Ava QUAD Manual de instrucciones de instalación
Mounting guide
Quad • Mounting guide | 2
Important warnings
Avoid exposing the camera to shocks, high pressure or temperatures above 60OC.
Avoid placing the camera near fans, ventilation or other noise sources. This will degrade audio performance.
Avoid scratching or leaving ingerprints on the lens cover, this degrades image quality. If possible, keep the protective
plastic on the dome cover during installation.
Do not clean the camera with harsh detergents, gasoline or chemicals such as acetone.
Do not try to repair the unit yourself. Refer all servicing of the camera to Ava or contact a reseller.
Quad • Mounting guide | 3
Safety instructions
Disconnect power from the unit when performing a maintenance task.
Requires PoE+ power connection to operate with IR.
The power supply should bear the UL listed and LPS marks
This product should be supplied by a Power over Ethernet Power Sourcing Equipment (PSE) compliant to IEEE 802.3at Type 2 (PoE+).
The camera should be connected only to PoE networks without routing to the outside plant. The PoE PSE must be properly
grounded.
Please contact AVA’s certiied dealers (or distributor) for power adapters.
For the grounding wire use a green/yellow wire (min. 18AWG), a knurled washer and min. 3.5mm screw.
Quad • Mounting guide | 4
Overview
Outer view
Release
button IR LEDs
Threaded holes for
mounting adapter
Top mounting plate
Through holes for
ceiling-mount or wall
mount bracket
Dome cover
Top view
Package contains:
Quad camera
IR light cover
Alignment sticker
Screws and anchors
T10 security L-key
Quad • Mounting guide | 5
Overview
Inner view
Lens (sensor) module,
3-axis adjustable
Reset button
Cable gland
Status LEDs
Safety tether wire
RJ45
Ethernet port
Quad • Mounting guide | 6
Camera mount - preparation
1 2
A
A
C
B
T10
security bit
B
C
Quad • Mounting guide | 7
Camera mount - preparation
3
Quad • Mounting guide | 8
Ceiling mount
Cable hole
Cable hole
Drill hole
Drill hole
Drill hole
180mm
1 2
Alignment sticker
Quad • Mounting guide | 9
In-ceiling mount
1
If needed, add hanging rods to strengthen the ceiling structure.
Weight of camera: 2.7 Kg
Weight of Recessed kit: 1.1 Kg
Hanging rod
Main keel
Secondary keel
ø15cm
Cut a hole in the center of the tile with a diameter of 15cm.
Quad • Mounting guide | 10
In-ceiling mount
2 3
Remove the assembly from the ceiling and assemble the adapter plate to the bracket rod.
Use nuts, washers and lock washers as shown, tighten the nut towards the adapter plate and
make sure the two nuts close to the bracket rod are loose.
Assemble the bracket stand to the bracket rod, adjust the width so the stands are resting on the
secondary keels. Secure the position by the two lathead screws.
Adapter plate
Bracket rod
Bracket stand
Otros manuales para QUAD
2
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Cámara de seguridad de Ava
Ava
Ava CONDUIT BACK BOX Manual de instrucciones de instalación
Ava
Ava COMPACT DOME Manual de instrucciones de instalación
Ava
Ava QUAD Manual de instrucciones de instalación
Ava
Ava Flex Manual de instrucciones de instalación
Ava
Ava QUAD Manual de instrucciones de instalación
Ava
Ava COMPACT DOME Manual de instrucciones de instalación
Ava
Ava Bullet Series Manual de instrucciones de instalación
