4
ASSEMBLY INSTRUCTIONS FOR OPTIONS
FORTY-FIVE (45) GALLON DRUMS
Attach sleeves to the bottom of the dust collector with the fix band clamps and to
the top of the forty-five (45) gallons storage drums with the quick release band
clamps.
DUMPING BINS (option)
Assemble the quick coupling plate as per drawing 0482-AIC-00000 of appendix 2.
To help you, use the dumping bin to support the quick coupling plate and follow
these easy steps:
1. Slide the quick coupling plate, over the dumping bin but not completely.
Leave about two (2) feet at the end. If necessary have someone hold the bin
to prevent it from tilting forward.
2. Then roll the dumping bin under the filtration module until the upward flap of
the quick coupling plate is flush with front of the filtration module.
3. Install the first set of bolts situated at the far end, where the plate is
protruding from bin. You do not have to tighten completely the bolt at this
step.
4. Once the end bolts are secured, back up the dumping bin to gain access to
the second set of holes located in the middle of the coupling plate.
5. With four (4) bolts installed, remove slowly the dumping bin to gain access
to the last two (2) holes.
6. Now make sure that the six (6) bolts are tightened properly and the seal to
the filtration unit, achieved.
Then simply glide the dumping bin through the quick coupling plate. The floor
should be level enough so that the wheels would not touch the floor when the bin
is in position. In fact the bulb trim seal should start to be compressed six (6) to
twelve (12) inches before the bin is completely in position (when the front of the
bin hits the back of the coupling plate). If the bin leaks when dust collector is
functioning, use the side adjustments, hidden under each side lip of the bin, to
better squeeze the gasket where needed. Note that optimum sealing will be
obtained when gasket is compressed of approximately one-eighth of an inch
(1/8”). An excessively squeezed gasket, will not seal better, it will only shorten its
life span or may damage it permanently.
