Belkin ClassicMouse F8E201-BLK Manual de usuario

F8E201

P73096 F8E201-BLK

ClassicMouse

User Manual

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 1

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 2

ABOUT YOUR MOUSE

1.1 An Introduction to Your New Belkin ClassicMouse

The Belkin ClassicMouse is a high-resolution three-button mouse

designed for today’s active PC user. It works with Microsoft®

systems for optimum compatibility, and its sleek design helps

reduce stress and undue hand and wrist fatigue. It features

dynamic resolution, low-friction rollers and three separate

function micro-switch buttons for years of productive use.

Once the software has been loaded onto your computer, the

center button of your mouse can be programmed to perform the

same tasks as:

• Left Button Double Click

• F1 through F12

• Enter Key

• Page Up Key

• Page Down Key

• Home Key

• End Key

1. Introduction

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 1

1. Introduction (continued)

1.2 Connecting Your Mouse

Your mouse connects to either a PS/2 (or 6 pin MiniDIN) mouse

port or a 9 pin serial port. To verify your connectors, locate the

port on the back of your computer that is designated for your

mouse. Most PCs will have the word MOUSE marked next to

the PS/2 connector. Older PCs will have either Serial 1 (and up)

or COM 1 (and up) for the serial connector. If you are still

unsure, please refer to your hardware manual.

For PS/2 mouse port installation, simply remove the serial

adapter before connecting the mouse cable to the computer.

WARNING: To avoid damage, turn your computer off

before plugging or unplugging any

pointing devices.

a. Locate the computer PS/2 mouse port or Serial port

on the back of your computer.

b. Plug your mouse into the appropriate port suggested

above. Check the box in which your mouse was shipped to

verify the ports supported.

c. If applicable, tighten down the connector thumbscrews.

d. Turn your computer on. At this point, your mouse will work

with the built-in Microsoft®Operating System. To use the

extra features of your middle button, you must install the

included software.

6 pin MiniDIN 9 pin Serial

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 2

2. Software Installation

A STEP BY STEP GUIDE

2.1 Windows®3.1 and Windows®3.11

a. Insert the ClassicMouse diskette in the A: or B: drive.

b. From the “Program Manager”, click on “File”, then click

on “Run”.

c. Type “A:setup” or “B:setup” and then click on “OK”.

d. Follow the on-screen instructions to complete the

installation of the ClassicMouse.

e. To make the process run smoothly:

1. Click “Next” twice.

2. Type your name and the company’s name, then

click “Next”.

3. Click “Next” twice.

4. Specify if you are using a PS/2 or Serial mouse (refer

to section 1.2) then click “OK”.

5. Select “Yes, I want to restart my computer now” then

click on “Finish”.

Note: Remove the software from the disk drive before you

restart your computer. Don’t worry if it has already

restarted before you can remove it. The computer will

prompt you to remove it.

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 3

2. Software Installation (continued)

2.2 Windows®95, Windows®98 and Windows NT®4.0

a. Insert the ClassicMouse™diskette in the A: or B: drive.

b. Click on "Start" in the lower left corner of your screen, then

click on "Run".

c. Type "A:setup" (or "B:setup") and then click on "OK".

d. Follow the on-screen instructions to complete the installation of

the ClassicMouse™.

e. To make the process run smoothly:

1. Click on “Next” twice.

2. Type your name and the company’s name, then

click “Next”.

3. Click “Next” twice.

4. Specify if you are using a PS/2 or Serial mouse (refer

to section 1.2) then click “OK”.

5. Select “Yes, I want to restart my computer now”, then

click “Finish”.

Note: Remove the software from the disk drive before you

restart your computer. Don't worry if it has already

restarted before you can remove it. The computer will

prompt you to remove it.

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 4

3. Troubleshooting

Q: When installing the software, which driver should I

choose? The PS/2, Serial Mouse on COM1, or Serial

Mouse on COM2?

A: If you are using a PS/2 mouse (refer to section 1.2), then

the driver must state that it is using a PS/2 driver. If you

are using a Serial mouse (refer to section 1.2), then the

driver must state that it is using a Serial driver on COM1

or COM2.

Q: I can get into Windows®or into Safe Mode but I

cannot use the mouse.

A: If you have more than one driver, this could be causing

your computer to boot in safe mode or not allow your

mouse to work at all. If you are using a PS/2 mouse then

the driver must state that it is using a PS/2 driver. If you are

using a Serial mouse then the driver must state that it is

using a Serial driver on COM1 or COM2. If you have a

Serial Mouse and you are not sure whether you are using

COM1 or COM2 then try moving the mouse to another

serial port on the back of your computer (most computers

have two; if you have only one then it will more than likely

be COM1). If you have more than one driver then you must

remove the excess drivers.

Q: If I have more than one mouse driver how do I remove

the driver without the mouse control? How do I boot

into normal Windows®mode?

A: Use your "Windows®" key at the bottom left hand corner

of your keyboard if you have one; if not, press "Alt + S" to

go to the "Start" button in Windows®98. Then use your

“Up” arrow" to select "Settings", then use your “Right”

arrow to select "Control Panel" and then press "Enter".

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 5

3. Troubleshooting (continued)

These steps have taken you to the "Control Panel" where

you can gain access to your "Device Manager". The "Device

Manager" shows your driver status and information and it

will allow you to modify their settings.

After entering the "Control Panel" use your "Up" and

"Down" arrows to select "System", and then press "Enter".

After entering "System Properties" use your "Right” arrow

to select "Device Manager". Then press "Tab" until you have

selected "Computer" and then use the "Down” arrow until

your "Mouse" is highlighted. Then use your "Right” arrow to

expand and select your mouse driver or drivers. After you

have chosen your mouse driver you can now modify it by

removing the driver or changing the driver.

To remove the driver you have selected, use your "Tab" key

until the "Remove" tab is selected. Then press "Enter". This

will remove the driver. Use your "Arrow” keys to select any

other drivers and repeat the process until all but one driver

remains. Even if it is the wrong driver you can use it and

change it to the mouse driver you want.

After removing or changing the mouse driver, use your

"Tab" key until "Close" is selected and then press "Enter".

Then you will have to reboot your computer. Use your

"Windows®" key at the bottom left hand corner of your

keyboard if you have one; if not, press "Alt + S". Then use

the "Up” arrow to select "Shut Down" and press "Enter".

Use your "Arrow” key to select "Restart" and press "Enter".

Q: After installing the mouse driver and rebooting, my

mouse will not work. How do I change the mouse driver

without mouse control?

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 6

3. Troubleshooting (continued)

A: Use your "Windows®" key at the bottom left hand corner

of your keyboard if you have one; if not press "Alt + S" to

go to the "Start" button in Windows®98. Then use your

"Up" arrow to select "Settings" then use your "Right"

arrow to select "Control Panel" and then press "Enter".

These steps have taken you to the "Control Panel" where

you can gain access to your "Device Manager". The

"Device Manager" shows your driver status and

information and it will allow you to modify their settings.

After entering the "Control Panel" use the "Up" and

"Down" arrows to select "System" and then press

"Enter". After entering "System Properties" use the

"Right" arrow to select "Device Manager". Then press

"Tab" to bring your selection to "Computer" and then

use the "Down" arrow until your "Mouse" is highlighted.

Then use your "Right" arrow to expand and select your

mouse driver or drivers. After you select the mouse

driver, use your "Tab" key to select "Properties" and

then press "Enter". Use your "Right” arrow key to

choose the "Driver" tab and then use your "Tab" key to

choose "Update driver" and then press "Enter".

The next options will vary from computer to computer

because there are many types of Windows®operating

systems. The wording or options will be a little different

but should be somewhat the same.

Windows®will then continue to ask questions and help

guide you through the changes. Use your "Arrow" keys,

"Enter", and "Tab" keys to continue through the process.

Windows®may or may not start searching for Plug-and-

Play devices right away, and it may or may not find

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 7

3. Troubleshooting (continued)

anything new. If it does not find anything new it will ask you

another line of questions, and if it does find something new

choose something similar to "This Device is not in the list".

Windows®will then ask if you want Windows®to search for a

new device or will ask if you want to select a driver from a

list. You will want to choose a device or driver from a list.

Use your "Arrow", "Tab" and "Enter" keys to navigate and

finish until the end of questioning. After finishing, Windows®

may or may not ask you to reboot your computer. You will

want to restart your computer. If it does not ask you to

restart your computer you will have to close "System

Properties". Use the "Tab" key until "Close" is selected and

then press "Enter". You will have to restart your computer.

Use your "Windows®" key at the bottom left hand corner of

your keyboard if you have one; if not, press "Alt + S". Then

use the "Up” arrow to select "Shut Down" and use your

"Enter" key. Use the "Arrow" key to select "Restart" and

press "Enter".

Q: Why does my external mouse not work with my

laptop computer?

A: You may have to disable the onboard mouse in order to use

an external mouse. Try looking in your CMOS or BIOS in

order to disable the onboard mouse. If you do not have this

option or do not know how to get into your BIOS or CMOS,

please follow instructions in your computer manual or call

the computer dealer or technical support for your computer.

P73096-F8E201-US-man-qxd 3/9/00 8:14 AM Page 8

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Ratón de Belkin

Belkin

Belkin F8E857 Manual de usuario

Belkin

Belkin F5L017-USB Manual de usuario

Belkin

Belkin F8E874EA Manual de usuario

Belkin

Belkin NetMaster F8E204 Manual de usuario

Belkin

Belkin ErgoMouse F8E203-BLK Manual de usuario

Belkin

Belkin F8T041-B Manual de instrucciones

Belkin

Belkin F8E825-USB Manual de usuario

Belkin

Belkin F8E800 series Manual de usuario

Belkin

Belkin MiniScroller F8E841-BLK Manual de usuario

Belkin

Belkin COMFORT MOUSE Manual de usuario

Belkin

Belkin ClassicMouse F8E201 Manual de usuario

Belkin

Belkin AeroCruiser F8E888 Manual de usuario

Belkin

Belkin F8T041-B Manual de usuario

Belkin

Belkin WIRELESS OPTICAL USB MOUSE Manual de usuario

Belkin

Belkin MiniWireless F8E874 Manual de usuario

Belkin

Belkin M450 Manual de usuario

Belkin

Belkin F8E825-USB Manual de usuario

Belkin

Belkin F8E729 Manual de usuario

Belkin

Belkin F8E845ea Manual de usuario

Belkin

Belkin P74279ea Manual de usuario

Belkin

Belkin F5L075USB Manual de usuario

Belkin

Belkin ErgoFit P74278 Manual de usuario

Belkin

Belkin F8E845 Manual de usuario

Belkin

Belkin COMFORT MOUSE Manual de usuario

Manuales populares de Ratón de otras marcas

Sven

Sven RX-G720 Manual de usuario

3DConnexion

3DConnexion CadMouse Pro Manual de usuario

Canyon

Canyon Puncher GM-20 Manual de usuario

Sharkoon

Sharkoon Light2 180 Manual de usuario

Cherry

Cherry MW 8C ERGO Manual de usuario

NGS

NGS HIT RB Manual de usuario

Sharkoon

Sharkoon FireGlider Manual de usuario

Lenovo

Lenovo Wireless Mouse N3902 Manual de usuario

BASETech

BASETech BN-S11 Manual de usuario

Dell

Dell WM326 Manual de usuario

Areson

Areson B213 Manual de usuario

HP M17587-371 Manual de usuario

Chatpen

Chatpen CHA-30 Manual de usuario

GAMDIAS

GAMDIAS DEMETER GMS5000 Manual de usuario

HP KJ453AA - Wireless Laser Mouse Manual de usuario

Trust

Trust GRAPHIN GXT 960 Manual de usuario

Lenovo

Lenovo SD-9082 Manual de usuario

Alienware

Alienware AW320M Manual de usuario