9
7. Programming and Calibration
In this section you will find the programming and calibration procedure of indicator
according to your application. The signs those take place on the lower right corner of the
keys indicate the function of the keys in programming menu. The basic meanings of these
keys are given in the table below.
Exit without
saving Advancing
next
parameter
Get back to
previous
parameter
will be
changed
Changing
parameter
value or
increasing the
blanking digit
Enter
7.1 Entering the Programming and Calibration Menu
Press F and Info keys sequentially to enter the Programming and Calibration Menu. First
[FunC ] and then [PASSWr ] prompts will be seen on the display sequentially. Here you
can enter to the parameters block by using the service password (Zero and Info) or the
operator password (Tare) and confirm with Enter. The calibration jumper (See Section 2.2)
should be short circuit to change the metrological related parameters .
Programming and Calibration menu consist of main blocks which are shown as [X-- ]
and sub-blocks. By using ↑and ↓keys you can reach previous or next main blocks.
After reaching the desired main block, you can get in by pressing Enter key. As you enter
the block you will reach the first sub-block in that main block. The sub-block address will
be seen on the display as [X0- ]. You can also search between the sub-blocks by using
↑and ↓keys and reach the first parameter of the sub-block seen on the display by
pressing Enter key. The number of the parameter comes on display as [XY0 ]. Again you
can search between parameters by ↑and ↓keys. For entering numerical value in the
parameters, press the tare key to select the digit and press the zero key the change the
value.
7.2 Exiting the Programming and Calibration Menu
If you press F key on which parameter you are, you will get out of the active sub-block and
reach the next sub-block. If you press F key again, you will get out of the active block and
reach the next main block. If you press F key once again, the [SAvE ] message appears
on the display. Here you can press Enter key to save the changes into the memory, or you
can press Tare key to store the changes until the power goes off, or you can press F key
to abort changes. [Waıt] message will be seen on the display for a little while, and
automatically get back to weighing mode.
Especially for legal metrological usage, please don’t forget to turn the power off and
remove the calibration jumper to start operation.
