BARRON EXITRONIX LL30 Series Manual de usuario

LL30 SERIES

INSTALLATION INSTRUCTIONS

SAVE THESE INSTRUCTIONS!

READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY

• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

•Installation and servicing of this equipment should be performed by qualified service personnel only.

•Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.

•Do not mount near gas or electrical heaters.

•Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

•The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

Any modification or use of non-original components will void the warranty and product liability.

•Do not use this equipment for other than intended use.

800.533.3948 •www.barronltg.com

10070057 Rev 4 - 02/14

INSTALLATION INSTRUCTIONS

1. Mount steel bracket (5) to junction box, using hardware provide with junction box.

2. All Electrical connection should be made inside junction box.

Make Electrical Connection as follows:

120V AC 277V AC

White - Common White - Common

Black - 120V Orange - 277V

Green - Ground Green - Ground

Note: Cap unused leads to prevent shorting.

3. Mount Emergency light unit to the steel bracket (5).

4. Remove lamp cover (1) by removing the cover hold plug (6).

5. Remove cover housing (2) by loosening four cover housing screws (7).

6. For additional mounting support knockout key hole and use appropriate hardware for mounting surface.

7. Use supplied wire nuts to connect lamp leads with lamp power leads (Purple and Yellow).

8. Make appropriate battery lead connection:

• Red lead to positive (+) terminal.

• Blue lead to negative (-) terminal.

9. Reinstall cover housing (2) carefully to avoid damaging LED AC ON indicator, retightening for screws (7)

10. Reinstall lamp cover (1) by replacing the cover hold plug (6).

11. Turn on power supply.

SELF-DIAGNOSTICS TESTING:

1. NORMAL OPERATION

When unit is functioning properly with A.C. power supplied, the status indicator will be green.

2. TESTING

The exit performs two types of test, Contingency and Non-Contingency.

The contingency testing includes “Battery Disconnected Mode” and “Lamp Failure Mode”. When the Battery is

disconnected, the indicator would indicate as Red (Steady). When the Lamp fails, the indicator would indicate as Red

(Blinking - three times). The Non-Contingency test is for testing the Battery for its “discharging” and “recharging”

capacity. A 1minute battery discharge test is performed every 30 days to check for the normal operation of the battery

and the unit. Also a full 90 minute discharge this is performed once a year to confirm the same. When the battery is in

discharging mode, the LED indicator would be a flashing Green (Three/Four Pulses). Upon completion of the test and

after 24 hours battery charging (Indicator on Red and Green flashing), the status indicator will return to either Green

(Steady) indicating a properly functioning unit or Red (Double Pulse) to show a battery failure. The following table

shows the status indication.

MANUAL TESTING:

Battery and Lamp test may be manually

initiated by pressing the manual test switch.

Once the test switch is pressed, the unit

would be reset and the date of battery

self-testing would start counting again.

OPERATION:

During and electrical power failure, the

lamps will automatically come on for a

minimum of 90 minutes. To test this unit, the

battery needs to be charged initially for 2

hours before depressing the test switch.

On pressing the test switch, the emergency

lamps will illuminate. When the switch is

released, the lamps will turn off.

LL30 SERIES

INSTALLATION INSTRUCTIONS

800.533.3948 •www.barronltg.com

10070057 Rev 4 - 02/14

CAUTION This equipment is furnished with a low voltage

disconnect circuit to protect the battery from fully

discharging after its useful output has been used. Allow 24

hours recharge time after installation or power failure for

full load testing.

1. Lamp Cover

2. Cover Housing

3. Lamp

4. Base Housing

5. Mounting Bracket

6. Cover Hold Plug

7. Cover Housing Screw

8. Setting Screw

9. Battery

10. Circuit Board

11. Wire Nuts

12. Purple & Yellow

ACTION

REACTION AND LED INDICATION

Press test button once (Within 2 seconds) 30-second test: Green light – Single blinking

Press test button 2 times (Within 2 seconds)

15-minute test: Green light – Double blinking

Press test button 3 times (Within 2 seconds)

90-minute test: Green light – Triple blinking

FUNCTION

LED INDICATION

Exit is in Emergency Mode

Off

Exit is in Normal Mode

Green (Steady)

Battery Disconnected

Red (Steady)

Lamp Failure Red (Flashing 4 times)

Battery Fast Charging

Red and Green (Flashing Alternately)

Battery Failure*

Red (Flashing 2 times)

30 Second Battery Discharging Mode

Green (Flashing 1 time)

15 Minute Battery Discharging Mode**

Green (Flashing 2 times)

90 Minute Battery Discharging Mode***

Green (Flashing 3 times)

* = Happens only after battery discharges once in every 30 days or 1 year.

** = Occurs once in every 30 days.

*** = Occurs once in a year.

Otros manuales de Equipo de iluminación de BARRON

BARRON

BARRON Exitronix 900E Series Manual de usuario

BARRON

BARRON Exitronix NFT Series Manual de usuario

BARRON

BARRON CP-EMW Series Manual de usuario

BARRON

BARRON TRACE-LITE AXL2 Manual de usuario

BARRON

BARRON TRACE-LITE TL101 Manual de usuario

BARRON

BARRON Exitronix VEX-8 NEMA Manual de usuario

BARRON

BARRON EXITRONIX SCL Series Manual de usuario

BARRON

BARRON Speciality LED FBTCJ-24V Manual de usuario

BARRON

BARRON Exitronix SCL Series Manual de usuario

BARRON

BARRON Growlite GLB-315-A-120/277 Manual de usuario

BARRON

BARRON EXITRONIX EQUITY QMR Series Manual de usuario

BARRON

BARRON EXITRONIX ILX Series Manual de usuario

BARRON

BARRON Exitronix S900C Series Manual de usuario

BARRON

BARRON Trace-Lite E110 Manual de usuario

BARRON

BARRON Exitronix NFT Series Manual de usuario

BARRON

BARRON Growlite GRM Manual de usuario

BARRON

BARRON EXITRONIX VLEDC Series Manual de usuario

BARRON

BARRON Exitronix 400U Series Manual de usuario

BARRON

BARRON EXITRONIX 82 Series Manual de usuario

BARRON

BARRON specialtyLED FTK Manual de usuario

BARRON

BARRON Exitronix NY900C Series Manual de usuario

BARRON

BARRON EXITRONIX CRL Series Manual de usuario

BARRON

BARRON EXITRONIX VLED-90L Series Manual de usuario

BARRON

BARRON specialityLED RFX Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario