4 Installation
Only special-purpose parts can be used for installation of the heater.
Fig. 7 is the diagram for installation. The positions and ways of fixing of
various parts may vary from one automobile model to another, but the
general principles must be followed in conformity with the requirements of
this chapter. Otherwise the heater may not work normally or safety
problems may occur.
4.1 Requirements for Installation and Places ofApplication of the Heater
4.1.1 It is not allowed to use the heater in locations with inflammable or
explosive substances such as flammable gas or flammable dust.
4.1.2 It is not allowed to use the heater in closed space (such as garage or
maintenance workshop without air ventilation) to avoid danger of poisoning
due to exhaust from burning.
Attention: Under either of the above circumstances, it is not allowed to use
the heater even at the timer stand-by state or wireless remote control state.
4.1.3 It is not allowed to install and use the heater in bedrooms.
4.1.4 If the heater is installed in special-purpose vehicles (such as vehicles for
dangerous goods), special rules must be followed in installing the heater.
4.1.5 Never place fuel tank, compression tank, fire extinguisher, clothes,
paper, etc. near the heater or opposite to the hot air vent.
4.2 Installation of the Main Heater
4.2.1The main heater can be installed inside the vehicle or outside the
vehicle. But when it is installed outside the vehicle a shield which can be
prevent the damage(splash of stones)of external force(supplied by
retailers).The heater can’t be soaked in the water or in the rain for a long
time(heater should be shut off).The heater should be operated after it is
completely dried if the heater is corroded by rain and water.
4.2.2 For convenience of heating air flow and installation, maintenance of the
main heater, enough space must be provided for installation. Please refer to
the scope of double dot line for the space for installation, as shown in Fig. 8.
