bedTech BT1000 Manual de usuario
OWNER’S MANUAL
Installation & Operation
Serial No.
Safety & Warranty Warnings ……………………………………………… 01
Parts List …………………………………………………………………………… 02
BT1000 Electronics Quick Reference Guide ……………………… 03
BT2000 Electronics Quick Reference Guide ……………………… 04
BT3000 Electronics Quick Reference Guide ……………………… 05
BT4000 Electronics Quick Reference Guide ……………………… 06
Installation Guide ……………………………………………………………… 07
BT1000/BT2000 Remote Control Intructions…………………… 08
BT3000 Remote Control Intructions………………………………… 09
BT4000 Remote Control Intructions………………………………… 10
Setting Programmable Positions and Pairing Remote………… 11
Synchronizing Two Bases…………………………………………………… 12
Headboard Bracket Installation Guide ……………………………… 13
Troubleshooting ………………………………………………………………… 14
Table of Contents
Customer Service: 1-855-430-8943
READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT
If unable to understand warnings, cautions, and/or instructions, contact the dealer or technical personnel
if applicable, before attempting to use the equipment. Otherwise, injury or damage may result.
SAFETY WARNINGS:
• Do not use bed outdoors.
• Do not use bed near explosives.
• Using bed with oxygen administering equipment other than the
nasal masked type creates a possible re hazard.
• When using nasal or masked type administering equipment, route
and secure oxygen or air tubing properly to ensure that tubing does
not become entangled or damaged during normal operation of the
bed.
• Use caution when having liquids in or around the bed to ensure no
spilling occurs. In case of spillage, stand in a dry, clean area of the
oor and unplug the bed immediately. Clean up spill and allow the
area around bed to dry thoroughly before using the electric controls
again. Do not eat or drink hot liquids while operating the bed.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instructions concerning use of the appliance by a
person responsible for their safety.
• Do not allow children or individuals with disabilities to operate the
bed without adult supervision.
• Do not allow any person or pet under the bed at any time.
• During bed operation, make sure body is positioned within the
connes of the bed. Do not place extremities over the sides of the
bed when operating bed functions.
WARRANTY WARNINGS:
Do not open or tamper with control box, motors, or remote (with the
exception of battery compartments). The warranty will be void if the
internal workings of these components are tampered with.
Product Rating:
The motors are not designed to operate continuously for more than
[2] minutes in an [18] minute time period or approximately 10% duty
cycle. Attempting to circumvent or exceed this rating will shorten the
life expectancy of the foundation and may void the warranty.
Operating Information:
• After power foundation assembly is completed, operate remote
control to ensure proper functions.
• Keep moving parts free of obstruction during bed operation
(including sheets, clothing, tubing, wiring, and products using electric
power cords).
• Distribute body weight evenly over bed surface. Do not place entire
weight on head or foot sections of the bed, during repositioning and
entering or exiting bed.
Hospital Use Disclaimer:
This power foundation is designed for residential use only. It is
not approved for hospital use and does not comply with hospital
standards.
Weight Limits:
This product is not rated to support weights in excess of 750 pounds
inclusive of the mattress and bedding. The bed will structurally
support this weight, provided it is evenly distributed across the
foundation. The power foundation is not designed to support or
lift this amount in the head or foot sections alone. Exceeding this
weight restriction could damage the bed and/or cause injury and will
void the warranty.
FCC COMPLIANCE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
To comply with the FCC RF exposure requirements, no change to the antenna or the device is permitted. Any change to the antenna or the
device could result in the device exceeding the RF exposure requirement and void user’s right to operate the device.
RADIO FREQUENCY: 2.4 GHz
—01—
Safety & Warranty Warnings
Customer Service: 1-855-430-8943
All electronics and components that need to be installed are located in boxes under the foundation or
attached to the frame. Before discarding the packing materials, ensure that all the parts are accounted for.
OPTIONAL EQUIPMENT (NOT INCLUDED)
(2) 9-Volt Batteries Socket and Crescent Wrench
Actual product appearance and functionality may vary from photographs.
—02—
Accessories Box Headboard Bracket Box
(1) Hand Control
(4) 9" adjustable legs (2) T Brackets
(4) Short Bolts
(8) Long Bolts
(12) Nuts
(1) Power Supply
(1) Power Cord
(2) AAA Batteries
(2) Headboard Brackets
Parts List
Customer Service: 1-855-430-8943
—03—
BT1000 Electronics Quick Reference Guide
BT1000 WIRELESS OVERVIEW
Remote
Power Cord
Power Supply
Paring Button
Control Box
Control Box
Head Motor
Head Motor
Customer Service: 1-855-430-8943
BT2000 WIRELESS OVERVIEW
—04—
Foot Motor
Remote
Foot Motor
Power Cord
Power Supply
Paring Button
Control Box
Control Box
Head Motor
Head Motor
BT2000 Electronics Quick Reference Guide
Customer Service: 1-855-430-8943
BT3000 WIRELESS OVERVIEW
—05—
Foot Motor
Foot Motor
Power Cord
Power Supply
Paring Button
BT3000 Electronics Quick Reference Guide
r
Control Box
Remote
Head Motor
Head Massage Motor
Foot Massage Motor
LED Light
USB Ports
r
USB Ports
Head Massage Motor
Head Motor
Control Box
LED Light
Foot Massage Motor
Customer Service: 1-855-430-8943
Customer Service: 1-855-430-8943
BT4000 Electronics Quick Reference Guide
BT4000 WIRELESS OVERVIEW
Power Cord
Power Supply
Paring Button
r
Control Box
Remote
Head Motor
Head Massage Motor
Foot Massage Motor
LED Light
USB Ports
Head Motor
Head Massage Motor
LED Light
USB Ports
Foot Motor
Foot Massage Motor
Headrest Motor
Headrest Motor
Control Box
Foot Motor
—06—
Two people are required to set up the foundation.
STEP 1
STEP 2
STEP 3
Place the foundation box in a
desired location with the bottom
of the box facing up.
Remove the binding straps and
packing materials, making sure
not to puncture the box with any
sharp objects.
Remove the foundation from the box, keeping the bottom of the
foundation facing upward for easier access to the bed's components.
To install the legs, thread the
bolt of the leg to the nut on
the foundation frame, and
tighten by hand. DO NOT
OVERTIGHTEN.
STEP 6
STEP 9
STEP 7
STEP 8
Uncoil the power cord and connect it to the
power supply.
Locate the mattress retainer bar brackets.
Slide the left side of the mattress retainer bar into the bracket. Pull
the retainer bar to the opposite bracket and secure the right side.
Carefully ip the foundation over onto its legs.
Important: Two people are required to move the foundation.
Do not drag across the oor. Do not rest frame on its side;
excessive pressure may damage the legs.
Ensure that batteries are correctly
installed.
NOTE: To avoid damage to the foundation,
always open the carton while the bed is in the at
position.
—07—
STEP 4
STEP 5
Locate the power supply
and install (2) 9-volt batteries (not
included).
Uncoil the input power cord
(connected to the control box’s
power port) and plug it into the
power supply.
Installation Guide
Customer Service: 1-855-430-8943
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Mobiliario de interior de bedTech
