Technical Specifications
DIMENSIONS
Base 1
5/8"
(4cm) x 2
1/4"
(5.5cm), Height
(including removable protective cap) 2
1/2"
(6cm), Brackets 1
1/4"
(3.5cm) x
5/8"
(1.5cm)
x
1/8"
(3mm).
WEIGHT
Battery Brain 175gm, Accessories 280gm,
Packaging 3gm; Total weight 408gm (1Ib).
CURRENT
SPECIFICATIONS
Operational Current Consumption for Silver-
Remote reconnection (Type
II)
&Gold-Remote/
Anti-theft (Type
III)
After disconnect: 3.8
Milliamps.
Operational Current Consumption for Bronze
(Type
I)
&Gold-Wired Push Button (Type
IV)
After disconnect: 0Milliamps
Maximum Peak Amperage: 1100 Amps, for 15
consecutive seconds.
Continuous Amperage Capacity: 250 Amps.
Disconnect Voltage Threshold: 11.8V
Disconnect Voltage Threshold for Gold-Auxiliary
(Type
IV
RV):
10.5V
OPERATIONAL TEMPERATURE RANGE
-60°F (-51°C)
to
200°F (90°C). Battery Brain is
made
of
non-combustible materials.
BATTERY SAFETY WARNING!
When working with lead acid batteries and
accessories, caution
must
be employed:
•Shield eyes. Do not open vent caps
or
puncture battery casing
in
any way.
•Sulfuric acid can cause blindness
and severe burns. •Rinse hands and flush eyes
with
water
immediately. •Avoid sparks, flames
and smoking.
PROPOSITION 65 WARNING
Battery posts, terminals, and related
accessories contain lead and lead compounds.
Chemicals known
to
the State
of
California
to
cause cancer and reproductive harm. Wash
hands after handling.
Battery Brain
GENERAL
The Battery Brain is installed on
the
positive
(+)
battery post with the post clamp provided. The
clip end
of
the black ground wire
is
fastened
to
the negative (-) post clamp bolt.
HELPFUL
HINT
The positive
(+)
bracket on the Battery Brain for
the positive
(+)
post clamp is on the same side
of
the Battery Brain unit with "12V+" printed on it.
TOOLS REQUIRED
Tools required may vary based on your vehicle.
The most
common
tools are; Open-end 5/16",
9/16", 1Omm, 12mm,14mm,
or
adjustable
wrench. Standard and Phillips screwdrivers.
REMOTE CONTROL USERS
Save a
copy
of
the
identification number on
the
back
of
your remote control.
You
will need it
to
order areplacement if lost.
IMPORTANT NOTE
Before beginning installation, be sure your
battery is holding the proper charge. If your
battery does not hold aminimum charge, it
may
be at the end
of
its lifecycle. The Battery Brain
is designed
to
protect aproperly functioning
or
new battery. It cannot restore
or
repair a
damaged battery. If your vehicles battery
shows
any signs
of
physical damage such as swelling,
leaking
or
cracking, replace
the
battery prior
to
installing Battery Brain.
IMPORTANT NOTE
Unless you are fully familiar with your vehicles
electrical system it is recommended
that
installation
of
this product is performed
by
a
certified technician.
IMPORTANT NOTE
This
product
is not intended
for
Marine use
and should not be submerged in water. Units
specifically designed for Marine use are
available, see www.smgy.netlbatterybrain for
more information.
