Safety İnstructions
➢Be sure that electrical connection is made carefully. To avoid unwanted situations like electrical shock, protect the main supply cable with a holster.
➢Before running the machine, be sure that all of the protections are mounted properly and all the covers are closed.
➢Avoid from smoke and moisture.
➢Please use the parts and equipments which are recommended. Usage of unsuitable parts and materials which are bigger than the capacity of the machine can cause unwanted situations.
➢Check the machine and inform the defects everyday.
➢Don’t leave any material after chancing the band.
➢Do not hold the material while the machine is cutting. Always tighten the material by using essential parts.
➢Please pay attention to choose the area of the machine which doesn’t include anything that creates difficulties to control the machine
➢Please be sure that the teeth of the band are looking to correct direction.
•Don’t leave the band on the ground or any place that is dangerous for other people.
•Be careful when using the machine and keep the working area clean ( clean the saw dusts and oil traces )
•Pay attention to security instructions when using the machine.
•Don’t wear loose cloths when using the machine.
•Regardless use the protective gloves when using the machine.
•Don’t get close too much to the machine when running.
•Before carrying out any cleaning or maintenance procedure, disconnect the machine from main supply.
•İn some conditions, noise level can be about 85 db. Band choice and cutting speed is important factor for noise level.
•İllumination is an important factor for security.
•Ratio of coolant liquid is important for obtaining optimum lubrication.
•Never use the machine if you notice any fault of the machine or absence of any part of the machine.
- Control the emergency button at least once a week and be sure that it is working properly.
