AXIOMTEK AX92801 Series Manual de usuario
AX92801 Series
Dual Intel®Gigabit LAN By-Pass
Adapter Card
User’s Manual
ii
Disclaimers
This manual has been carefully checked and believed to contain
accurate information. AXIOMTEK Co., Ltd. assumes no responsibility
for any infringements of patents or any third party’s rights, and any
liability arising from such use.
AXIOMTEK does not warrant or assume any legal liability or
responsibility for the accuracy, completeness or usefulness of any
information in this document. AXIOMTEK does not make any
commitment to update the information in this manual.
AXIOMTEK reserves the right to change or revise this document
and/or product at any time without notice.
No part of this document may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, electronic,
mechanical, photocopying, recording, or otherwise, without the prior
written permission of AXIOMTEK Co., Ltd.
CAUTION
If you replace wrong batteries, it causes the danger of explosion. It is
recommended by the manufacturer that you follow the manufacturer’s
instructions to only replace the same or equivalent type of battery,
and dispose of used ones.
©Copyright 2007 AXIOMTEK Co., Ltd.
All rights reserved
June 2007, Version A1
Printed in Taiwan
iii
ESD Precautions
Computer boards have integrated circuits sensitive to static electricity.
To prevent chipsets from electrostatic discharge damage, please take
care of the following jobs with precautions:
Do not remove boards or integrated circuits from their anti-static
packaging until you are ready to install them.
Before holding the board or integrated circuit, touch an unpainted
portion of the system unit chassis for a few seconds. It
discharges static electricity from your body.
Wear a wrist-grounding strap, available from most electronic
component stores, when handling boards and components.
Trademarks Acknowledgments
AXIOMTEK is a trademark of AXIOMTEK Co., Ltd.
Windows®is a trademark of Microsoft Corporation.
Phoenix & AWARD are trademarks of Phoenix Technology Ltd.
IBM, PC/AT, PS/2, VGA are trademarks of International Business
Machines Corporation.
Intel®and Pentium®are trademarks of Intel Corporation.
Other brand names and trademarks are the properties and registered
brands of their respective owners.
iv
Table of Contents
Chapter 1 Introduction................................................................... 1
1.1 Specifications ........................................................................ 2
1.2 Mechanical/Environmental.................................................... 3
1.3 Features ................................................................................ 3
Chapter 2 Jumpers and Connectors ............................................ 5
2.1 Placement............................................................................... 5
2.2 Jumper Settings...................................................................... 6
2.3 Connectors........................................................................... 10
Appendix ........................................................................................ 11
AX92801 Gigabit LAN By-Pass Adapter Card User’s Manual
Introduction 1
C h a p t e r 1
Introduction
AX92801 is a PCI 32-bit LAN by-pass adapter card that supports dual
gigabit ports w/WDT (Watch Dog Timer) for LAN by-pass feature
enabling. The LAN by-pass function ensures all network traffic
passing through the device in the event of a host system failure,
power off, or upon software request. It can keep working mutually for
two specific network segments even when the network device is
losing power or hanging up. The LAN by-pass feature can be
controlled by software, or by a watchdog timer that any connections
received at one interface are immediately passed on to the other
interface.
Network traffic can be migrated by the adapter card with concurrent
network appliance platforms of VPN, UTM, other network security
applications and embedded box solutions.
This card supports two Intel®82541PI LAN chipsets that provides
micro code for Linux kernel to let your customers easily implement it
with their application programs.
AX92801 Gigabit LAN By-Pass Adapter Card User’s Manual
Introduction
2
1.1 Specifications
Interface PCI 32-bit/33MHz
LAN Chipset Intel®82541PI
Protocol IEEE802.3ab, 1000Base-T
IEEE802.3u, 100Base-TX
IEEE802.3, 10Base-T
Media Interface 2-Port RJ-45 w/LED (Act/Link and
Transfer rate)
Cabling Category 5/5e or above, 4-pair
Length 100 meters maximum
LAN Two LAN (10/100/1000Mbps) ports
support LAN by-pass.
These LAN ports feature the Intel®
82541PI, a highly efficient Gigabit
Ethernet Controller to provide
optimized Gigabit networking for
power-sensitive designs.
These two LAN ports also support
Intel®teaming feature.
These two LAN ports share one (32-
bit/33MHz) bus bandwidth through
Arbiter or PICMG mode.
OS Compatibility Linux kernel 2.4 & 2.6
Redhat Linux 2.4 and 2.6 Kernel
Support SDK in Linux environment
with the micro code for LAN by-pass
function that can be enabled by
customer’s application programs.
Others Support Auto MDI / MDI-X feature
and Integrated 128K Byte Frame
Buffer memory.
AX92801 Gigabit LAN By-Pass Adapter Card User’s Manual
Introduction 3
1.2 Mechanical/Environmental
Form Factor PCI 32-bit (120mm x 70mm)
LED Link/Act with Transfer rate (RJ-45),
LAN by-pass (pin header)
Operating Temp. 0°C ~ 60°C
Storage Temp. -20°C ~ 70°C (-4~158°F)
Humidity 5% - 95% RH, non-condensing
1.3 Features
zDual Gigabit ports w/LAN bypass function
zJumper selection by PICMG or Arbiter control mode
zSupport WDT function for LAN by-pass enabling
zMicro code supports different Linux for the software integration
zSuitable LAN by-pass function implementation for Network
Appliance ; VPN, UTM, Network Bandwidth controller,
SSL/TLS, Firewall and other embedded box applications
NOTE: Specifications are subject to change without notice.
AX92801 Gigabit LAN By-Pass Adapter Card User’s Manual
Introduction
4
MEMO
AX92801 Gigabit LAN By-Pass Adapter Card User’s Manual
Jumpers and Connectors 5
C h a p t e r 2
Jumpers and Connectors
2.1 Placement
Length 120 mm
Width 70mm
,
excludin
g
the
g
old colored contacts.
AX92801 Gigabit LAN By-Pass Adapter Card User’s Manual
Jumpers and Connectors
6
2.2 Jumper Settings
Proper jumer settings configure the AX92801 to meet your application
purpose. We are herewith listing a summary table of all jumpers and
default settings for onboard devices, respectively.
Description Function Jumper Setting
Mode
Selection
After Power
On
Bypass
Mode
JP1
Normal
Mode
(Default)
JP1
Lan1 ID PCI AD25
(Default)
JP2
PCI AD30 JP2
PCI AD31 JP2
Tabla de contenidos
Manuales populares de Tarjeta de red de otras marcas
3Com
3Com EtherLink 3C509B Manual de usuario
TRENDnet
TRENDnet TEG-PCITX Manual de usuario
Cisco
Cisco MC16E Manual de usuario
Delta Electronics
Delta Electronics Braking Modules VFDB Series Manual de usuario
TwinMOS
TwinMOS Booming Manual de usuario
Dialogic
Dialogic Media Board DM/V1200BTEPEQ Manual de usuario
Buffalo
Buffalo AirStation WLI-PCM-L11GP Manual de usuario
National Instruments
National Instruments NI 9234 Manual de usuario
Hama
Hama 49276 Manual de usuario
Linksys
Linksys WCF54G - Wireless-G Compact Flash Card Manual de operación
Compaq
Compaq Wireless LAN 100 Manual de usuario
Bose
Bose PowerMatch Dante Manual de usuario