Axis T90C10 Manual de usuario
ENGLISH DEUTSCH ITALIANO ESPAÑOL
USER GUIDE
FRAN
Ç
AIS
AXIS T90C10 Fixed Dome IR-LED
AXIS T90C20 Fixed Dome IR-LED
ENGLISH
ENGLISH
Safeguards
Please read through this User Guide carefully before installing the product. Keep the User Guide for further
reference.
CAUTION!
• When transporting the Axis product, use the original packaging or equivalent to prevent damage to the
product.
• Store the Axis product in a dry and ventilated environment.
• Only use handtools when installing the Axis product, the use of electrical tools or excessive force could
cause damage to the product.
• Do not use chemicals, caustic agents, or aerosol cleaners. Use a damp cloth for cleaning.
• Only use accessories and spare parts provided or recommended by Axis.
• Do not attempt to repair the product by yourself, contact Axis or your Axis reseller for service matters.
IMPORTANT!
• This Axis product must be used in compliance with local laws and regulations.
AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide Page 5
ENGLISH
AXIS T90C10/T90C20 Fixed Dome IR-LED
This guide provides instructions for installing the AXIS T90C10/ AXIS T90C20 IR-LED with the
following fixed dome cameras:
• AXIS P3343-VE
• AXIS P3344-VE
• AXIS P3346-VE.
To install the camera, refer to the installation guide supplied with the product.
The contents of this guide are as follows:
1.
Package Contents
. See below.
2.
Installation
, on page 8.
3.
Specifications
, on page 12.
Package Contents
Item Models/variants/notes
Lighting Module • PoE Cat 5 cable
(for AXIS T90C20 Fixed Dome IR-LED)
• 18-56V DC Power Control cable
(for AXIS T90C10 IR-LED)
Printed materials AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide
(this document), Axis Warranty Document
Page 6 AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide
Hardware Overview
AXIS P33 Fixed Dome camera
Photocell
IR-LED
PoE Cat 5 or 18-56 V DC Power
(pre-mounted)
5-meter cable
Specifications subject to change without notice. Installation to be carried out by trained and qualified personnel.
AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide Page 7
ENGLISH
Recommendations
This Axis product is delivered with the LED block facing the front and this positioning is appropriate
for most installations; it is however possible to move the LED block to face other directions. See
page 10.
Use screws appropriate for your wall material.
20-30m
Max illumination
Less illumination Less illumination
120˚
Page 8 AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide
Installation
Notes:
• When the IR-LED is installed, the camera cables can only be routed through the wall (not along the wall).
•The
IR-LED is controlled by the level of ambient light which is detected by the unit's photocell. Ensure that
the photocell is not obstructed or covered.
1. If the camera is already installed, disconnect power from the camera; remove the weather
shield, and the dome cover on the camera; remove the unit casing from the mounting bracket;
detach the camera unit.
If the camera is not already installed, attach the mounting bracket to the wall. Please check the
camera’s installation guide for this and further installation procedures.
2. Remove the side lid from the unit casing; save the screw.
If the camera lens is to face right or left, please read the information on page 10 before you
proceed.
3. Remove the gasket from one of the side holes and
from the corresponding back hole in the unit casing,
for cabling. (The cable for the IR-LED should enter
the hole to the left in the unit casing)
Route the IR-LED cable through the side hole and
through the back hole in the unit casing.
4. Force the 2 gaskets on the cable through the side
hole.
Mounting bracket
Unit casing
Dome cover
Weather shield
Side holes
Back hole
Back hole
Side lid
Screw
Unit casing
Gaskets in side
and back holes
AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide Page 9
ENGLISH
5. Plug the gaskets into the side and back holes. The gaskets should fit snugly in the holes with no
folds or bends.
6. Place the IR-LED beneath the unit casing
aligning the screw hole on the back of the
IR-LED with the screw hole in the unit
casing; screw the IR-LED on to the unit
casing with the single screw.
7. Attach the unit casing to the mounting
bracket.
8. For vandal-resistant installation do the following:
a. Detach the cover on the IR-LED.
b. Screw the IR-LED to the wall with 2 screws.
c. Replace the cover after ensuring the gasket is in place.
9. Connect the network cable from the IR-LED to the PoE switch or midspan (AXIS T90C20); or
connect the DC cable to the PSU (AXIS T90C10).
10. To complete the camera installation please refer to the installation guide provided with the
network camera.
Screw IR-LED
Back view
Screw here
Screw here
Front view
Page 10 AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide
AXIS T90C20
When camera lens faces left
1. Remove 2 screws located on the top on either side of the LED block.
2. Unscrew the ground wire from the screw hole to the left and attach to a screw hole to the
right.
3. Align the LED block with the screw holes to the left and fasten the 2 screws again.
When camera lens faces right
1. Remove 2 screws located on the top on either side of the LED block.
2. Unscrew the ground wire from the screw hole to the left and attach to a screw hole to the
right.
3. Loosen the cable gland and pull a greater length of the cable so it can reach the left side of the
IR-LED.
4. Remove 2 screws on the control board and fasten the control board to the left.
5. Fix the LED block where the control board was with 2 screws.
LED block
2 screws on LED block
LED block to the left
LED block to the right
2 screws on control
board
LED block
Control board
LED block to the center
Cable gland
Ground wire
Otros manuales para T90C10
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Idiomas:
Otros manuales de Cámara de seguridad de Axis
Axis
Axis Q6032-E PTZ Manual de usuario
Axis
Axis M3106-L Manual de usuario
Axis
Axis Q35 Series Manual de usuario
Axis
Axis Q6054 Mk II Manual de usuario
Axis
Axis P5512 Manual de usuario
Axis
Axis ExCam XF P1377 Manual de usuario
Axis
Axis M30 Series Manual de usuario
Axis
Axis Q8741-E Manual de usuario
Axis
Axis NETWORK CAMERA 2100 Manual de usuario
Axis
Axis Q1941-E Manual de usuario
Axis
Axis M3113-VE Nocap Manual de usuario
Axis
Axis AXIS 231D+ Manual de usuario
Axis
Axis P5624-E Manual de usuario
Axis
Axis Q6045-E Manual de usuario
Axis
Axis Q16 Series Manual de usuario
Axis
Axis Axis 216FD Manual de usuario
Axis
Axis P1447-LE Manual de usuario
Axis
Axis AXIS P3374-V Manual de usuario
Axis
Axis AXIS Q6042-E Manual de usuario
Axis
Axis Fixed Dome Network Camera AXIS P3301-V Manual de usuario
