within an equilateral triangle is intended to alert the user to the presence of important operating
and maintenance instructions in the literature accompanying the product.
english
Unite CC-24P – Charging Case 5
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other device (including amplifiers) that
produce heat.
9. For safety purposes do not make any changes to the polarized or grounding type plug. A polarized plug has two
contacts with one wider than the other. A grounding type plug has two contacts and a third grounding prong. The wide
contact or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord by not walking or standing on it or pinching, this is considered for plugs especially where they
exit from the device.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the device. When a
cart is used, use caution when moving the cart/device combination to avoid injury from tipping over.
13. Unplug this device during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged in any way,
such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the device, the device
has been exposed to rain or moisture, does not operate normally, or has been dropped.
Location
• The equipment must be set up so that the mains switch, mains plug and all connections on the rear of the device are
easily accessible.
• If you transport the equipment to another location take care to ensure that it is adequately secured and can never be
damaged by being dropped or by impacts on the equipment.
Fire hazard
• Never place naked flames (e.g. candles) near the equipment.
Unite CC-24P – Charging Case
6
Humidity / heat sources
• Never expose the equipment to rain or a high level of humidity. For this reason do not install it in the immediate vicinity
of swimming pools, showers, damp basement rooms or other areas with unusually high atmospheric humidity.
• Never place objects containing liquid (e.g. vases or drinking glasses) on the equipment. Liquids in the equipment could
cause a short circuit.
• Do not install near any heat sources such as radiators, heat registers, stoves or other device (including amplifiers) that
produce heat.
Connection
• The equipment must be connected to a mains socket that has an earth contact.
• Protect the power cord by not walking or standing on it or pinching, this is considered for plugs especially where they exit
from the device.
• Lay all connection cables so that they do not present a trip hazard.
• Whenever working on the equipment switch off all inputs and outputs to the power supply.
• Check whether the connection figures comply with the existing mains supply. Serious damage could occur due to
connecting the system to the wrong power supply. An incorrect mains voltage could damage the equipment or cause an
electric shock.
• Please note that different operating voltages require the use of different types of power cable and plugs.
Please refer to the following table:
• If the equipment causes a blown fuse or a short circuit, disconnect it from the mains and have it checked and repaired.
• Do not hold the mains cable with wet hands. There must be no water or dust on the contact pins. In both cases you could
receive an electric shock.
Voltage Power plug according to standard
110 - 125 V UL817 and CSA C 22.2 no. 42.
220 - 230 V CEE 7 page VII, SR section 107-2-D1/IEC 83 page C4.
240 V BS 1363 (1984): “Specification for 13A fused plugs and switched and un-switched socket outlets.”
english
Unite CC-24P – Charging Case 7
• The mains cable must be firmly connected. If it is loose there is a fire hazard.
• Always pull out the mains cable from the mains and/or from the equipment by the plug – never by the cable. The cable
could be damaged and cause an electric shock or fire.
• Do not use the equipment if the mains plug is damaged.
• If you connect defective or unsuitable accessories, the equipment could be damaged. Only use connection cables
available from or recommended by beyerdynamic.
Switching o
• When switching off the device, also disconnect the power plug from the power socket. Make sure that you do not pull on
the cable, but on the power plug.
Ventilation
• Do not insert objects into the ventilation grilles or other openings. You could damage the equipment and/or injure your-
self.
Maintenance
• Only clean the equipment with a slightly damp or dry cloth. Never use solvents as these damage the surface.
Trouble shooting and servicing
• Never open the device yourself. You could receive an electric shock. There are no user-serviceable parts inside.
• Leave all service work to authorised expert personnel.
Charging
• A completely new battery may need to be charged and discharged several times before it has reached its full change
capacity.
• Do not throw used batteries in the household waste, but hand them over to the local collection points.
• High ambient temperatures during charging (> +40 °C) affect the efficiency of the charging process and the lifetime of
the rechargeable battery.
Unite CC-24P – Charging Case
8
Disposal
This symbol on the product, in the instructions or on the packaging means that your electrical and electronic
equipment should be disposed at the end of its life separately from your household waste. There are separate
collection systems for recycling in the EU. For more information, please contact the local authority or your
retailer where you purchased the product.
Battery disposal
This symbol means that according to local laws and regulations your product and/or its battery shall be disposed
of separately from household waste. When this product reaches its end of life, take it to a collection point
designated by local authorities. The separate collection and recycling of your product and/or its battery at the
time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects
human health and the environment.
• Old batteries may contain substances that are harmful to your health and environment.
• Dispose used batteries always according to the applicable disposal regulations. Please do not throw used
battery packs into the fire (danger of explosion) or your household rubbish, take them to your local collection
points. The return is free and required by law. Please dispose discharged batteries only.
• All batteries are recycled to reclaim valuable material such as iron, zinc or nickel.
2. Supplied accessories
Power cable
english
Unite CC-24P – Charging Case 9
3. Controls and indicators
Top view
Button for initiating the
pairing process or clearing
stored pairing information
in the charger
Status indicator light for
pairing status
Switch for “Pair & Charge”
or “Charge only”
Charging modules with
4 charging compartments
each
Slots for more optional
charging modules or one
optional charging module
and one optional compart-
ment for storing the
Unite TH handheld
transmitter
Pair/Reset
Status
• Pair & Charge
• Charge only
Pair/Reset
Status
• Pair & Charge
• Charge only
Unite CC-24P – Charging Case
10
Rear view
Reset button
Ethernet connection
USB connection
Mains connection
Fuse
On-off switch
Tabla de contenidos
Idiomas:
Otros manuales de Cargador de baterías de Beyerdynamic
Beyerdynamic
Beyerdynamic WA-CDb Manual de usuario
Beyerdynamic
Beyerdynamic SLG 300 H Manual de usuario
Beyerdynamic
Beyerdynamic Synexis SG 24 Guía de configuración
Beyerdynamic
Beyerdynamic LG 30 Manual de usuario
Beyerdynamic
Beyerdynamic Synexis C30 Manual de usuario
Beyerdynamic
Beyerdynamic UNITE CDD-8/4 Manual de usuario
Beyerdynamic
Beyerdynamic SLG 900 Manual de usuario
Beyerdynamic
Beyerdynamic UNITE CC Series Manual de usuario
