AXIOMTEK P6151-V3 Manual de usuario

P6151-V3

15” XGA TFT Monitor

User’s Manual

Disclaimers

This manual has been carefully checked and believed to contain accurate information.

Axiomtek Co., Ltd. assumes no responsibility for any infringements of patents or any third

party’s rights, and any liability arising from such use.

Axiomtek does not warrant or assume any legal liability or responsibility for the accuracy,

completeness or usefulness of any information in this document. Axiomtek does not make any

commitment to update the information in this manual.

Axiomtek reserves the right to change or revise this document and/or product at any time

without notice.

No part of this document may be reproduced, stored in a retrieval system, or transmitted, in

any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,

without the prior written permission of Axiomtek Co., Ltd.

CAUTION

If you replace wrong batteries, it causes the danger of explosion. It is recommended by the

manufacturer that you follow the manufacturer’s instructions to only replace the same or

equivalent type of battery, and dispose of used ones.

July 2021, Version A1

Printed in Taiwan

iii

Safety Precautions

Before getting started, read the following important cautions.

1. Be sure to ground yourself to prevent static charge when installing the internal

components. Use a grounding wrist strap and place all electronic components in any

static-shielded devices. Most electronic components are sensitive to static electrical

charge.

2. Disconnect the power cords from the P6151-V3 Series before making any installation. Be

sure both the system and the external devices are turned OFF. Sudden surge of power

could ruin sensitive components. Make sure the P6151-V3 Series is properly grounded.

3. Do not open the system’s top cover. If opening the cover for maintenance is a must, only

a trained technician is allowed to do so. Integrated circuits on computer boards are

sensitive to static electricity. To avoid damaging chips from electrostatic discharge,

observe the following precautions:

◼Before handling a board or integrated circuit, touch an unpainted portion of the

system unit chassis for a few seconds. This will help to discharge any static

electricity on your body.

◼When handling boards and components, wear a wrist-grounding strap, available

from most electronic component stores.

Trademarks Acknowledgments

Axiomtek is a trademark of Axiomtek Co., Ltd.

Windows®is a trademark of Microsoft Corporation.

IBM, PC/AT, PS/2, VGA are trademarks of International Business Machines Corporation.

Intel®and Pentium®are trademarks of Intel Corporation.

AMI is trademark of American Megatrend Inc.

Other brand names and trademarks are the properties and registered brands of their

respective owners.

iv 
 
Table of Contents 
 
 
Disclaimers.....................................................................................................ii 
Safety Precautions........................................................................................iii 
Section 1 Introduction............................................. 1 
1.1 General Description............................................................................1 
1.2 Features...............................................................................................2 
1.3 Specifications......................................................................................2 
1.4 Dimensions and Outlines ...................................................................3 
1.5 I/O Outlets............................................................................................4 
1.6 Packing List.........................................................................................5 
Section 2 System Setup .......................................... 7 
2.1 System Configuration.........................................................................7 
2.2 Panel Mounting ...................................................................................8 
2.3 Wall Mounting......................................................................................8 
2.4 VESA Mounting ...................................................................................9 
2.5 OSD Key Configuration ......................................................................9 
Appendix A Supported Input Timing Modes ............. 11 
Appendix B OSD Operation........................................ 13 
Function Description of OSD Menu............................................................13 
 
 

P6151-V3 User’s Manual

Introduction 1

Section 1

Introduction

This chapter contains general information and detailed specifications of the P6151-V3.

Chapter 1 includes the following sections:

⚫General Description

⚫Features

⚫Specifications

⚫Dimensions and Outlines

⚫I/O Outlets

⚫Package List

1.1 General Description

The P6151-V3, an industrial 15 inches view area LCD Monitor comes with slim, light and

reliable features to replace traditional bulky CRT for Industrial application. Its unique flat design

is fit for panel mounting, VESA mounting, Wall mounting and Rack mounting. The display

interface offers DP, HDMI and VGA for different input source from PC system or multimedia

system that let you upgrade the display don’t change anything from your system. Besides, for

varied HMI field, you can choose one of resistive touch or glass interface to meet your

application. In addition, this monitor has more comfort, safety, and environmental protection for

humanized & health consideration those would be the benefit that users can get.

This LCD monitor builds in color active matrix thin-film-transistor (TFT) liquid crystal display to

provide superior display performance. A maximum resolution of 1024x768 is ideal for

displaying complex graphics and high-definition images. Other outstanding designs that

enhance this LCD monitor’s performance are Plug & Play compatibility, and OSD (On Screen

Display) controls, especially OSD, it made you ease adjustment on screen image.

P6151-V3 User’s Manual

2 Introduction

1.2 Features

⚫High contrast color 15”XGA TFT LCD display support resolution up to 1024x768

⚫Flat design with NEMA4/IP65-compliant

⚫Suits with resistive touch or glass

⚫High Brightness and Ultra-wide viewing angle with anti-glare features.

⚫Power management system conforms to VESA DPMS standard

⚫Advanced OSD control for picture quality adjustment

⚫Supports VESA ARMs, Desktop Stand Rear, Panel, Wall mount

1.3 Specifications

⚫15” XGA(1024x768) LCD with LED backlight

⚫Resistive Touch or glass

⚫Front bezel design with NEMA4/IP65

⚫Control: OSD (On Screen Display) control pad on the side

⚫Mounting: Support Panel mount, VESA arm mount, Wall mount

⚫Net/Gross Weight

◼P6151-V3: 3.7 kg (8.15 lb)/5.9 kg (13 lb)

⚫Dimension (Main Body Size)

◼P6151-V3: 377.9 mm (14.87") (W) x 309.3 mm(12.17") (H) x 58 mm (2.28") (D)

⚫Operation Temperature

◼0℃to 50℃

⚫Relative Humidity

◼10% to 90% @ 40℃, Non-Condensing

⚫Power input

◼AC Version: Screw-type connecter (12V3A, 36W 100 - 240 VAC-DC power adapter)

◼DC Version: Terminal block (24Vdc)

◼Max power consumption: 14W

NOTE: All specifications and images are subject to change without notice.

P6151-V3 User’s Manual

Introduction 3

1.4 Dimensions and Outlines

The following diagrams show the dimensions and outlines of P6151-V3

P6151-V3 User’s Manual

4 Introduction

1.5 I/O Outlets

Please refer to the following illustration for I/O locations of the P6151-V3.

P6151-V3 User’s Manual

Introduction 5

1.6 Packing List

When you receive the P6151-V3, the bundled package should contain the following items:

⚫P6151-V3 unit x 1

⚫VGA cable x1

⚫USB cable or RS-232 cable x1 (for resisitve touch version only )

⚫Adaptor x1 (for AC version only)

⚫Panel mount kit set x 1 (optional)

⚫HDMI cable x1 (optional)

⚫DP cable x1 (optional)

⚫Wall mount bracket x1 (optional)

If you can not find the package or any items are missing, please contact Axiomtek distributors

immediately.

P6151-V3 User’s Manual

6 Introduction

This page is intentionally left blank.

Tabla de contenidos

Otros manuales de Monitor de AXIOMTEK

AXIOMTEK

AXIOMTEK P6187W Manual de usuario

AXIOMTEK

AXIOMTEK P6105 Manual de usuario

AXIOMTEK

AXIOMTEK P6187W V2 Series Manual de usuario

AXIOMTEK

AXIOMTEK P6125 Manual de usuario

AXIOMTEK

AXIOMTEK DK1211C Manual de usuario

AXIOMTEK

AXIOMTEK P6191-V3 Manual de usuario

AXIOMTEK

AXIOMTEK PANEL6100 Manual de usuario

AXIOMTEK

AXIOMTEK P6217W Manual de usuario

AXIOMTEK

AXIOMTEK P6157W-V2 Manual de usuario

AXIOMTEK

AXIOMTEK P6187W-V3 Manual de usuario

AXIOMTEK

AXIOMTEK P624-C Manual de usuario

AXIOMTEK

AXIOMTEK GOT3187W-881-PCT Manual de usuario

AXIOMTEK

AXIOMTEK P6151 Manual de usuario

AXIOMTEK

AXIOMTEK P6121-V3 Manual de usuario

AXIOMTEK

AXIOMTEK P718O Manual de usuario

AXIOMTEK

AXIOMTEK P6157W-V3 Manual de usuario

AXIOMTEK

AXIOMTEK PANEL 6152-O/P Manual de usuario

AXIOMTEK

AXIOMTEK P6191 Manual de usuario

AXIOMTEK

AXIOMTEK MMT175 Manual de usuario

AXIOMTEK

AXIOMTEK P6157 Manual de usuario

AXIOMTEK

AXIOMTEK P712 Manual de usuario

AXIOMTEK

AXIOMTEK P6103W-V3 Manual de usuario

AXIOMTEK

AXIOMTEK P6171-V3 Manual de usuario

AXIOMTEK

AXIOMTEK SDM510L Manual de usuario

Manuales populares de Monitor de otras marcas

Linear Acoustic

Linear Acoustic LQ-1000 Manual de usuario

AOC

AOC I2579V Manual de usuario

Gateway

Gateway FPD1520 Manual de usuario

Furuno

Furuno Mu 120c Manual de usuario

Asus

Asus VB171D - 17" LCD Monitor Manual de usuario

Dell

Dell S2230MX Instrucciones de uso

Philips

Philips 107C64 Manual de usuario

Dell

Dell S2409WFP Manual de usuario

EverFocus

EverFocus EN-7517E Manual de usuario

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manual de usuario

Dell

Dell Precision 7680 Manual de instrucciones

LG 50PM1M - - 50" Plasma Panel Manual de usuario

Bosch

Bosch DDU 9 Manual de usuario

Acer

Acer A231HL Manual de usuario

Philips

Philips 86BDL4152T Manual de usuario

NEC

NEC AccuSync LCD5V Manual de usuario

Emay

Emay SleepO2 Manual de usuario

IBM

IBM 6360 Instrucciones de instalación