BARRON Exitronix 400U Series Manual de usuario

400U SERIES

INSTALLATION INSTRUCTIONS

800533.3948 •www.barronltg.com

10070143 Rev 1 - 03/14 1

SAVE THESE INSTRUCTIONS!

READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY

• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

• Installation and servicing of this equipment should be performed by qualified service personnel only.

• Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.

• Do not mount near gas or electrical heaters.

• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any

modification or use of non-original components will void the warranty and product liability.

• Do not use this equipment for other than intended use.

INSTALLATION INSTRUCTIONS

CANOPY MOUNTING (Top or Side-end mount.

1. Remove faceplate cover by pulling equally at the outer rim of the face plate on two opposite sides. Remove ground

wire from faceplate. (Fig. F)

2. Pop out plastic mounting hole cover on the top or side of the sign. Place one of the nuts from threaded stem rod in

the slot inside the housing just inside of the unit.(Fig. A).

3. Feed the AC supply and ground wire through the nut & hole and out of the sign housing (Fig. B)

4. Secure the canopy junction box cover to the mount area of the exit sign by inserting it and shifting it over to align the

hole.

5. Feed AC supply wires and ground wire through

threaded stem and screw stem into nut inside unit.

Screw the remaining nut for the threaded stem onto

the stem and tighten securely to complete the

mounting of the canopy to the exit sign (Fig. C)

6. All Electrical connections should be made inside

junction box.

Make Electrical connections as follows:

Note: Cap unused leads to prevent shorting.

120V AC

White - Common

Black -120V

Green - Ground

277V AC

White - Common

Orange - 277V

Green - Ground

Fig. A Fig. B

Fig. C

400U SERIES

INSTALLATION INSTRUCTIONS

800533.3948 •www.barronltg.com

10070143 Rev 1 - 03/14 2

7. Determine the position the exit needs to be mounted

(the way the face needs to be pointed). Use the

included round junction box mounting plate and small

#8-32 screws provide to tighten securely (Fig. E)

8. Remove the proper chevron(s) from the EXIT

legends(s) if necessary. Reattach the ground wire to

the faceplate (Fig. F)

9. Attach battery jumper wire (where applicable) to PC

board and replace face plate back on unit to complete

installation.

FLUSH MOUNTING

1. Remove faceplate cover by pulling equally at the outer

rim of the face plate on two opposite sides. Remove

ground wire from face plate (Fig. F)

2. Remove desired knockout on baseplate and mount to junction box using hardware supplied with junction box.

3. Route wires through the center knockout.

4. All Electrical connections should be made inside junction box.

Make Electrical Connections as follows:

Note: Cap unused leads to prevent shorting

5. Remove the proper chevron(s) from the EXIT legends(s) if necessary. Reattach the ground wire to the faceplate

(Fig. F).

6. Attach battery jumper wire (where applicable) to PC board and replace face plate back on the unit to complete

installation.

WIRING DIAGRAMS

Fig. F

Fig. E

Fig. D

120V AC

White - Common

Black -120V

Green - Ground

277V AC

White - Common

Orange - 277V

Green - Ground

Tabla de contenidos

Otros manuales de Equipo de iluminación de BARRON

BARRON

BARRON TRACE-LITE AXL2 Manual de usuario

BARRON

BARRON TRACE-LITE WTA Series Manual de usuario

BARRON

BARRON specialtyLED FTK Manual de usuario

BARRON

BARRON Growlite GLE-GL Manual de usuario

BARRON

BARRON EXITRONIX VLEDC Series Manual de usuario

BARRON

BARRON Exitronix CRL Series Manual de usuario

BARRON

BARRON EXITRONIX ILX Series Manual de usuario

BARRON

BARRON TRACE-LITE TL101 Manual de usuario

BARRON

BARRON EXITRONIX CRL Series Manual de usuario

BARRON

BARRON EXITRONIX LED-51 Series Manual de usuario

BARRON

BARRON Trace-Lite E110 Manual de usuario

BARRON

BARRON Growlite GRM Manual de usuario

BARRON

BARRON Exitronix S900C Series Manual de usuario

BARRON

BARRON Exitronix VEX-8 NEMA Manual de usuario

BARRON

BARRON Exitronix NY900C Series Manual de usuario

BARRON

BARRON Exitronix TPXC Series Manual de usuario

BARRON

BARRON EXITRONIX 400WX Series Manual de usuario

BARRON

BARRON Exitronix 900E Series Manual de usuario

BARRON

BARRON Trace-Lite AXL2 Manual de usuario

BARRON

BARRON Exitronix LED-90 Series Manual de usuario

BARRON

BARRON EXITRONIX VLED-90L Series Manual de usuario

BARRON

BARRON TRACE-LITE RHL-ACR Manual de usuario

BARRON

BARRON GROWLITE GRM Manual de usuario

BARRON

BARRON EXITRONIX LL30 Series Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario