BL-ETH-SW Ethernet Switch
Pedestal Installation Guide
1-866-294-5847 Rev 10042016 www.baselinesystems.com
Side Wall Mounting Instructions
1. Find the orange power connector on the wires coming from the transformer. Gently pull the
connector away from the board to disconnect the power. See the photo on the previous
page for the location of the orange power connector.
2. Move the Ethernet radio module out of the way:
Remove the screws used to mount the Ethernet radio module to the back wall. You
may be able to move the Ethernet radio module toward the center of the pedestal
without disconnecting the power and antenna cables. If not, remove the power and
antenna cables, and then set the Ethernet radio module aside in a clean location.
3. On the inside left wall, remove the nuts on the lower edge of the external antenna assembly,
and then remove the screws. Set the nuts aside to be reused later.
4. Align the holes on the Ethernet switch
mounting plate with the holes on the inside
wall of the pedestal.
Note: The photo on the right shows a cell
modem module on the mounting plate
with the Ethernet switch. The cell modem
module may not be present in your
configuration.
5. Locate the 2 long screws that were provided
with the Ethernet switch. Working from the
outside of the pedestal, push the screws
through the holes on the pedestal wall and
through the holes on the Ethernet switch
mounting plate.
6. Thread the nuts onto the screws and tighten
them.
7. Replace the Ethernet radio module and reconnect the power and antenna cables if
necessary.
8. Continue with the Power Connector Instructions on the next page.
