Belkin F8Z125 Manual de usuario

Introduction

User Manual

TuneFM™ for iPod® nano

Introduction | 01

Introduction

Congratulations and thank you for purchasing the innovative TuneFM

from Belkin. This product is designed to play your iPod nano through

your car, home, or portable stereo. Please review this User Manual

carefully so that you can be sure to get the most from your iPod nano,

virtually anywhere you go.

| 02

Car Setup Instructions

1. Turn down your car stereo’s volume.

2. Connect the Belkin TuneFM to your iPod nano (at the bottom of

the nano).

3. Connect the included Auto Power Cord to your cigarette-lighter

outlet in your car and to the bottom of your TuneFM for optional

powering and charging in the car.

The TuneFM transmitter function automatically turns on when the iPod

is connected. It automatically turns off when the iPod is removed.

1. Tune your stereo frequency to a channel with a weak broadcast

signal. The ideal channel is one that is not broadcasting a radio

program, or is doing so weakly.

2. Insert the TuneFM into your iPod nano. The iPod backlight will turn

on and the current transmitter frequency will be displayed on the

iPod screen.

3. Press the ▲ or ▼ button on the TuneFM to select the transmission

frequency chosen in step 1. The frequency will be visible on the

iPod nano’s screen. Pressing and holding either button will provide

faster tuning.

4. After displaying the current frequency for five seconds, the iPod

screen will return to the iPod Main Menu. This happens whenever

you make changes to the TuneFM’s settings. All settings—including

transmission frequency and stereo/mono control settings—are

permanently stored in memory at this time.

Note: iPod playback will pause momentarily when entering and exiting

the TuneFM control menu. Playback will quickly resume.

Using the TuneFM Transmitter

Using the TuneFM Transmitter | 03

| 04

5. Adjust the iPod nano volume to about three-fourths of the

maximum. Adjust the volume of your FM radio to the desired

listening level.

NOTE: We recommend that you remove the TuneFM from the iPod

when not in use.

Frequency display

Frequency selector

Memory station display

Memory stations 1 – 4

Using the TuneFM Transmitter



















1. To store a preset, select the desired frequency using ▲ or ▼ buttons. Press and hold

the desired preset button (1, 2, 3, or 4) for two seconds. An audible beep sounds in

the transmitted audio when the new frequency is programmed*. The iPod nano

display reflects the change when the memory button is released by showing which

memory button was pressed followed by the frequency saved in that memory

position.

* Do NOT remove the TuneFM from the iPod nano until it returns to the Main Menu

screen or new settings may not be saved.

2. To transmit over one of your preset frequencies, momentarily press “1”, “2”, ”3”, or “4”.

This will instantly tune the FM transmitter to the frequency stored in that preset.

Transmission-Volume Setting

Although the default volume setting will be ideal for most conditions,

you may be able to improve the performance of the TuneFM by

adjusting the volume of the transmitted audio signal. The TuneFM

allows you to select one of five volume levels. You may wish to

decrease the volume if you experience distorted audio.

You can access the transmission-volume menu by pressing the “1” and

“2” buttons simultaneously. TuneFM displays the current volume setting on the iPod, which

is represented by “VOL 1” (low), “VOL 2”, “VOL 3” (default), “VOL 4”, and “VOL 5” (high). You

can then change the volume level by using the up and down arrows. To accept your volume

selection, simply wait for the iPod screen to return to the iPod Main Menu.

Note: The iPod nano has a lower audio-output level than other iPod models, so a volume

setting of “VOL 4” or “VOL 5” works best for iPod nano.

Storing and Using Presets | 05

Storing and Using Presets







| 06Stereo/Mono Selection

Stereo/Mono Selection









Transmitting music in stereo generally gives you the highest-quality

listening experience. However, you may get better FM signal reception

by changing the transmission to mono. The TuneFM transmits in stereo

mode by default. We suggest that you switch from stereo to mono

transmission only if your car stereo is NOT receiving a clear signal from

the TuneFM, or if you are listening to mono recordings such

as audio books.

You can access the stereo/mono transmission

menu by pressing the “1” and “3” buttons

simultaneously for two seconds. The TuneFM

then displays the current mode setting, which is

represented by “MONO” or “ST”.

You can change the mode by pressing the up

or down arrows. Either arrow will change

between the two modes. The new setting

takes effect immediately.

To accept your mode selection, press one of the

memory preset buttons, or simply wait for the iPod

screen to return to the iPod Main Menu.

Issue – The audio is distorted.

Solution 1

Decrease the volume of your iPod nano until you no longer hear distortion.

Keeping the iPod nano volume level at or below three-fourths of the

maximum should prevent audio distortion.

Solution 2

Tune your car stereo and the TuneFM to a different frequency.

Issue – I am unable to get clear FM reception.

Solution 1

Tune your car stereo and the TuneFM to a different frequency.

Solution 2

In some instances, lowering the car antenna (available in some cars)

improves the clarity of the TuneFM’s signal.

Solution 3

Change the stereo/mono setting to mono mode. This may improve signal

reception, but the audio will be monaural instead of stereo.

Solution 4

If used indoors, attach or reposition the antennae on the stereo receiver.

Troubleshooting | 07

Troubleshooting

| 08

Issue – iPod playback stays paused after I’ve changed a setting on

the TuneFM.

Solution

Simply press the “Play/Pause” button on your iPod nano to

resume playback.

Issue – The TuneFM does not appear to be saving my settings.

Solution

Be sure NOT to remove the iPod from the cradle or remove power to the

TuneFM while adjusting the TuneFM settings. Your settings are stored in

memory when the iPod screen returns to the iPod Main Menu.

Issue – When I attach a USB cable from my computer to the

TuneFM, my computer does not recognize that the iPod nano

is attached.

Solution

The USB connector on the TuneFM can only be used to charge the iPod.

Troubleshooting

Issue – My iPod nano does not seem to be charging.

Solution 1

Make sure that the TuneFM is correctly connected to your car’s power outlet

with the included Auto Power Cord.

Solution 2

Ensure that your car’s power outlet is receiving power. Some cars are

designed so that power is not provided to the power outlet unless the car

is in ignition mode or the engine is started. If none of these solutions solves

the problem, the fuse in the Auto Power Cord might be burned out and need

to be replaced.

Troubleshooting | 09

Troubleshooting

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Transmisor de Belkin

Belkin

Belkin TuneCast II Manual de usuario

Belkin

Belkin F8Z343EA Manual de usuario

Belkin

Belkin TuneBase F8Z049 Manual de usuario

Belkin

Belkin F8Z176 Manual de usuario

Belkin

Belkin F8V3080 - TuneCast II Mobile Transmitter Manual de usuario

Belkin

Belkin F8M117 Manual de usuario

Belkin

Belkin F8V3080 - TuneCast II Mobile Transmitter Manual de usuario

Belkin

Belkin TuneCast3 Manual de usuario

Belkin

Belkin F8V367-APL Manual de usuario

Belkin

Belkin TuneFM for iPod Manual de usuario

Belkin

Belkin TuneCast 3 Manual de usuario

Belkin

Belkin TuneCast II Manual de usuario

Belkin

Belkin TuneFM for iPod Manual de usuario

Belkin

Belkin F8Z618cw Manual de usuario

Manuales populares de Transmisor de otras marcas

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manual del propietario

Honeywell

Honeywell 5816WMBR Manual de usuario

Kamstrup

Kamstrup READy MTU Instrucciones de funcionamiento

Omega

Omega ZW Series Manual de usuario

ABB

ABB Field 264H Guía

Alinco

Alinco DJ-V17T Manual de usuario

Dejero

Dejero EnGo 3x Manual de usuario

Rosemount

Rosemount 4600 Manual de usuario

Speaka Professional

Speaka Professional 2342740 Manual de usuario

trubomat

trubomat GAB 1000 Manual de usuario

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manual de usuario

Rondish

Rondish UT-11 Manual de usuario

MG 10JRE Manual de usuario

Burkert

Burkert 8177 Manual de usuario

Firetide

Firetide HotPort 3203 Manual

Tele Radio

Tele Radio T9-02 Manual de usuario

Rotronic

Rotronic HygroFlex HF3 Series Manual de usuario

Jamara

Jamara FCX6 Pro Tel Manual de usuario