Azden 35HT Manual de usuario

INSTRUCTION MANUAL

310 DIVERSITY CAMERA-MOUNT

UHF WIRELESS MICROPHONE SYSTEM

310UDR - 35BT - 35HT - 35XT

Thank you for purchasing the Azden 310 Diversity Wireless Microphone system. The following

table will show you the contents of the system you ordered:

310LT

1 x 310UDR Diversity Receiver

1 x Stereo Mini-to-Dual XLR Cable

1 x Stereo Mini-to-Stereo Mini Cable

1 x 35BT Body-Pack Transmier

1 x EX-503L Lavalier Microphone

310HT

1 x 310UDR Diversity Receiver

1 x Stereo Mini-to-Dual XLR Cable

1 x Stereo Mini-to-Stereo Mini Cable

1 x 35HT Handheld Microphone/Transmier

310XT

1 x 310UDR Diversity Receiver

1 x Stereo Mini-to-Dual XLR Cable

1 x Stereo Mini-to-Stereo Mini Cable

1 x 35XT XLR Plug-in Transmier

310ULH

1 x 310UDR Diversity Receiver

1 x Stereo Mini-to-Dual XLR Cable

1 x Stereo Mini-to-Stereo Mini Cable

1 x 35BT Body-Pack Transmier

1 x EX-503L Lavalier Microphone

1 x 35HT Handheld Microphone/Transmier

310ULX

1 x 310UDR Diversity Receiver

1 x Stereo Mini-to-Dual XLR Cable

1 x Stereo Mini-to-Stereo Mini Cable

1 x 35BT Body-Pack Transmier

1 x EX-503L Lavalier Microphone

1 x 35XT XLR Plug-in Transmier

Operang the System

WARNING

・Do not use other baeries than the ones specied in this manual. Do not mix a fresh

baery with a used baery.

・When installing baeries, make sure baery polarity is correct as marked inside the

baery compartment.

・Remove the baeries if the products are not used for a long period of me.

・Do not submerge the products.

Because this is a frequency agile system, the receiver and transmier must be on the same

channel number. To change the channel selecon, use a small , sharp object such as the p of

a pen, and press the “UP” or “DOWN” buon to the desired channel. Make sure both the re-

ceiver and transmier are on the same channel.

310UDR Diversity Receiver

Aer installing new baeries, mount the receiver to your video camera with supplied

shoe mount or hook & loop fastener. Select one of the supplied cables and connect the

output on the receiver and input on the video camera. Turn the power switch to “ON”

and the baery level indicator on the LCD display should come on. If not, check the

baeries. When the 310UDR receives a signal from the transmier, the recepon level

indicator will come on. If it does not, make sure both the receiver and the transmier

are on matching channels.

35BT Body-Pack Transmier

Plug in the supplied EX-503L Lavalier Microphone and clip it to your subject. The micro-

phones should be placed 4”-12” from the subject’s mouth. Clip the transmier to a

belt by using the supplied belt clip or place it in a pocket. Turn the power switch to

“ON” and the baery level indicator on the LCD display should come on. If not, check

the baery. Have someone speak into the microphone as you monitor the sound

through the 310UDR Receiver’s phone output. If the sound is distorted, lower the MIC

input level on the 35BT Transmier. If there is not enough volume, raise the MIC input

level on the Transmier.

35XT Plug-in Transmier

Aach the 35XT Transmier to any low impedance microphone with a corresponding 3-

pin XLR connector. Turn the power switch on the 35XT Transmier to “ON” posion

and the baery level indicator on the LCD display should come on. Have someone

speak into the microphone as you monitor the sound through the camera’s monitor

output. If the sound is distorted, lower the MIC input level control on the 35XT Trans-

mier. If there is not enough volume, raise the level control on the Transmier.

310UPR Diversity Receiver

① Antennas

For the best recepon, the antennas should be pointed in an upward posion. Use cau-

on and do not force them into this posion.

② Power Switch

To turn ON/OFF the receiver

③ LCD Display

The LCD Display shows mulfunconal readout. Refer to “LCD Display Readouts” in this

manual for further details.

35HT Handheld Microphone/Transmier

Turn the power switch on the 35HT Transmier to “ON” posion and the baery level

indicator on the LCD display should come on. Have someone speak into the micro-

phone as you monitor the sound through the camera’s monitor output. Adjust the MIC

input level control accordingly.

①

②

③

④

⑤⑥

⑦

④ CHANNEL UP and DOWN Buon

To change the channel number, use a small, sharp object, such as the p of a pen, and

press the UP or DOWN buon unl the desired channel number is shown on the LCD

Display. Keep the buon pressed down to fast forward the channel numbers. Once the

desired channel number is selected on the receiver, set the transmier to the same

number.

⑤ PHONE Jack

This jack allows you to monitor the sound.

⑥ MIC OUT Jack

The 310UDR is supplied with both mini-to-mini and mini-to-dual XLR cables.

For mini jack microphone inputs: Use the supplied mini-to-mini cable. Plug one

end of the cable into the 310UDR Receiver and the other end into the micro-

phone input of the video camera.

For 3-pin XLR microphone inputs: Use the supplied mini-to-dual XLR cable. Plug

the mini-plug end of the cable into the 310UDR Receiver (use the screw-down

sleeve to secure it to the receiver) and plug the XLR ends into the microphone

inputs on the video camera.

⑦ Baery Compartment

Remove the baery compartment lid by sliding it down. Install two fresh alkaline “AA”

baeries. Make sure the baery polarity is correct as marked inside the baery com-

partment. Alkaline baeries are preferred, but Azden’s 1HR-3U rechargeable Ni-MH

baeries may be used.

LCD Display Readouts

a. TV channel number (30 – 33)

b. Transmit channel number (01 -47)

c. Recepon level indicator: 4 bars = High, 1 bar = Low

d. Baery level indicator: 3 bars = High, 1 bar = Low

35BT Body-Pack Transmier

BATT

LEVEL

30-02

⑧ Baery Compartment

Remove the baery compartment lid by sliding it down. Install two fresh alkaline “AA”

baeries. Make sure the baery polarity is correct as marked inside the baery

compartment.

⑨ Install two fresh alkaline “AA” baeries. Make sure the baery polarity is correct as

marked inside the baery compartment.

Inside the baery compartment, you will also nd:

⑩ MIC Input Level Control

This control enables you to adjust the input level of the microphone. Using the

supplied tool, also found inside the baery compartment, turn the orange dial

clockwise to increase, or counterclockwise to decrease the input level.

⑪ POWER Switch

Switches the 35BT Transmier “ON” or “OFF”.

⑫ MIC Input Jack

Plug the supplied EX-503L Lavalier Microphone into the MIC input jack. In addion to

the EX-503L, other lapel and/or headset microphones with 3.5mm mini plug may also

be used with the 35BT.

⑬ LCD Display

The display shows the following informaon:

TV Ch – Transmit Channel Number (i.e. 30 – 01, 31 – 12, 33 – 47)

The TV – Transmit channel display is made of two parts. The rst two digit

number is the actual TV channel (30-33) and the second two digit is the

transmit channel number (01-47).

Baery level by 3-bar indicator (3 bars = High, 1 bar = Low)

⑭ AUDIO Switch

It is best to set the AUDIO switch to “OFF” prior to rst turning the POWER switch “ON”.

When you are ready to begin transming, turn the AUDIO “ON”. The “OFF” posion

acts as “mute” that maintains the RF signal but turns o the audio.

35XT Plug-in Transmier

⑮ Baery Compartment

Open the baery compartment lid by pushing down on the tab and liing it up. Install

two fresh alkaline “AA” baeries. Make sure the baery polarity is correct as marked

inside the baery compartment.

⑯ POWER Switch

Turns the 35XT Transmier “ON” or “OFF”.

⑰ AUDIO Switch

It is best to set the AUDIO switch to “OFF” prior to rst turning the POWER switch

“ON”. When you are ready to begin transming, turn the AUDIO “ON”. The “OFF” po-

sion acts as “mute” that maintains the RF signal but turns o the audio.

⑱ MIC Connector/Locking Ring

This 3-pin XLR connector is the microphone input. Any low impedance microphone

with a corresponding connector may be plugged here. Once the microphone is plugged

into the 35XT, the locking ring should be rotated clockwise unl snug. To remove the

microphone, rst rotate the locking ring counterclockwise and then pull the micro-

phone away while pressing the XLR release.

⑲ MIC Input LEVEL Control

This enables you to adjust the input level of the connected microphone. Using the sup-

plied tool, turn the orange dial clockwise to increase, or counterclockwise to decrease

the input level.

⑳ LCD Display

The LCD display shows the following informaon:

TV Ch – Transmit Channel Number (i.e. 30 – 01, 31 – 12, 33 – 47)

The TV – Transmit channel display is made of two parts. The rst two digit

number is the actual TV channel (30-33) and the second two digit is the

transmit channel number (01-47).

Baery level by 3-bar indicator (3 bars = High, 1 bar = Low)

AF (Audio Frequency) level by 4-bar indicator (4 bars = High, 1 bar = Low)

To change the channel number, use the p of the tool provided and press the UP or

DOWN buon unl the desired channel number is shown on the LCD Display. Keep the

buon pressed to fast forward the channel numbers.

35HT Handheld Microphone/Transmier

㉑ Baery Compartment Cover

Remove the baery compartment cover by rotang it counterclockwise and sliding it

down.

㉒ Baery Compartment

Install two fresh alkaline “AA” baeries. Make sure the baery polarity is correct as

marked inside the baery compartment.

Este manual sirve para los siguientes modelos

Otros manuales de Sistema de micrófono de Azden

Azden

Azden 310UDR Manual de usuario

Azden

Azden EX-503 Manual de usuario

Azden

Azden UHF Performance Series Manual de usuario

Azden

Azden 1000URX-Si Manual de usuario

Azden

Azden 100UPR Manual de usuario

Azden

Azden PRO-XR Manual de usuario

Azden

Azden WHX-PRO Manual de usuario

Azden

Azden i-coustics pro-xd Manual de usuario

Azden

Azden 100UPR Manual de usuario

Azden

Azden 300UPR Manual de usuario

Azden

Azden 330UPR Manual de usuario

Azden

Azden 330UPR Manual de usuario

Azden

Azden 1200URX/Si Manual de usuario

Azden

Azden 330UPR Manual de usuario

Azden

Azden 330UPR Manual de usuario

Azden

Azden Body-pack Transmitter 35BT Manual de usuario

Azden

Azden 1200BT Manual de usuario

Azden

Azden EX-503 Manual de usuario

Azden

Azden WLX-PRO Manual de usuario

Azden

Azden WHX-PRO Manual de usuario

Azden

Azden 10BT Manual de usuario

Azden

Azden 500UDR Manual de usuario

Azden

Azden WLX-PRO Manual de usuario

Azden

Azden IRB-10 Manual de usuario

Manuales populares de Sistema de micrófono de otras marcas

Paso

Paso R824 Manual de usuario

Naxa

Naxa NAM-982 Manual de usuario

Motorola

Motorola PMNN4461 Manual de usuario

Xvive

Xvive U3 Manual de usuario

Tekon

Tekon DUOS Manual de usuario

Heyuan Intelligence

Heyuan Intelligence IOT-G2S-01 Manual de usuario

Devine

Devine WMD-IE Manual de usuario

LG LF-D7150 Manual de usuario

GE S768DAV Manual de usuario

LD U305 HBH 2 Manual de usuario

Chainway

Chainway URA8 Manual de usuario

ORATOR

ORATOR D860TD Manual de usuario

Sennheiser

Sennheiser Evolution Wireless Digital EW-DX EM 2 Manual de usuario

Alpha Technologies

Alpha Technologies RBMS Manual de usuario

SWIT Electronics Co.,LTD.

SWIT Electronics Co.,LTD. CW-S150 Manual de usuario

Shure

Shure UA844 Manual de usuario

Panasonic

Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Manual de usuario

Pyle

Pyle PDWM5000 Manual de usuario