BENTEL SECURITY S.r.l. reserves the right to modify the technical specifications of this product without prior notice.
IMPORTANT: The following information is for disassembled Control Panels ONLY.
Ensure that the Manual you are using complies with the requirements (see below) on the
“RELEASE ISSUES” label inside the package. Upgrades of the KYO Unit Software Re-
lease are also suitable.
Manual Release
Firmware Release
Software Release
RELEASE ISSUES
OK32 1.01
Installation Manual
UserManual
Keypad Prog. Man.
Main Unit Manual
Kyo Unit Software
1.1
1.1
1.1
1.1
5.10
DO NOT attempt to assemble and install the Control Panel using a manual that does not
comply with requirements.
The Manual Release Number of each Manual is shown at the bottom of the last page,
between the Code and Date, as shown below.
ISTPTBLEUNKYO 190503 P70
1.2
Manual
Release
Number
DateCode
This control unit supports the following keypads and key readers:
PREMIUM, CLASSIKA, MIA series,ALISON series, OMNIA/TAST-R, NC2/TAST, ICON/KP, ECLIPSE, ECLIPSE2
To keep things simple,this instruction manual refers only
to the PREMIUM and CLASSIKA keypads and ECLIPSE2 key readers.
Ifyou require further information relating to the other types of keypad/Key Readersupported by this control unit,
the previous version of this instruction manual may be downloaded from the web address www.bentelsecurity.com
KYO 4 M – KYO 8 M – KYO 8W M – KYO 32 M – KYO 4 P – KYO 8 P – KYO 8W P – KYO 32 P
KYO 8G L-SW1 – KYO 8G L-SW2 – KYO 32G L-SW1 – KYO 32G L-SW2
KYO16D
For all the Control Panels the performance level is II (unless otherwise specified).
The KYO16D performance level is I
KYO 8GWP-SW1 – KYO 8GWP-SW2 – KYO 8GWL-SW1 – KYO 8GWL-SW2
KYO 8G P-SW1 – KYO 8G P-SW2 – KYO 32G P-SW1 – KYO 32G P-SW2
Hereby, Bentel Security, declares the above mentioned Control Panels to be in compliance with the
essential requirements and other relevant provisions of 1999/5/EC Directive.
The complete R&TTE Declaration of Conformity for each Panel can be found at
www.bentelsecurity.com/dc.html.
These Control Panels comply with
Installation of these systems must be carried out strictly in accordance with the instructions
described in this manual, and in compliance with the local laws and bylaws in force.
The above mentioned Control panels have been designed and made
to the highest standards of quality and performance.
The manufacturer recommends that the installed system should be completely tested at least once a month.
BENTEL SECURITY Srl shall not assume the responsibility
for damage arising from improper application or use.
The above mentioned Control panels have no user-friendly components, therefore,
CEI 79-2 2 ed. 1993
a
.
