Beamz 2-SOME Manual de usuario

2-SOME

153.747_153.748 V3

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and

have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from

shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to

the factory, it is important that the product be returned in the original factory box and packing.

If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water

might damage your unit. Leave the unit switched off until it has reached room temperature.

On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all

other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No

dimmer or adjustable power supply.

Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to

avoid the risk of electrocution or fire.

The unit may be set up on a stable and even surface. By means of the fixing facilities of the baseplate, the unit can also be mounted upside down to a truss,

see below picture. For fixing, certified clamps with correct save working load are required. According to the figure, the quick lock bolts of the omega

brackets are placed into the openings provided in the base plate and turned clockwise until they lock (to the stop). The mounting place must be of

sufficient stability and be able to support a weight of 10 times of the unit’s weight. Secure the unit with a safety cable so that it cannot fall down.

When carrying out any installation, always comply European and national guidelines concerning rigging, truss and all other safety issues. Always let the

installation checked out by an authorized dealer !

You can control this fixture without a controller because this feature provides automatic and sound

activated mode.

Fixture shows the preset program.

Fixture responds to the beat of the music. Turn the music on and adjust the microphone

sensitivity knob until the product responds to the beat of the music.

Controls the speed of program in auto mode

Press off existing modes. Press return the last modes.

Automatic mode will enable you to run the automatic programs on the product.

To turn on Automatic mode:

1. Press on the remote controller.

2. Press or to choose between the different auto programs.

Sound-Active mode will enable the product to respond to the music.

To turn on Sound-Active mode:

1. Press on the remote controller.

2. Press or to choose between the different sound programs.

To adjust the strobe speed of the automatic program and the sound active program.

1. Press on the remote controller.

2. Press or to either increase or decrease the speed of the program.

3. Press again to turn off the strobe.

To adjust the speed of the automatic program and the sound active program.

1. Press on the remote controller.

2. Press or to either increase or decrease the speed of the program.

To adjust sound sensitivity for in Sound-Active mode

1. Press on the remote controller.

2. Press or to either increase or decrease sound sensitivity.

1. Press on the remote controller.

2. Press , , , , (red, green, blue or white) to choose your colour.

3. Press again , , , , (red, green, blue or white) to close your colour.

4. Press or to either increase or decrease the percentage of each colour.

Press ON/OFF Light 1

Press ON/OFF Light 2

The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the

battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the

remote control. Otherwise operation of the remote control is not possible.

If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote

control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For

operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the

button cell shows upwards in the support.

Otros manuales para 2-SOME

1

Este manual sirve para los siguientes modelos

1

Tabla de contenidos

Otros manuales de Equipo de DJ de Beamz

Beamz

Beamz FLOOD36UV Manual de usuario

Beamz

Beamz LED PARBAR 4Way Tricolor Manual de usuario

Beamz

Beamz FUZE 712 Manual de usuario

Beamz

Beamz BBP90 Manual de usuario

Beamz

Beamz PS10W LED Pin Spot 10W RGBW DMX Manual de usuario

Beamz

Beamz Snow600 Manual de usuario

Beamz

Beamz FUZE1910 Manual de usuario

Beamz

Beamz BPP100 Manual de usuario

Beamz

Beamz Athena Manual de usuario

Beamz

Beamz Scan200ST 5x3W RGBAW 6strobe DMX IR Manual de usuario

Beamz

Beamz 153.262 Manual de usuario

Beamz

Beamz BAC550Z PAR ZOOM Manual de usuario

Beamz

Beamz 153.691 V1.2 Manual de usuario

Beamz

Beamz 160.571 Manual de usuario

Beamz

Beamz TP46 TRUSS PAR Manual de usuario

Beamz

Beamz 151.502 Manual de usuario

Beamz

Beamz Fuze 75 Beam Manual de usuario

Beamz

Beamz COB30WW Manual de usuario

Beamz

Beamz 151.347 V1.2 Manual de usuario

Beamz

Beamz 160.569 Manual de usuario

Beamz

Beamz LED Mini 4 head moon Manual de usuario

Beamz

Beamz KUBE20 Manual de usuario

Beamz

Beamz COB30RGB Manual de usuario

Beamz

Beamz Wi-par 8x 3w LED tri color battery 2.4Ghz... Manual de usuario

Manuales populares de Equipo de DJ de otras marcas

ALPHA LITE

ALPHA LITE ALPHA 1500 Manual del propietario

Chauvet

Chauvet OVATION E-930VW Manual de usuario

Zumtobel

Zumtobel APHRODITE Home Manual de usuario

Snow Masters

Snow Masters Zig Oscillator Manual de usuario

EuroLite

EuroLite 50530554 Manual de usuario

thomann

thomann Stairville DJ Lase 40-G MK-III Manual de usuario

Eagletone

Eagletone 6 Eyes Flower Manual de usuario

EuroLite

EuroLite FLD-1508 Manual de usuario

Technical Pro

Technical Pro LG8xSEA Manual de usuario

JB Systems

JB Systems Lounge Laser DMX Manual de usuario

Lightmaxx

Lightmaxx Vega Halo 90 Manual de usuario

Elation

Elation FUZE WASH Z350 Manual de usuario

Maverick

Maverick MK3 WASH Manual de usuario

Infinity

Infinity TF-260C7 Fresnel Manual de usuario

Chauvet

Chauvet EVE E-50Z Manual de usuario

Eliminator Lighting

Eliminator Lighting E 138 Manual de usuario

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manual de usuario

KAM

KAM DMX Laser80 FScan Manual de usuario