Play music
Insert a compact flash facing the label side toward
you until you hear a clicking sound.
Press to turn on.
Press to play.
Basic operation
Volume cannot be controlled when using
an after market digital processor.
(When selection is D for position setting)
Volume Keep pushing for continuous
control.
Stop and pause
Press again to play from where
you left off.
Pause Press while playing for pause.
Push for play from the beginn-
ing of song you stopped at.
Stop Press for stop.
Press and hold until where you
want to listen to and release .
Select songs, Fast-forward, Rewind
･Fast-forward to the next song.
Press once.
･Restart the playing song.
Press once.
･Fast-forward a song.
Press and hold until where you
want to listen to and release .
･Rewind a song.
Please read all instructions in this manual before attempting operation and keep it handy for future eferences.
We are not responsible for damage or any malfunctions caused by not following the instructions.
■This unit is for vehicles with a 12-volt battery and negative This unit is for vehicles with a 12-volt battery and negative
grounding.grounding.
Before installing it in a recreational vehicle, truck or bus, check the
battery voltage.
■To prevent an electric shock or short-circuit during connectionTo prevent an electric shock or short-circuit during connection
and installation, be sure to disconnect the negative (-) terminaland installation, be sure to disconnect the negative (-) terminal
of the battery beforehand.of the battery beforehand.
■DO NOT route wires where they will get hot, especially in DO NOT route wires where they will get hot, especially in
the engine room or where the heater will blow over them. the engine room or where the heater will blow over them.
If the insulation heats up, it may become damaged, resulting in a
short-circuit through the vehicle body.
■DO NOT install unit where it may obstruct driver's sight or DO NOT install unit where it may obstruct driver's sight or
cause possible injury to passengers.cause possible injury to passengers.
■DO NOT allow installation to interfere with normal vehicle DO NOT allow installation to interfere with normal vehicle
operations.operations.
Make sure that wires will not interfere with moving parts of the vehicle,
such as the gearshift, handbrake or seat sliding mechanism.
■DO NOT connect the ground wire to the bolts and nuts of DO NOT connect the ground wire to the bolts and nuts of
steering, seat rail, or brake as it may cause accident, fire or steering, seat rail, or brake as it may cause accident, fire or
electrical shock.electrical shock.
■Be sure to use the proper size fuse for replacement.Be sure to use the proper size fuse for replacement.
Thank you for purchasing this BEWITH Mirror Media MM-1. It is designed to give you many years
of enjoyment.
■Please read all instructions in this manual before attempting operation and keep it handy for
future references.
■Please make sure of the product's serial number, the date of purchase, and the dealer name
on the enclosed warranty for your own security and convenience. Should you have any questions,
contact your nearest BEWITH authorized dealer or installation specialist.
Precautions Please read carefully before using this product.
This label is intended to alert the user to the
presence of important operating instructions.
Failure to heed the instructions may result in
severe injury or death.
WarningWarning CautionCaution
This label is intended to alert the user to the
presence of important operating instructions.
Failure to heed the instructions can result in
injury or material damage.
WarningWarning
for safe usagefor safe usage
WarningWarning
for installationfor installation
■The driver must not operate while driving.The driver must not operate while driving.
For your safety, some of the functions do not allow you to operate
unless the vehicle is stopped and the parking brake is applied.
■DO NOT watch the unit while driving.DO NOT watch the unit while driving.
Proper installation allows the driver to only watch the screen when the
vehicle is stopped and the parking brake is applied. (Except rearview
camera)
■DO NOT disassemble or modify the product as it may DO NOT disassemble or modify the product as it may
cause accident, fire or electrical shock.cause accident, fire or electrical shock.
It will void your warranty.
■DO NOT attempt to operate if screen fails or no sound is DO NOT attempt to operate if screen fails or no sound is
heard as it may cause accident, fire or electrical shock. heard as it may cause accident, fire or electrical shock.
Please contact the dealer or distributor from where you purchased the
product for this matter.
■Stop using the unit immediately when problems appear Stop using the unit immediately when problems appear
such as noxious odors or smoke being emitted from the unit, such as noxious odors or smoke being emitted from the unit,
or foreign objects or dropped inside the unit.or foreign objects or dropped inside the unit.
Please contact the dealer or distributor from where you purchased the
product.
■For your safety, please ask the dealer from where you For your safety, please ask the dealer from where you
purchased the product for installation and changing the purchased the product for installation and changing the
system that need technical skill.system that need technical skill.
■Follow the wiring diagram of the product as shown in the Follow the wiring diagram of the product as shown in the
manual.manual.
■Use provided parts for installation. Use provided parts for installation.
Over-sized hardware or other parts than the one provided may cause
an electrical short or result in product not being mounted securely.
■DO NOT place unit on uneven or unstable surfaces.DO NOT place unit on uneven or unstable surfaces.
■DO NOT drop this unit or put pressure on the mirror andDO NOT drop this unit or put pressure on the mirror and
display.display.
CautionCaution
for safe usagefor safe usage
CautionCaution
for installationfor installation
■For traffic safety and to maintain safe driving conditions, For traffic safety and to maintain safe driving conditions,
keep the volume low enough so that you can still hear normal keep the volume low enough so that you can still hear normal
traffic sound.traffic sound.
■DO NOT use this unit for purposes other than those listed DO NOT use this unit for purposes other than those listed
for a vehicle.for a vehicle.
■DO NOT use benzine, paint thinner, or any other DO NOT use benzine, paint thinner, or any other
chemicals to clean this unit.chemicals to clean this unit.
Please use dry or wringed cloth.
■DO NOT spray any cleaning fluid directly on this unit.DO NOT spray any cleaning fluid directly on this unit.
Please spray and spread it on cloth and clean for preventing
damage.
○Cellular phones and remote control starters may cause noise or malfunction to this unit. Please stay away from the unit
when using those apparatus.
○This unit contains sensitive components. Please handle your unit safely with care.
○This unit's video format is NTSC. This is not compatible with PAL.
○This unit should not be used in a vehicle where is extremely hot or cold. Please wait until the temperature inside the
vehicle becomes normal.
○The height of existing rearview mirror must be 55～80mm to install MM-1. The MM-1 may not be able to be installed when
the existing rearview mirror is peculiar shape or there is not enough space between the existing rearview mirror and the
interior.
○For driver's safety, proper installation allow the driver to only watch images when the vehicle is stopped and the parking
brake is applied.
○Do not watch images or the monitor when operating a vehicle.
○The LCD panel used in this unit is made with the application of high precision technology. However, there may be minute
points on the screen where pixels never light or are permanently lit. Also, if the screen is viewed from an acute angle there
may be uneven colors or brightness. Please note that these are not malfunctions but common phenomena of LCDs and
will not affect the performance of the monitor.
○The images may not be displayed properly(black and white or unstable images) when the products connected to this unit
are not standardized or not functioning properly. Please contact with the dealers or the manufactures of the products for
product information.
○Smart Interface must be installed safely with adhesive tape to place where it does not interfere with the vehicle operation.
Excepting when operating the rearview camera.
