Power Requirements
NEMA 23 CNC Controller:
Input power: 100-120VAC or 200-240VAC, 50/60Hz
Voltage range must be set on main power supplies. They will be pre-configured for 100-120VAC, unless the system was specifically
ordered for 200-240VAC power.
Current draw (approx.): 6A @ 120VAC, 3A @ 240VAC
NEMA 34 CNC Controller:
Input power: 100-120VAC or 200-240VAC, 50/60Hz
Voltage range must be set on main power supplies. They will be pre-configured for 100-120VAC, unless the system was specifically
ordered for 200-240VAC power.
Current draw (approx.): 12A @ 120VAC, 6A @ 240VAC
3 HP Plug and Play Spindle / VFD System:
Input power: 200-240VAC, 50/60Hz (possible to use two legs of a 3-phase 208V supply)
Current draw (approx.): 8A at peak load
Systems utilizing a router as the cutting tool can typically run off of a single 120V 20A AC circuit. Alternatively, two 120V 15A AC circuits can be
used with the router and CNC controller on separate circuits. NEMA 23 systems with a 2.25 HP or smaller router can typically run off of a single
15A circuit without issue.
Systems utilizing a spindle typically require a single 120V 15A circuit for the CNC controller and a single 240V 30A circuit for the spindle.
Alternatively, both the CNC controller and spindle can run off of a single 240V 30A AC circuit. Our spindles come pre-wired with an L6-30P plug,
which mates with an L6-30R receptacle. This can be field retrofitted to a different 240V AC plug if necessary. Consult a qualified electrician for
assistance with any changes to the stock power cable.
