B&D BND87624 Manual de usuario
Secure the mounting to
wall with screws and
adjust arm to desired
position
Connect the antenna
and AC adaptor to the
camera and switch on
Ensure your wireless
router is turned on and
ethernet cable
connected to camera
AND
Before you continue, make sure your Smart Hub is
online and you have the B&D App downloaded to
your smart phone.
STEP TWO
ELECTROCUTION! Be mindful not to drill into existing
wiring as this may result in serious harm and or death.
MOUNT THE CAMERA
STEP THREE
OPEN THE PACKAGING
STEP ONE
Open the App
and go into
the settings
Select:
Devices ->
Add Camera
Then select
the camera
listed at
t o p.
ADDING THE CAMERA
STEP FOUR STEP FIVE
Select how
your camera
will display
in the APP.
Then select
Save.
Once the camera is
registered, click Next
tip
CONSIDER: setting up camera via ethernet cable
before installing in position.
STEP SIX
Secure the mounting to
ceiling with screws and
adjust arm to desired
position
OR
WALL CEILING
WPSWPS
Router
Select:
Settings ->
Devices ->
Camera
Outdoor ->
Manage ->
Disconnect and connect
to outdoor power source
Then select
Refresh.
OPTIONAL: insert SD card into camera now for recording
before connecting power (requires FAT32 format, 32GB - 128GB)
Micro SD Card Slot
tip
CONSIDER: mounting the camera in a position that
provides a clear / unobstructed view.
refer to bnd.com.au for full warranty details.
CAMERA DETAIL
RESET THE CAMERA
To restore the camera back to factory settings:
1. Hold the Reset button for about 10 seconds with
the camera powered on.
2. Release the button and wait about 30 seconds.
The camera will automatically restart, and restore
factory settings.
CHANGE WI-FI NETWORK
First, setup the Smart Hub on the new network and
then:
1. Open the Smart Hub phone app and remove the
camera from the Smart Hub.
2. Reset the camera using the instruction above.
3. Re-follow the instructions “Adding the Camera”.
CONFIGURE THE CAMERA
STEP SEVEN
Antenna
Micro SD Card Slot
LENS
Infrared LED
LAN
Audio in /
Audio out
Power
Reset Button
Ceiling mounted
cameras, ip
image vertically
from button.
Image settings
can be
adjusted using
the camera
controls on the
stand alone
camera page.
You can receive
notications on
motion and/or
sound detection
and adjust the
sensitivity.
Select:
Settings ->
Devices ->
Your Camera
Manage ->
Detection Settings
1
tip
Check out the HELP menu on the home page in the
APP for more instructions
Tabla de contenidos
Otros manuales de Cámara de seguridad de B&D
